scholarly journals The impact of dislocations on AlGaN/GaN Schottky diodes and on gate failure of high electron mobility transistors

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Sven Besendörfer ◽  
Elke Meissner ◽  
Farid Medjdoub ◽  
Joff Derluyn ◽  
Jochen Friedrich ◽  
...  

Abstract GaN epitaxially grown on Si is a material for power electronics that intrinsically shows a high density of dislocations. We show by Conductive Atomic Force Microscopy (C-AFM) and Defect Selective Etching that even for materials with similar total dislocation densities substantially different subsets of dislocations with screw component act as current leakage paths within the AlGaN barrier under forward bias. Potential reasons are discussed and it will be directly shown by an innovative experiment that current voltage forward characteristics of AlGaN/GaN Schottky diodes shift to lower absolute voltages when such dislocations are present within the device. A local lowering of the Schottky barrier height around conductive dislocations is identified and impurity segregation is assumed as responsible root cause. While dislocation related leakage current under low reverse bias could not be resolved, breakdown of AlGaN/GaN Schottky diodes under high reverse bias correlates well with observed conductive dislocations as measured by C-AFM. If such dislocations are located near the drain side of the gate edge, failure of the gate in terms of breakdown or formation of percolation paths is observed for AlGaN/GaN high electron mobility transistors.

2018 ◽  
Vol 58 (2) ◽  
Author(s):  
Vytautas Jakštas ◽  
Justinas Jorudas ◽  
Vytautas Janonis ◽  
Linas Minkevičius ◽  
Irmantas Kašalynas ◽  
...  

This paper reports on the AlGaN/GaN Schottky diodes (SDs) and high-electron-mobility transistors (HEMTs) grown on a semi-insulating SiC substrate. The electronic devices demonstrate an improved performance in comparison with the ones processed on a sapphire substrate. Both the SDs and HEMTs show much smaller leakage current density and a higher ION/IOFF ratio, reaching values down to 3.0±1.2 mA/cm2 and up to 70 dB under the reverse electric field of 340 kV/cm, respectively. The higher thermal conductivity of the SiC substrate leads to the increase of steady current and transconductance, and better thermal management of the HEMT devices. In addition, a successful detection of terahertz (THz) waves with the AlGaN/GaN HEMT is demonstrated at room temperature. These results open further routes for the optimization of THz designs which may result in development of novel plasmonic THz devices.


2019 ◽  
Vol 33 (18) ◽  
pp. 1950190
Author(s):  
Hai Li Wang ◽  
Peng Yang ◽  
Kun Xu ◽  
Xiang Yang Duan ◽  
Shu Xiang Sun

In this paper, we investigated the impact of thickness and mole fraction AlInGaN back barrier on the DC performance of AlGaN/GaN high electron mobility transistors (HEMTs) by numerical simulation. The simulations are performed using the hydrodynamic transport model (HD). The simulation results indicated that an inserted AlInGaN back barrier with increasing thickness and mole fraction could effectively confine the electron in the channel, resulting in a significant improvement of the channel current and transconductance. Additionally, the variation of conduction band offset and the increase of total number electron in the channel led to the threshold voltage moving toward a more negative value.


Coatings ◽  
2019 ◽  
Vol 9 (5) ◽  
pp. 318 ◽  
Author(s):  
He Guan ◽  
Shaoxi Wang ◽  
Lingli Chen ◽  
Bo Gao ◽  
Ying Wang ◽  
...  

Because of the high electron mobility and electron velocity in the channel, InAs/AlSb high electron mobility transistors (HEMTs) have excellent physical properties, compared with the other traditional III-V semiconductor components, such as ultra-high cut-off frequency, very low power consumption and good noise performance. In this paper, both the structure and working principle of InAs/AlSb HEMTs were studied, the energy band distribution of the InAs/AlSb heterojunction epitaxy was analyzed, and the generation mechanism and scattering mechanism of two-dimensional electron gas (2DEG) in InAs channel were demonstrated, based on the software simulation in detail. In order to discuss the impact of different epitaxial structures on the 2DEG and electron mobility in channel, four kinds of epitaxies with different thickness of InAs channel and AlSb upper-barrier were manufactured. The samples were evaluated with the contact Hall test. It is found the sample with a channel thickness of 15 nm and upper-barrier layer of 17 nm shows a best compromised sheet carrier concentration of 2.56 × 1012 cm−2 and electron mobility of 1.81 × 104 cm2/V·s, and a low sheet resistivity of 135 Ω/□, which we considered to be the optimized thickness of channel layer and upper-barrier layer. This study is a reference to further design InAs/AlSb HEMT, by ensuring a good device performance.


2015 ◽  
Vol 54 (4) ◽  
Author(s):  
Vytautas Jakštas ◽  
Irmantas Kašalynas ◽  
Irena Šimkienė ◽  
Viktorija Strazdienė ◽  
Pawel Prystawko ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document