Artificial neural networks modeling in ultra performance liquid chromatography method optimization of mycophenolate mofetil and its degradation products

2014 ◽  
Vol 28 (7) ◽  
pp. 567-574 ◽  
Author(s):  
Jelena Golubović ◽  
Ana Protić ◽  
Mira Zečević ◽  
Biljana Otašević ◽  
Marija Mikić
Author(s):  
SIVA MADHU CHAITANYA ◽  
SRINATH NISSANKARARAO ◽  
SATYA LAKSHMI GANDHAM

Objective: This investigation demonstrates a stability-indicating and reliable “normal phase ultra-performance liquid chromatography” method to simultaneously quantify Ramucirumab and Erlotinib in the pharmaceutical dosage form. Methods: Successful separation was accomplished using Chiralcel-OD-3 column (50 mm x 4.6 mm, 3 μm) with an isocratic type of elution using a mobile phase containing n-hexane+isopropyl alcohol+methanol (89:10:1), respectively with 1.0 ml/min flow rate. The wavelength sensor was attuned at 266 nm to quantify Ramucirumab and Erlotinib. Results: Erlotinib and Ramucirumab peaks were eluted with fine resolution at retention times 1.7807 min and 3.175 min, respectively. In the 10-150 μg/ml and 1-15 μg/ml concentration ranges for Erlotinib and Ramucirumab, the calibration graphs were linear, with regression coefficients of 0.99928 and 0.99976, respectively. The suggested ultra-performance liquid chromatography approach has been shown as sensitive, precise, robust, accurate, specific and stability indicating through the resolution of Erlotinib and Ramucirumab from its degradation-based compounds. Conclusion: The established ultra-performance liquid chromatography technique was effectively extended to the evaluation of Erlotinib and Ramucirumab in the pharmaceutical dosage form and the test results appeared satisfactory.


Author(s):  
Murlidhar V Zope ◽  
Rahul M Patel ◽  
Ashwinikumari Patel ◽  
Samir G Patel

Objective: The objective was to develop and validate the stability indicating reverse-phase high-performance liquid chromatography method for the quantification of potential degradation products of regadenoson (REGA) from its injectable dosage form.Methods: YMC-PAK ODS AQ, 150 mm × 4.6 mm, 3 μm composed with hydrophobic high carbon loading and a relatively hydrophilic surface chemically bonded to porous silica particles column was used with the temperature maintained at 40°C. Mobile phase A composed of 0.1% triethylamine buffer having pH 4.5 while mobile phase B is 100 % acetonitrile was used for gradient elution with 1.5 ml/min as a flow rate. The wavelength used for quantification was 245 nm and 20 μl as an injection volume. The suitability of the method has been checked and validated according to the International Council for Harmonization (ICH) guidelines for different parameters, namely, specificity, linearity, accuracy, precision, limit of quantification (LOQ), Limit of detection (LOQ), and robustness studies.Results: The resolution between REGA and its two-degradation product is >8.0 for all pairs of components. The high correlation coefficient (r2>0.990) values are for drug and all potential degradation products from LOQ to 150% of specification limits for impurities calculated based on the maximum daily dose of REGA. LOQ for the drug as well as each degradation product is <0.02% w/w. The % relative standard deviation (RSD) for precision and intermediate precision is in the range of 0.17–0.89, and % RSD for precision at LOQ is 0.86–2.35. The % RSD for robustness study is maximum 2.59.Conclusion: The developed method can quantify the specified and unknown degradation products from 0.1% in the injectable dosage form which indicates that method is sensitive. Method fulfills the ICH criteria for its different validation parameters and demonstrates that the developed analytical method is highly specific, precise, and robust and would have a great value when applied in quality control and stability studies for REGA injection.


Sign in / Sign up

Export Citation Format

Share Document