scholarly journals Characterization and application of cellulose acetate synthesized from sugarcane bagasse

2017 ◽  
Vol 167 ◽  
pp. 280-289 ◽  
Author(s):  
R.G. Candido ◽  
G.G. Godoy ◽  
Adilson R. Gonçalves
2010 ◽  
Vol 66 (3) ◽  
pp. 377-389 ◽  
Author(s):  
Moacir Fernandes Ferreira Júnior ◽  
Elaine Angélica Ribeiro Mundim ◽  
Guimes Rodrigues Filho ◽  
Carla da Silva Meireles ◽  
Daniel Alves Cerqueira ◽  
...  

2015 ◽  
Vol 42 (7) ◽  
pp. 1066-1072 ◽  
Author(s):  
Guimes Rodrigues Filho ◽  
Flávia Almeida ◽  
Sabrina D. Ribeiro ◽  
Thiago F. Tormin ◽  
Rodrigo A. A. Muñoz ◽  
...  

2011 ◽  
Vol 33 (3) ◽  
pp. 566-571 ◽  
Author(s):  
Guimes Rodrigues Filho ◽  
Sabrina Dias Ribeiro ◽  
Carla da Silva Meireles ◽  
Leandro Gustavo da Silva ◽  
Reinaldo Ruggiero ◽  
...  

Polymers ◽  
2020 ◽  
Vol 12 (11) ◽  
pp. 2501
Author(s):  
Ali Aldalbahi ◽  
Mehrez El-Naggar ◽  
Tawfik Khattab ◽  
Meram Abdelrahman ◽  
Mostafizur Rahaman ◽  
...  

Novel ecofriendly adsorbents, cellulose acetate/graphene oxide (CA-GO) nanocomposite, were prepared from sugarcane bagasse agro-waste for removing Ni2+ ions from wastewater. Graphene oxide (GO) was prepared by the oxidation of sugarcane bagasse using ferrocene under air atmosphere. Cellulose acetate (CA) was also prepared from sugarcane bagasse by extraction of cellulose through a successive treatments with sulfuric acid (10% v/v), sodium hydroxide (5% w/v), ethylenediaminetetraacetic acid, and hydrogen peroxide, and finally, followed by acetylation. CA-GO was prepared via mixing of GO and CA in the presence of calcium carbonate and different concentrations of GO, including 5, 10, 15, 20, 25, and 30 wt% relative to the weight of CA. The CA-GO nanocomposite showed porous microstructures with high surface area, which enhance their ability towars the adsorption of Ni2+ ions from wastewater. The morphological properties of the prepared adsorbents were explored by scanning electron microscope (SEM) and Fourier-transform infrared spectroscopy (FT-IR). The efficiency of the CA-GO towards the adsorption of Ni2+ ions from wastewater was explored against as time, temperature, and total content of Ni2+ ions. The adsorption measurements of Ni2+ ions were investigated within the concentration range of 10–40 mg/L, time range between 15 and 90 min, and temperature range between 25 °C and 55 °C. The results displayed a considerable improvement in the adsorption process of Ni2+ ions by CA-GO-2 with a removal efficiency of 96.77%. The isotherms were monitored to best fit the Langmuir model. Finally, the adsorption performance of the prepared CA-GO nanocomposite films demonstrated promising properties as green, sustainable and cheap adsorbents for water pollutants.


2008 ◽  
Vol 48 (8) ◽  
pp. 1443-1448 ◽  
Author(s):  
Carla da Silva Meireles ◽  
Guimes Rodrigues Filho ◽  
Rosana Maria Nascimento de Assunção ◽  
Daniel Alves Cerqueira ◽  
Mara Zeni ◽  
...  

2007 ◽  
Vol 104 (2) ◽  
pp. 909-914 ◽  
Author(s):  
Carla da Silva Meireles ◽  
Guimes R. Filho ◽  
Rosana M. N. de Assunção ◽  
Mara Zeni ◽  
Kátia Mello

2019 ◽  
Vol 9 (16) ◽  
pp. 3347 ◽  
Author(s):  
Nu ◽  
Hung ◽  
Hoang ◽  
Van der Bruggen

Asymmetric cellulose acetate membranes have been successfully fabricated by phase inversion, using sugarcane bagasse (SB) as the starting material. SB is a raw material with high potential to produce cellulose derivatives due to its structure and morphology. Cellulose was extracted from SB by pretreatment with solutions of 5 wt% NaOH, 0.5 wt% EDTA; then bleached with 2 wt% H2O2. Cellulose acetate (CA) was prepared by the reaction between extracted cellulose with acetic anhydride, and H2SO4 as a catalyst. The obtained CA exhibited a high degree of substitution (2.81), determined with 1H-NMR spectroscopy and titration. The functional groups and thermal analysis of the extracted cellulose and the synthesized CA have been investigated by Fourier transform infrared spectroscopy (FT-IR), differential scanning calorimetry (DSC), and thermogravimetric analysis (TGA). The change in the crystallinity of the extracted cellulose and CA was evaluated by X-ray diffraction (XRD) spectroscopy. Asymmetric membranes were fabricated using dimethyl sulfoxide (DMSO) as the solvent, with a casting thickness of 250 µm. The obtained membranes were studied by scanning electron microscopy (SEM), DSC and atomic force microscopy (AFM). The hydrophilicity of the membranes was evaluated, as demonstrated by the measurement of water contact angle (WCA) and water content. Furthermore, the antifouling properties of membranes were also investigated.


2020 ◽  
Vol 8 (24) ◽  
pp. 9002-9008 ◽  
Author(s):  
Shiori Suzuki ◽  
Risa Yada ◽  
Yosuke Hamano ◽  
Naoki Wada ◽  
Kenji Takahashi

Sign in / Sign up

Export Citation Format

Share Document