Food-industry-effluent-grown microalgal bacterial flocs as a bioresource for high-value phycochemicals and biogas

2016 ◽  
Vol 18 ◽  
pp. 25-32 ◽  
Author(s):  
Sofie Van Den Hende ◽  
Jolien Beyls ◽  
Pieter-Jan De Buyck ◽  
Diederik P.L. Rousseau
Chemosphere ◽  
2015 ◽  
Vol 130 ◽  
pp. 73-81 ◽  
Author(s):  
Irene Carra ◽  
Carla Sirtori ◽  
Laura Ponce-Robles ◽  
José Antonio Sánchez Pérez ◽  
Sixto Malato ◽  
...  

Científica ◽  
2016 ◽  
Vol 44 (3) ◽  
pp. 310
Author(s):  
Crislaine Trevisan da Rocha Ribeiro Ferrari ◽  
Aziza Kamal Genena ◽  
Daiane Cristina Lenhard

2020 ◽  
Vol 277 ◽  
pp. 124117
Author(s):  
Joanna Boguniewicz-Zablocka ◽  
Iwona Klosok-Bazan ◽  
Arianna Callegari ◽  
Andrea G. Capodaglio

2019 ◽  
pp. 297-316
Author(s):  
Mihir Kumar Purkait ◽  
Piyal Mondal ◽  
Chang-Tang Chang

2007 ◽  
Vol 56 (2) ◽  
pp. 71-77 ◽  
Author(s):  
J. Lobos ◽  
C. Wisniewski ◽  
M. Heran ◽  
A. Grasmick

This work focuses on the performances of two immersed membrane bioreactors used for the treatment of easily biodegradable organic matter present in food industry effluents, for the purpose of water reuse. Two reactor functioning modes (continuous and sequencing) were compared in terms of organic carbon removal and of membrane permeability. For each working mode, pollutant removal was very high, treated water quality presented a low COD concentration (<125 mg.L−1), no solids in suspension and low turbidity (<0.5 NTU). The quality of the treated water (including germ removal) enabled its reuse on site. Moreover, by developing high biomass concentrations in the reactor, excess sludge production remained very low (<0.1 gVSS.gCOD−1). The performances appeared slightly better for the continuous system (lower COD concentration in the effluent, <50 mg.L−1, and lower sludge production). In terms of filtration, a distinct difference was observed between continuous and sequencing systems; transmembrane pressure showed a small and constant evolution rate in continuous membrane bioreactor (CMBR) although it appeared more difficult to control in sequencing membrane bioreactor (SMBR) probably due to punctually higher permeate flow rate and modified suspension properties. The rapid evolution of membrane permeability observed in SMBR was such that more frequent chemical cleaning of the membrane system was required.


2020 ◽  
Vol 8 (6) ◽  
pp. 104469
Author(s):  
Fernando Morgan-Sagastume ◽  
Simon Bengtsson ◽  
Giulia De Grazia ◽  
Tomas Alexandersson ◽  
Luca Quadri ◽  
...  

Author(s):  
Jean Fincher

An important trend in the food industry today is reduction in the amount of fat in manufactured foods. Often fat reduction is accomplished by replacing part of the natural fat with carbohydrates which serve to bind water and increase viscosity. It is in understanding the roles of these two major components of food, fats and carbohydrates, that freeze-fracture is so important. It is well known that conventional fixation procedures are inadequate for many food products, in particular, foods with carbohydrates as a predominant structural feature. For some food science applications the advantages of freeze-fracture preparation procedures include not only the avoidance of chemical fixatives, but also the opportunity to control the temperature of the sample just prior to rapid freezing.In conventional foods freeze-fracture has been used most successfully in analysis of milk and milk products. Milk gels depend on interactions between lipid droplets and proteins. Whipped emulsions, either whipped cream or ice cream, involve complex interactions between lipid, protein, air cell surfaces, and added emulsifiers.


Sign in / Sign up

Export Citation Format

Share Document