Tensile flow and work hardening behavior of hot cross-rolled AA7010 aluminum alloy sheets

2013 ◽  
Vol 577 ◽  
pp. 87-100 ◽  
Author(s):  
Chandan Mondal ◽  
A.K. Singh ◽  
A.K. Mukhopadhyay ◽  
K. Chattopadhyay
Keyword(s):  
Aluminum Alloy ◽  
Work Hardening ◽  
Work Hardening Behavior ◽  
Hardening Behavior

Stir zone anisotropic work hardening behavior in friction stir processed EN8 medium carbon steel

2020 ◽  
pp. 140582
Author(s):  
Md Anwar Ali Anshari ◽  
Murshid Imam ◽  
Mohd Zaheer Khan Yusufzai ◽  
Viswanath Chinthapenta ◽  
Rajnish Mishra
Keyword(s):  
Carbon Steel ◽  
Work Hardening ◽  
Medium Carbon Steel ◽  
Stir Zone ◽  
Medium Carbon ◽  
Work Hardening Behavior ◽  
Friction Stir ◽  
Hardening Behavior

scholarly journals Machining-Induced Work Hardening Behavior of Inconel 718 Considering Edge Geometries

Materials ◽  
2022 ◽  
Vol 15 (2) ◽  
pp. 397
Author(s):  
Bin Zhou ◽  
Weiwei Zhang ◽  
Zhongmei Gao ◽  
Guoqiang Luo
Keyword(s):  
Grain Size ◽  
Work Hardening ◽  
Inconel 718 ◽  
Orthogonal Cutting ◽  
Chip Thickness ◽  
Machined Surface ◽  
Work Hardening Behavior ◽  
Hardening Behavior ◽  
Significant Difference ◽  
Optimization Of Cutting Parameters

As a representative type of superalloy, Inconel 718 is widely employed in aerospace, marine and nuclear industries. The significant work hardening behavior of Inconel 718 can improve the service performance of components; nevertheless, it cause extreme difficulty in machining. This paper aims to investigate the influence of chamfered edge parameters on work hardening in orthogonal cutting of Inconel 718 based on a novel hybrid method, which integrates Coupled Eulerian-Lagrangian (CEL) method and grain-size-based functions considering the influence of grain size on microhardness. Orthogonal cutting experiments and nanoindentation tests are conducted to validate the effectiveness of the proposed method. The predicted results are highly consistent with the experimental results. The depth of work hardening layer increases with increasing chamfer angle and chamfer width, also with increasing feed rate (the uncut chip thickness). However, the maximum microhardness on the machined surface does not exhibit a significant difference. The proposed method can provide theoretical guidance for the optimization of cutting parameters and improvement of the work hardening.

Influence of Zn addition on the microstructure, tensile properties and work-hardening behavior of Mg-1Gd alloy

2020 ◽  
Vol 772 ◽  
pp. 138779 ◽  
Author(s):  
Jun Zhao ◽  
Bin Jiang ◽  
Yuan Yuan ◽  
Aitao Tang ◽  
Haoran Sheng ◽  
...  
Keyword(s):  
Tensile Properties ◽  
Work Hardening ◽  
Work Hardening Behavior ◽  
Hardening Behavior ◽  
Zn Addition
Sign in / Sign up

Export Citation Format

Share Document