Effects of consecutive chemical cleaning on membrane performance and surface properties of microfiltration

Desalination ◽  
2012 ◽  
Vol 286 ◽  
pp. 324-331 ◽  
Author(s):  
Ji Hyang Kweon ◽  
Jae Hyun Jung ◽  
Seung Ryul Lee ◽  
Hyung Woo Hur ◽  
Yongcheol Shin ◽  
...  
Membranes ◽  
2020 ◽  
Vol 11 (1) ◽  
pp. 25
Author(s):  
Javed Alam ◽  
Arun Kumar Shukla ◽  
Mohammad Azam Ansari ◽  
Fekri Abdulraqeb Ahmed Ali ◽  
Mansour Alhoshan

We fabricated a nanofiltration membrane consisting of a polyaniline (PANI) film on a polyphenylsulfone (PPSU) substrate membrane. The PANI film acted as a potent separation enhancer and antimicrobial coating. The membrane was analyzed via scanning electron microscopy and atomic force microscopy to examine its morphology, topography, contact angle, and zeta potential. We aimed to investigate the impact of the PANI film on the surface properties of the membrane. Membrane performance was then evaluated in terms of water permeation and rejection of methylene blue (MB), an organic dye. Coating the PPSU membrane with a PANI film imparted significant advantages, including finely tuned nanometer-scale membrane pores and tailored surface properties, including increased hydrophilicity and zeta potential. The PANI film also significantly enhanced separation of the MB dye. The PANI-coated membrane rejected over 90% of MB with little compromise in membrane permeability. The PANI film also enhanced the antimicrobial activity of the membrane. The bacteriostasis (BR) values of PANI-coated PPSU membranes after six and sixteen hours of incubation with Escherichia coli were 63.5% and 95.2%, respectively. The BR values of PANI-coated PPSU membranes after six and sixteen hours of incubation with Staphylococcus aureus were 70.6% and 88.0%, respectively.


2018 ◽  
Vol 2018 (18) ◽  
pp. 197-209
Author(s):  
Gayathri Ram Mohan ◽  
Robert Harris ◽  
JC Lan ◽  
Srinivas Jalla ◽  
Jim Lozier

Water SA ◽  
2019 ◽  
Vol 45 (3 July) ◽  
Author(s):  
Marjana Simonič

Membrane surface properties and their effect on the efficiency of ultrafiltration (UF) of real waste oily emulsions was studied. Experiments were performed in cross-flow operation at total recycle condition in a lab-scale system. The ceramic UF membrane in the tubular type module was employed. During the experiments permeate flux was measured. The most important influential factors, such as temperature, TMP, and pH, were considered during the experiments. Zeta potential was measured in order to explain the phenomena on the membrane surface. The isoelectric point of the fouled membrane was shifted to the alkaline range. COD removal efficiency reached 89%. Gas chromatography measurements were performed in order to determine the composition of waste emulsions. SEM micrographs showed the formation of calcite on the membrane, which contributed to membrane fouling. Chemical cleaning was examined using alkaline and acid solutions, and a cleaning strategy was determined.


2018 ◽  
Vol 77 (12) ◽  
pp. 2858-2866 ◽  
Author(s):  
J. Arevalo ◽  
R. Sandin ◽  
M. D. Kennedy ◽  
S. G. Salinas Rodriguez ◽  
F. Rogalla ◽  
...  

Abstract The main source of potable water in high water-stress areas is commonly produced in brackish and seawater desalination plants. Owing to the presence of high concentration of suspended solids, organic matter and colloidal particles in raw water, pretreatment processes are needed for a stable operation of desalination plants. A submerged membrane ultrafiltration pilot plant has been operated as pretreatment of complex brackish surface water to study the filtration performance. The results show the membrane performance, chemical reagent requirements, water quality and cleaning procedures efficiency of an ultrafiltration pilot plant used as pretreatment for a reverse osmosis system. Alternative chemical cleaning procedures have been satisfactorily implemented, which maximize permeability recovery and allow a stable operation.


Polymers ◽  
2021 ◽  
Vol 13 (4) ◽  
pp. 583
Author(s):  
Yu-Hsuan Chiao ◽  
Arijit Sengupta ◽  
Micah Belle Marie Yap Ang ◽  
Shu-Ting Chen ◽  
Teow Yeit Haan ◽  
...  

Forward osmosis (FO) is an important desalination method to produce potable water. It was also used to treat different wastewater streams, including industrial as well as municipal wastewater. Though FO is environmentally benign, energy intensive, and highly efficient; it still suffers from four types of fouling namely: organic fouling, inorganic scaling, biofouling and colloidal fouling or a combination of these types of fouling. Membrane fouling may require simple shear force and physical cleaning for sufficient recovery of membrane performance. Severe fouling may need chemical cleaning, especially when a slimy biofilm or severe microbial colony is formed. Modification of FO membrane through introducing zwitterionic moieties on the membrane surface has been proven to enhance antifouling property. In addition, it could also significantly improve the separation efficiency and longevity of the membrane. Zwitterion moieties can also incorporate in draw solution as electrolytes in FO process. It could be in a form of a monomer or a polymer. Hence, this review comprehensively discussed several methods of inclusion of zwitterionic moieties in FO membrane. These methods include atom transfer radical polymerization (ATRP); second interfacial polymerization (SIP); coating and in situ formation. Furthermore, an attempt was made to understand the mechanism of improvement in FO performance by zwitterionic moieties. Finally, the future prospective of the application of zwitterions in FO has been discussed.


2016 ◽  
Vol 57 (55) ◽  
pp. 26621-26628 ◽  
Author(s):  
Kaiwit Ruengruehan ◽  
Pattarasiri Fagkaew ◽  
Gwangtaek Ahn ◽  
Seoktae Kang ◽  
Seok-Oh Ko

Sign in / Sign up

Export Citation Format

Share Document