Flow rate influence on direct contact membrane distillation experiments: Different empirical correlations for Nusselt number

2008 ◽  
Vol 321 (2) ◽  
pp. 356-363 ◽  
Author(s):  
M.A. Izquierdo-Gil ◽  
C. Fernández-Pineda ◽  
M.G. Lorenz
2018 ◽  
Vol 19 (2) ◽  
pp. 492-501 ◽  
Author(s):  
M. Ebadi ◽  
M. R. Mozdianfard ◽  
M. Aliabadi

Abstract Optimized condition for desalination of the reverse osmosis (RO) rejected stream from Esfahan Oil Refining Company (EORC) using direct contact membrane distillation (DCMD) with polytetrafluoroethylene (PTFE) membrane was investigated here, having designed a set of 34 experiments using response surface methodology (RSM) and full factorial design (FFD) modelling, carried out in a laboratory scale set-up built for this purpose. Statistical criteria for validation, significance, accuracy and adequacy confirmed the suitability of the quadratic polynomial model employed. Response plots and regression equations suggested that the permeate flux response improved with increased feed temperature, reduced permeate temperature and enhanced feed flow rate. Optimizing DCMD process showed that maximum permeate flux of 60.76 L/m2·h could be achieved at the following optimum operational conditions: feed temperature and flow rate of 70 °C and 2 L/min, respectively, as well as the permeate temperature of 15 °C. At this point, the mean annual energy required for 90% water recovery (36 m3/h off the RO brackish rejected stream) at EORC refinery was found to be 96 GJ, which could be supplied using solar or conventional energy systems at Isfahan, facing a very critical water shortage at present.


Author(s):  
Hafiz M. Ahmad ◽  
Atia E. Khalifa ◽  
Mohamed A. Antar

Membrane distillation (MD) is a separation technique used for water desalination, which operates at low feed temperatures and pressures. Direct contact membrane distillation (DCMD) is one of the common MD configurations where both the hot saline feed stream and the cold permeate stream are in direct contact with the two membrane surfaces. An experimental study was performed to investigate the effect of operating conditions such as feed temperature, feed flow rate, permeate temperature, and permeate flow rate on the system output flux. To check the effect of membrane degradation, the MD system was run continuously for 48 hours with raw seawater as feed and the reduction in system flux with time was observed. Results showed that increasing the feed temperature, decreasing the permeate temperature, increasing the feed and permeate flow rate yield an increase in flux. The effects of feed temperature and feed flow rate are the most significant parameters. After 48 hours of system continuous operation flux was reduced by 42.4 % but the quality of permeate (as measured by its TDS) is still very high with salt rejection factor close to 100 %. For the DCMD system under consideration, the GOR values remain between 0.8 and 1.2, for the tested range of operating temperatures.


Desalination ◽  
2021 ◽  
Vol 505 ◽  
pp. 114986
Author(s):  
Jiahui Zhang ◽  
Nan Li ◽  
Dong Wang ◽  
Jinmei Li ◽  
Yue Chen ◽  
...  

Molecules ◽  
2021 ◽  
Vol 26 (6) ◽  
pp. 1808
Author(s):  
Rosa Tundis ◽  
Carmela Conidi ◽  
Monica R. Loizzo ◽  
Vincenzo Sicari ◽  
Rosa Romeo ◽  
...  

Olive mill wastewater (OMW), generated as a by-product of olive oil production, is considered one of the most polluting effluents produced by the agro-food industry, due to its high concentration of organic matter and nutrients. However, OMW is rich in several polyphenols, representing compounds with remarkable biological properties. This study aimed to analyze the chemical profile as well as the antioxidant and anti-obesity properties of concentrated fractions obtained from microfiltered OMW treated by direct contact membrane distillation (DCMD). Ultra-high performance liquid chromatography (UHPLC) analyses were applied to quantify some phenols selected as phytochemical markers. Moreover, α-Amylase, α-glucosidase, and lipase inhibitory activity were investigated together with the antioxidant activity by means of assays, namely β-carotene bleaching, 2,2′-azino-bis(3-ethylbenzothiazoline-6-sulphonic) acid (ABTS) diammonium salts, 2,2-diphenyl-1-picrylhydrazyl (DPPH) assay, and Ferric Reducing Activity Power (FRAP) tests. MD retentate—which has content of about five times greater of hydroxytyrosol and verbascoside and about 7 times greater of oleuropein than the feed—was more active as an antioxidant in all applied assays. Of interest is the result obtained in the DPPH test (an inhibitory concentration 50% (IC50) of 9.8 μg/mL in comparison to the feed (IC50 of 97.2 μg/mL)) and in the ABTS assay (an IC50 of 0.4 μg/mL in comparison to the feed (IC50 of 1.2 μg/mL)).


Desalination ◽  
2021 ◽  
pp. 115134
Author(s):  
Miaomiao Tian ◽  
Hellen De Coninck ◽  
Junyong Zhu ◽  
Yatao Zhang ◽  
Shushan Yuan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document