Diffuser design and experimental research of a large-scale chilled water storage system

Author(s):  
Jiali Tang ◽  
Zhengrong OuYang ◽  
Yuyang Shi
2013 ◽  
Vol 405-408 ◽  
pp. 2964-2968 ◽  
Author(s):  
Hu Lin ◽  
Xin Hong Li ◽  
Peng Sheng Cheng ◽  
Bu Gong Xu

For the purpose of grid peak load shifting, chilled water storage has been paid more and more attentions to integrated with air-conditioning system. In this paper, a new air conditioning system with directly chilled water storage is given. With peak-valley Price, cost for power consumption can be saved 15%-20% by coordinated operation between chilled water storage system and air conditioning system. By sensitivity analysis of system economic performance on ratio of peak price to valley price, it is revealed that with much higher ratio of peak price to valley price, not only system economic performance can seldom be improved, but also chilled water storage is restricted for engineering utilization. This paper supplies theory reference for engineering application of chilled water storage technology.


2011 ◽  
Vol 31 (14-15) ◽  
pp. 2656-2664 ◽  
Author(s):  
Zhiqin Zhang ◽  
William D. Turner ◽  
Qiang Chen ◽  
Chen Xu ◽  
Song Deng

1979 ◽  
Vol 23 (89) ◽  
pp. 430-432 ◽  
Author(s):  
A. Iken ◽  
A. Flotron ◽  
W. Haeberli ◽  
H. Röthlisberger

Abstract The results of systematic movement studies carried out by means of an automatic camera on the Unteraargletscher since 1969 (Flotron, 1973) are discussed together with more recent findings from theodolite measurements made at shorter intervals and over a longer section of the glacier. In addition to the typical spring/early-summer maximum of velocity known from other glaciers, an upward movement of up to 0.6 m has been recorded at the beginning of the melt season. It was followed, after various fluctuations of the vertical velocity, by a similar but slower downward movement which continued at an almost constant rate for about three months. The uplift was not confined to the section covered by the camera but occurred nearly simultaneously in profiles located 1 km below and 2 km above. The times of maximum upward velocity (increases of up to 140 mm/d) coincided approximately with periods of large horizontal velocity and occurred after increases of melt-rate. The following explanations for the variations of vertical velocity are considered: (1) Changes of longitudinal strain-rate. (2) Changes of the sliding velocity in a channel of variable width and with a bed slope deviating from horizontal. (3) Changes of volume due to opening or closing of crevasses. (4) Swelling or contraction of veins at the grain edges. (5) Growth (and closure) of cavities in the interior of the glacier. (6) Changes of large-scale water storage at the bed. Although all of the mechanisms (1)–(5) have some effect on the vertical ice movement, they cannot account for the observed variations of vertical velocity. We therefore conclude that large-scale water storage at the bed is the main cause of the uplift. Apparently the storage system is efficiently connected with the main subglacial drainage channels only during times of very high water pressure in the channels. The findings are of some interest to the concepts of glacier sliding: As mentioned above the maxima of horizontal velocity—and thus of the sliding velocity—have not been measured at the time when the storage had attained a maximum, but at the time of maximum vertical velocity, which we assume to be the time of most rapid growth of cavities at the bed. This behaviour of the sliding velocity agrees with that predicted by a simple finite-element model of the basal ice on a wavy bed with water-filled cavities. In particular, the model shows that the sliding velocity is larger during the process of cavity growth than at the final stage when the cavities have grown to the size which is stable for the applied water pressure.


1979 ◽  
Vol 23 (89) ◽  
pp. 430-432 ◽  
Author(s):  
A. Iken ◽  
A. Flotron ◽  
W. Haeberli ◽  
H. Röthlisberger

AbstractThe results of systematic movement studies carried out by means of an automatic camera on the Unteraargletscher since 1969 (Flotron, 1973) are discussed together with more recent findings from theodolite measurements made at shorter intervals and over a longer section of the glacier.In addition to the typical spring/early-summer maximum of velocity known from other glaciers, an upward movement of up to 0.6 m has been recorded at the beginning of the melt season. It was followed, after various fluctuations of the vertical velocity, by a similar but slower downward movement which continued at an almost constant rate for about three months. The uplift was not confined to the section covered by the camera but occurred nearly simultaneously in profiles located 1 km below and 2 km above. The times of maximum upward velocity (increases of up to 140 mm/d) coincided approximately with periods of large horizontal velocity and occurred after increases of melt-rate.The following explanations for the variations of vertical velocity are considered: (1) Changes of longitudinal strain-rate. (2) Changes of the sliding velocity in a channel of variable width and with a bed slope deviating from horizontal. (3) Changes of volume due to opening or closing of crevasses. (4) Swelling or contraction of veins at the grain edges. (5) Growth (and closure) of cavities in the interior of the glacier. (6) Changes of large-scale water storage at the bed.Although all of the mechanisms (1)–(5) have some effect on the vertical ice movement, they cannot account for the observed variations of vertical velocity. We therefore conclude that large-scale water storage at the bed is the main cause of the uplift. Apparently the storage system is efficiently connected with the main subglacial drainage channels only during times of very high water pressure in the channels.The findings are of some interest to the concepts of glacier sliding: As mentioned above the maxima of horizontal velocity—and thus of the sliding velocity—have not been measured at the time when the storage had attained a maximum, but at the time of maximum vertical velocity, which we assume to be the time of most rapid growth of cavities at the bed. This behaviour of the sliding velocity agrees with that predicted by a simple finite-element model of the basal ice on a wavy bed with water-filled cavities. In particular, the model shows that the sliding velocity is larger during the process of cavity growth than at the final stage when the cavities have grown to the size which is stable for the applied water pressure.


Sign in / Sign up

Export Citation Format

Share Document