Mixed-mode crack opening displacement measurements for small fatigue cracks growing in Astroloy at 20 oC

2000 ◽  
Vol 23 (5) ◽  
pp. 445-452 ◽  
Author(s):  
Davidson
Keyword(s):  
Crack Opening Displacement ◽  
Mixed Mode ◽  
Fatigue Cracks ◽  
Crack Opening ◽  
Opening Displacement ◽  
Mixed Mode Crack ◽  
Displacement Measurements

In-Situ Estimation of Surface Crack Shape From Crack Opening Displacement by Use of NCOD Database System

2010 ◽  
Author(s):  
Jingxia Yue ◽  
Zheng He ◽  
Yukio Fujimoto ◽  
Weiguo Wu
Keyword(s):  
Crack Opening Displacement ◽  
Surface Crack ◽  
Fatigue Cracks ◽  
Crack Opening ◽  
Crack Depth ◽  
Database System ◽  
Shape Estimation ◽  
Opening Displacement ◽  
Crack Shape

This paper proposes an in-situ estimation of crack shape from crack opening displacement (COD) by using of a visualized database system consisting of numerical calculation data of normalized crack opening displacement (NCOD) for some kinds of crack types. The relation between crack depth and corresponding NCOD is discussed based on FE analysis results, from which a crack shape estimation principle is deduced. Visualized software named NCOD Database System was developed to facilitate convenient in-situ estimation of crack shape. Shapes of three kinds of surface crack, partial circle crack in plate, fatigue cracks in gusset weld joint and in large-scale member, are successfully estimated by this system. The paper is supported by the Programme of Introducing Talents of Discipline to Universities (B08031).

Controlled Initiation of Short Fatigue Cracks in 316L Steel

2005 ◽  
Author(s):  
D. Stefanescu ◽  
J. Marrow ◽  
M. Preuss ◽  
A. Sherry
Keyword(s):  
Experimental Study ◽  
Stainless Steel ◽  
Crack Opening Displacement ◽  
Crack Nucleation ◽  
Fatigue Cracks ◽  
Crack Opening ◽  
Crack Tip ◽  
Image Correlation ◽  
Opening Displacement ◽  
R Ratio

Validation of models for short crack behavior requires accurate measurement of crack opening displacement and crack tip strain fields. Development of reliable measurement procedures, using new techniques such as Image Correlation (IC), requires specimens containing cracks with a well defined geometry. In this paper, results of an experimental study concerning controlled initiation of short fatigue cracks at positive R-ratio in laboratory specimens made from 316L stainless steel are presented. Experimental techniques, including hardness testing and X-ray diffraction were employed in order to investigate the effect of surface preparation on the surface mechanical properties and residual stresses. Crack nucleation is difficult in smooth specimens of 316L austenitic stainless steel at positive R-ratio due to the high fatigue limit and low tensile strength. Specimens with a thin ligament were therefore developed to enable nucleation of a single short fatigue crack. An experimental study of the crack growth aspect ratio evolution was then carried out using a beach marking technique. The technique described in this paper enables single short fatigue cracks of well defined geometry to be nucleated under tensile cyclic loading. Stress corrosion cracks can be developed using the same specimen geometry. Miniature tensile specimens can then be extracted to perform in-situ measurements of the crack opening displacement and crack tip strain field by Image Correlation from Scanning Electron Microscopy observations.

Sign in / Sign up

Export Citation Format

Share Document