Characteristics of iron droplet ejection caused by gas bubble bursting under reduced pressure

2010 ◽  
Vol 17 (1) ◽  
pp. 7-11 ◽  
Author(s):  
Ping Lin ◽  
Fu-li Wang ◽  
Liu Liu ◽  
Qing He
1997 ◽  
Vol 37 (6) ◽  
pp. 557-561 ◽  
Author(s):  
Teruhisa Tatsuoka ◽  
Chizuna Kamata ◽  
Kimihisa Ito
Keyword(s):  

1998 ◽  
Vol 375 ◽  
pp. 363-381 ◽  
Author(s):  
HERMAN E. SNYDER ◽  
ROLF D. REITZ

X-ray lithography and micro-machining have been used to study gas-assisted liquid atomization in which a liquid film was impinged by a large number of sonic micro-gas jets. Three distinct breakup regimes were demonstrated. Two of these regimes share characteristics with previously observed atomization processes: a bubble bursting at a free surface (Newitt et al. 1954; Boulton-Stone & Blake 1993) and liquid sheet disintegration in a high gas/liquid relative velocity environment (Dombrowski & Johns 1963). The present work shows that suitable control of the gas/liquid interface creates a third regime, a new primary atomization mechanism, in which single liquid droplets are ejected directly from the liquid film without experiencing an intermediate ligament formation stage. The interaction produces a stretched liquid sheet directly above each gas orifice. This effectively pre-films the liquid prior to its breakup. Following this, surface tension contracts the stretched film of liquid into a sphere which subsequently detaches from the liquid sheet and is entrained by the gas jet that momentarily pierces the film. After droplet ejection, the stretched liquid film collapses, covering the gas orifice, and the process repeats. This new mechanism is capable of the efficient creation of finely atomized sprays at low droplet ejection velocities (e.g. 20 μm Sauter mean diameter methanol sprays using air at 239 kPa, with air-to-liquid mass ratios below 1.0, and droplet velocities lower than 2.0 m s−1). Independent control of the gas and the liquid flows allows the droplet creation process to be effectively de-coupled from the initial droplet momentum, a characteristic not observed with standard gas-assisted atomization mechanisms.


1982 ◽  
Vol 43 (C5) ◽  
pp. C5-93-C5-100 ◽  
Author(s):  
M. Onuki ◽  
A. Nishikawa

2020 ◽  
Vol 4 (1) ◽  
Author(s):  
Catherine M. Febria ◽  
Maggie Bayfield ◽  
Kathryn E. Collins ◽  
Hayley S. Devlin ◽  
Brandon C. Goeller ◽  
...  

In Aotearoa New Zealand, agricultural land-use intensification and decline in freshwater ecosystem integrity pose complex challenges for science and society. Despite riparian management programmes across the country, there is frustration over a lack in widespread uptake, upfront financial costs, possible loss in income, obstructive legislation and delays in ecological recovery. Thus, social, economic and institutional barriers exist when implementing and assessing agricultural freshwater restoration. Partnerships are essential to overcome such barriers by identifying and promoting co-benefits that result in amplifying individual efforts among stakeholder groups into coordinated, large-scale change. Here, we describe how initial progress by a sole farming family at the Silverstream in the Canterbury region, South Island, New Zealand, was used as a catalyst for change by the Canterbury Waterway Rehabilitation Experiment, a university-led restoration research project. Partners included farmers, researchers, government, industry, treaty partners (Indigenous rights-holders) and practitioners. Local capacity and capability was strengthened with practitioner groups, schools and the wider community. With partnerships in place, co-benefits included lowered costs involved with large-scale actions (e.g., earth moving), reduced pressure on individual farmers to undertake large-scale change (e.g., increased participation and engagement), while also legitimising the social contracts for farmers, scientists, government and industry to engage in farming and freshwater management. We describe contributions and benefits generated from the project and describe iterative actions that together built trust, leveraged and aligned opportunities. These actions were scaled from a single farm to multiple catchments nationally.


Author(s):  
N. A. Bulychev

In this paper, the plasma discharge in a high-pressure fluid stream in order to produce gaseous hydrogen was studied. Methods and equipment have been developed for the excitation of a plasma discharge in a stream of liquid medium. The fluid flow under excessive pressure is directed to a hydrodynamic emitter located at the reactor inlet where a supersonic two-phase vapor-liquid flow under reduced pressure is formed in the liquid due to the pressure drop and decrease in the flow enthalpy. Electrodes are located in the reactor where an electric field is created using an external power source (the strength of the field exceeds the breakdown threshold of this two-phase medium) leading to theinitiation of a low-temperature glow quasi-stationary plasma discharge.A theoretical estimation of the parameters of this type of discharge has been carried out. It is shown that the lowtemperature plasma initiated under the flow conditions of a liquid-phase medium in the discharge gap between the electrodes can effectively decompose the hydrogen-containing molecules of organic compounds in a liquid with the formation of gaseous products where the content of hydrogen is more than 90%. In the process simulation, theoretical calculations of the voltage and discharge current were also made which are in good agreement with the experimental data. The reaction unit used in the experiments was of a volume of 50 ml and reaction capacity appeared to be about 1.5 liters of hydrogen per minute when using a mixture of oxygen-containing organic compounds as a raw material. During their decomposition in plasma, solid-phase products are also formed in insignificant amounts: carbon nanoparticles and oxide nanoparticles of discharge electrode materials.


Sign in / Sign up

Export Citation Format

Share Document