Analysis of defects in externally driven dust-density wavefronts in cogenerated dusty plasma using the time-resolved Hilbert–Huang transform

2016 ◽  
Vol 49 (20) ◽  
pp. 205201 ◽  
Author(s):  
Sanjib Sarkar ◽  
Chiranjib Barman ◽  
Malay Mondal ◽  
M Bose ◽  
S Mukherjee
Keyword(s):  
Dusty Plasma ◽  
Time Resolved ◽  
Dust Density ◽  
Hilbert Huang Transform

Effects of strength of dispersion and dust density on the formation of solitons and shocks in unmagnetized dusty plasma

2009 ◽  
Vol 16 (7) ◽  
pp. 073702 ◽  
Author(s):  
H. Asgari ◽  
S. V. Muniandy ◽  
C. S. Wong
Keyword(s):  
Dusty Plasma ◽  
Dust Density

scholarly journals Time‐resolved analysis of the precursor fragmentation kinetics in an hybrid PVD/PECVD dusty plasma with pulsed injection of HMDSO

2019 ◽  
Vol 16 (11) ◽  
pp. 1900044
Author(s):  
Vincent Garofano ◽  
Remy Bérard ◽  
Xavier Glad ◽  
Christine Joblin ◽  
Kremena Makasheva ◽  
...  
Keyword(s):  
Dusty Plasma ◽  
Time Resolved ◽  
Pulsed Injection

Simulations of ion–dust streaming instability in a highly collisional plasma

2020 ◽  
Vol 86 (6) ◽  
Author(s):  
K. Quest ◽  
M. Rosenberg ◽  
A. Levine
Keyword(s):  
Dusty Plasma ◽  
Low Frequency ◽  
Collisional Plasma ◽  
Ion Flow ◽  
Dust Density ◽  
Particle In Cell ◽  
Nonlinear Development ◽  
Nonlinear Phase ◽  
Streaming Instability ◽  
Flow Speeds

The excitation of low frequency dust acoustic (or dust density) waves in a dusty plasma can be driven by the flow of ions relative to dust. We consider the nonlinear development of the ion–dust streaming instability in a highly collisional plasma, where the ion and dust collision frequencies are a significant fraction of their corresponding plasma frequencies. This collisional parameter regime may be relevant to dusty plasma experiments under microgravity or ground-based conditions with high gas pressure. One-dimensional particle-in-cell simulations are presented, which take into account collisions of ions and dust with neutrals, and a background electric field that drives the ion flow. Ion flow speeds of the order of a few times thermal are considered. Waveforms of the dust density are found to have broad troughs and sharp crests in the nonlinear phase. The results are compared with the nonlinear development of the ion–dust streaming instability in a plasma with low collisionality.

Microtubule nucleation sequence studied by time-resolved x-ray scattering and electron microscopy

1983 ◽  
Vol 41 ◽  
pp. 766-767
Author(s):  
Eva-Maria Mandelkow ◽  
Eckhard Mandelkow ◽  
Joan Bordas
Keyword(s):  
Electron Microscopy ◽  
Dynamic Equilibrium ◽  
Time Resolved ◽  
X Ray ◽  
Additional Information ◽  
X Ray Scattering ◽  
Low Concentrations ◽  
Microtubule Growth ◽  
Ray Patterns ◽  
Ray Scattering

When a solution of microtubule protein is changed from non-polymerising to polymerising conditions (e.g. by temperature jump or mixing with GTP) there is a series of structural transitions preceding microtubule growth. These have been detected by time-resolved X-ray scattering using synchrotron radiation, and they may be classified into pre-nucleation and nucleation events. X-ray patterns are good indicators for the average behavior of the particles in solution, but they are difficult to interpret unless additional information on their structure is available. We therefore studied the assembly process by electron microscopy under conditions approaching those of the X-ray experiment. There are two difficulties in the EM approach: One is that the particles important for assembly are usually small and not very regular and therefore tend to be overlooked. Secondly EM specimens require low concentrations which favor disassembly of the particles one wants to observe since there is a dynamic equilibrium between polymers and subunits.

