scholarly journals Determination of aerosol optical thickness through the derivation of an atmospheric correction for short-wavelength Landsat TM and ASTER image data: an application to areas located in the vicinity of airports at UK and Cyprus

2009 ◽  
Vol 1 (1-2) ◽  
pp. 31-40 ◽  
Author(s):  
Diofantos G. Hadjimitsis ◽  
Chris Clayton
2017 ◽  
Author(s):  
Chong Shi ◽  
Teruyuki Nakajima

Abstract. Retrieval of aerosol optical properties and water leaving radiance over ocean is changeling since the latter mostly accounts for ~10% of satellite observed signal and can be easily contaminated by the atmospheric scattering. Such an effort would be more difficulty in turbid coastal waters due to the existence of optically complex oceanic substances or high aerosol loading. In an effort to solve such problems, we present an optimization approach for the simultaneous determination of aerosol optical thickness (AOT) and normalized water leaving radiance (nLw) from multi-spectral measurements. In this algorithm, a coupled atmosphere-ocean radiative transfer model combined with a comprehensive bio-optical oceanic module is used to jointly simulate the satellite observed reflectance at the top of atmosphere and water leaving radiance just above the ocean surface. Then a full-physical nonlinear optimization method is adopted to retrieve AOT and nLw in one step. The algorithm is validated using Aerosol Robotic Network Ocean Color (AERONET-OC) products selected from eight OC sites distributed over different waters, consisting of observation cases covered both in and out of sun glint from the Moderate Resolution Imaging Spectroradiometer (MODIS) instrument. Results show a good consistency between retrieved and in situ measurements in each site. It is demonstrated that more accurate AOT are determined based on the simultaneous retrieval method, particularly in shorter wavelengths and sun glint conditions, where the averaged percentage difference (APD) of retrieved AOT generally reduce by approximate 10 % in visible bands compared with those derived from the standard atmospheric correction (AC) scheme. It is caused that all the spectral measurements can be used jointly to increase the information content in the inversion of AOT and the wind speed is also simultaneously retrieved to compensate the specular reflectance error estimated from the rough ocean surface model. For the retrieval of nLw, over atmospheric correction can be avoided to have a significant improvement for the inversion of nLw at 412 nm. Furthermore, generally better estimates of band ratios of nLw(443)/nLw(554) and nLw(488)/nLw(554), which are employed in the inversion of chlorophyll a concentration (Chl), are obtained using simultaneous retrieval approach with less root mean square errors and relative differences than those derived from the standard AC approach in comparison to the AERONET-OC products, as a result that the APD value of retrieved Chl decreases by about 5 %. On the other hand, the standard AC scheme yields a more accurate retrieval of nLw at 488 nm, prompting a further optimization of oceanic bio-optical module of current model.


2010 ◽  
Vol 3 (3) ◽  
pp. 2107-2164 ◽  
Author(s):  
W. von Hoyningen-Huene ◽  
J. Yoon ◽  
M. Vountas ◽  
L. G. Istomina ◽  
G. Rohen ◽  
...  

Abstract. For the determination of aerosol optical thickness (AOT) Bremen AErosol Retrieval (BAER) has been developed. Method and main influences on the aerosol retrieval are described together with validation and results. The retrieval separates the spectral aerosol reflectance from surface and Rayleigh path reflectance for the shortwave range of the measured spectrum of top-of-atmosphere reflectance less than 0.670 μm. The advantage of MERIS (Medium Resolution Imaging Spectrometer on ENVISAT) and SeaWiFS (Sea viewing Wide Fiels Sensor on OrbView-2) observations are the existence of several spectral channels in the blue and visible range enabling the spectral determination of AOT in 7 (or 6) channels (0.412–0.670 μm) and additionally channels in the NIR, which can be used to characterize the surface properties. A dynamical spectral surface reflectance model for different surface types is used to obtain the spectral surface reflectance for this separation. Normalized differential vegetation index (NDVI), taken from the satellite observations, is the model input. Further surface BRDF is considered by the Raman-Pinty-Verstraete (RPV) model. Spectral AOT is obtained from aerosol reflectance using look-up-tables, obtained from radiative transfer calculations with given aerosol phase functions and single scattering albedos either from aerosol models, given by OPAC or from experimental campaigns. Validations of the obtained AOT retrieval results with AERONET data over Europe gave a preference for experimental phase functions derived from almucantar measurements. Finally long-term observations of SeaWiFS have been investigated for trends in AOT.


2009 ◽  
Vol 2 (2) ◽  
pp. 1027-1055
Author(s):  
A. A. Kokhanovsky ◽  
A. S. Prikhach ◽  
I. L. Katsev ◽  
E. P. Zege

Abstract. A new technique to retrieve the particulate matter vertical columns from spaceborne observations is described. The method is based on the measurements of the spectral aerosol optical thickness (AOT). The spectral slope of the derived aerosol optical thickness is used to infer the size of particles, which is needed (along with the absolute value of AOT) to determine corresponding vertical columns. The technique is applied to the case of a cloudless atmosphere over Germany and results are compared with ground-based observations.


Sign in / Sign up

Export Citation Format

Share Document