ChemInform Abstract: Deposition, Annealing and Characterization of High-Dielectric Constant Metal Oxide Films.

ChemInform ◽  
2010 ◽  
Vol 26 (41) ◽  
pp. no-no
Author(s):  
H. TREICHEL ◽  
A. MITWALSKY ◽  
G. TEMPEL ◽  
G. ZORN ◽  
D. A. BOHLING ◽  
...  
1995 ◽  
Vol 5 (3) ◽  
pp. 163-175 ◽  
Author(s):  
H. Treichel ◽  
A. Mitwalsky ◽  
G. Tempel ◽  
G. Zorn ◽  
D. A. Bohling ◽  
...  

2013 ◽  
Vol 22 ◽  
pp. 564-569
Author(s):  
KANTA RATHEE ◽  
B. P. MALIK

Down scaling of complementary metal oxide semiconductor transistors has put limitations on silicon dioxide to be used as an effective dielectric. It is necessary to replace the SiO 2 with a physically thicker layer of oxides of high dielectric constant. Thus high k dielectrics are used to suppress the existing challenges for CMOS scaling. Many new oxides are being evaluated as gate dielectrics such as Ta2O5 , HfO2 , ZrO2 , La2O3 , HfO2 , TiO2 , Al2O3 , Y2O3 etc but it was soon found that these oxides in many respects have inferior electronic properties to SiO2 . But the the choice alone of suitable metal oxide with high dielectric constant is not sufficient to overcome the scaling challenges. The various deposition techniques and the conditions under which the thin films are deposited plays important role in deciding the structural and electrical properties of the deposited films. This paper discusses in brief the various deposition conditions which are employed to improve the structural and electrical properties of the deposited films.


2012 ◽  
Vol 520 (14) ◽  
pp. 4532-4535 ◽  
Author(s):  
O. Fursenko ◽  
J. Bauer ◽  
G. Lupina ◽  
P. Dudek ◽  
M. Lukosius ◽  
...  

2013 ◽  
Vol 1561 ◽  
Author(s):  
M.A Jithin ◽  
Lakshmi Ganapathi Kolla ◽  
Navakanta Bhat ◽  
S. Mohan ◽  
Yuichiro Morozumi ◽  
...  

ABSTRACTIn this study, synthesis and characterization of rutile-Titanium dioxide (TiO2) thin films using pulsed DC Magnetron Sputtering at room temperature, along with the fabrication and characterization of MIM capacitors have been discussed. XPS and RBS data show that the films are stoichiometric and have compositional uniformity. The influence of electrode materials on electrical characteristics of the fabricated MIM capacitors has been studied. The Al/TiO2/Al based capacitors show low capacitance density (9 fF/μm2) with low dielectric constant (K=25) and high EOT (3.67 nm) due to low dielectric constant TiO2 phase formation on Al/Si substrate. On the other hand, Ru/TiO2/Ru based capacitors show high capacitance density (49 fF/μm2) with high dielectric constant (K=130) and low EOT (0.7nm) values at high frequency (100 KHz) due to high dielectric constant phase (rutile) formation of TiO2, on Ru/Si substrate. Raman spectra confirm that the films deposited on Ru/Si substrate show the rutile phase.


2013 ◽  
Vol 250 (5) ◽  
pp. 957-967 ◽  
Author(s):  
Flora M. Li ◽  
Bernhard C. Bayer ◽  
Stephan Hofmann ◽  
Stuart P. Speakman ◽  
Caterina Ducati ◽  
...  

2019 ◽  
Vol 55 (1) ◽  
pp. 83-86 ◽  
Author(s):  
Aswathy Joseph ◽  
Marylin Mary Xavier ◽  
Jacek Fal ◽  
Gaweł Żyła ◽  
Soorya Sasi ◽  
...  

An iron oxide based-electroactive IoNanofluid with a high dielectric constant, high stability and low viscosity was synthesized from ferrous sulphate heptahydrate via a facile microwave assisted one-step route in 1-butyl-4-methylpyridinium chloride.


Sign in / Sign up

Export Citation Format

Share Document