Electron Channeling Patterns

1977 ◽  
Vol 35 ◽  
pp. 12-13
Author(s):  
David C. Joy
Keyword(s):  
Electron Diffraction ◽  
Incidence Angle ◽  
Photographic Plate ◽  
Diffraction Effect ◽  
Angle Of Incidence ◽  
Bulk Single Crystal ◽  
Time Resolved ◽  
Electron Channeling ◽  
Spatially Resolved ◽  
Large Bulk

Electron channeling patterns (ECP) were first found by Coates (1967) while observing a large bulk, single crystal of silicon in a scanning electron microscope. The geometric pattern visible was shown to be produced as a result of the changes in the angle of incidence, between the beam and the specimen surface normal, which occur when the sample is examined at low magnification (Booker, Shaw, Whelan and Hirsch 1967).A conventional electron diffraction pattern consists of an angularly resolved intensity distribution in space which may be directly viewed on a fluorescent screen or recorded on a photographic plate. An ECP, on the other hand, is produced as the result of changes in the signal collected by a suitable electron detector as the incidence angle is varied. If an integrating detector is used, or if the beam traverses the surface at a fixed angle, then no channeling contrast will be observed. The ECP is thus a time resolved electron diffraction effect. It can therefore be related to spatially resolved diffraction phenomena by an application of the concepts of reciprocity (Cowley 1969).

Time-resolved high-resolution electron microscopy of structural stability in mgo clusters

1996 ◽  
Vol 54 ◽  
pp. 672-673
Author(s):  
T. Kizuka ◽  
N. Tanaka
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Magnesium Oxide ◽  
Structural Stability ◽  
High Resolution Electron Microscopy ◽  
Video Tape ◽  
Solid State Physics ◽  
Time Resolved ◽  
Resolution Electron ◽  
Structural And Functional Properties

Structure and stability of atomic clusters have been studied by time-resolved high-resolution electron microscopy (TRHREM). Typical examples are observations of structural fluctuation in gold (Au) clusters supported on silicon oxide films, graphtized carbon films and magnesium oxide (MgO) films. All the observations have been performed on the clusters consisted of single metal element. Structural stability of ceramics clusters, such as metal-oxide, metal-nitride and metal-carbide clusters, has not been observed by TRHREM although the clusters show anomalous structural and functional properties concerning to solid state physics and materials science.In the present study, the behavior of ceramic, magnesium oxide (MgO) clusters is for the first time observed by TRHREM at 1/60 s time resolution and at atomic resolution down to 0.2 nm.MgO and gold were subsequently deposited on sodium chloride (001) substrates. The specimens, single crystalline MgO films on which Au particles were dispersed were separated in distilled water and observed by using a 200-kV high-resolution electron microscope (JEOL, JEM2010) equipped with a high sensitive TV camera and a video tape recorder system.

Cryo-TEM of amphiphilic polymer and amphiphile/polymer solutions

1993 ◽  
Vol 51 ◽  
pp. 876-877
Author(s):  
Yeshayahu Talmon
Keyword(s):  
Microstructural Characterization ◽  
Building Blocks ◽  
Quantitative Information ◽  
Physical Models ◽  
Specimen Preparation ◽  
Time Resolved ◽  
Temperature Changes ◽  
Temperature And Humidity ◽  
Microstructured Fluids ◽  
Air Streams

To achieve complete microstructural characterization of self-aggregating systems, one needs direct images in addition to quantitative information from non-imaging, e.g., scattering or Theological measurements, techniques. Cryo-TEM enables us to image fluid microstructures at better than one nanometer resolution, with minimal specimen preparation artifacts. Direct images are used to determine the “building blocks” of the fluid microstructure; these are used to build reliable physical models with which quantitative information from techniques such as small-angle x-ray or neutron scattering can be analyzed.To prepare vitrified specimens of microstructured fluids, we have developed the Controlled Environment Vitrification System (CEVS), that enables us to prepare samples under controlled temperature and humidity conditions, thus minimizing microstructural rearrangement due to volatile evaporation or temperature changes. The CEVS may be used to trigger on-the-grid processes to induce formation of new phases, or to study intermediate, transient structures during change of phase (“time-resolved cryo-TEM”). Recently we have developed a new CEVS, where temperature and humidity are controlled by continuous flow of a mixture of humidified and dry air streams.

Sign in / Sign up

Export Citation Format

Share Document