scholarly journals Pharmacodynamic effect of clinical vancomycin exposures on cell wall thickness in heterogeneous vancomycin-intermediate Staphylococcus aureus

2010 ◽  
Vol 65 (10) ◽  
pp. 2149-2154 ◽  
Author(s):  
W. E. Rose ◽  
R. M. Knier ◽  
P. R. Hutson
Keyword(s):  
Staphylococcus Aureus ◽  
Cell Wall ◽  
Wall Thickness ◽  
Cell Wall Thickness ◽  
Pharmacodynamic Effect

scholarly journals Ceftaroline Increases Membrane Binding and Enhances the Activity of Daptomycin against Daptomycin-Nonsusceptible Vancomycin-Intermediate Staphylococcus aureus in a Pharmacokinetic/Pharmacodynamic Model

2012 ◽  
Vol 57 (1) ◽  
pp. 66-73 ◽  
Author(s):  
Brian J. Werth ◽  
George Sakoulas ◽  
Warren E. Rose ◽  
Joseph Pogliano ◽  
Ryan Tewhey ◽  
...  
Keyword(s):  
Staphylococcus Aureus ◽  
Cell Wall ◽  
Wall Thickness ◽  
Antimicrobial Agents ◽  
Single Agent ◽  
Pharmacodynamic Model ◽  
Cell Wall Thickness ◽  
Ceftaroline Fosamil ◽  
Content Type

ABSTRACTNew antimicrobial agents and novel combination therapies are needed to treat serious infections caused by methicillin-resistantStaphylococcus aureus(MRSA) with reduced susceptibility to daptomycin and vancomycin. The purpose of this study was to evaluate the combination of ceftaroline plus daptomycin or vancomycin in anin vitropharmacokinetic/pharmacodynamic model. Simulations of ceftaroline-fosamil at 600 mg per kg of body weight every 8 h (q8h) (maximum free-drug concentration in serum [fCmax], 15.2 mg/liter; half-life [t1/2], 2.3 h), daptomycin at 10 mg/kg/day (fCmax, 11.3 mg/liter;t1/2, 8 h), vancomycin at 2 g q12h (fCmax, 30 mg/liter;t1/2, 6 h), ceftaroline plus daptomycin, and ceftaroline plus vancomycin were evaluated against a clinical, isogenic MRSA strain pair: D592 (daptomycin susceptible and heterogeneous vancomycin intermediate) and D712 (daptomycin nonsusceptible and vancomycin intermediate) in a one-compartmentin vitropharmacokinetic/pharmacodynamic model over 96 h. Therapeutic enhancement of combinations was defined as ≥2 log10CFU/ml reduction over the most active single agent. The effect of ceftaroline on the membrane charge, cell wall thickness, susceptibility to killing by the human cathelicidin LL37, and daptomycin binding were evaluated. Therapeutic enhancement was observed with daptomycin plus ceftaroline in both strains and vancomycin plus ceftaroline against D592. Ceftaroline exposure enhanced daptomycin-induced depolarization (81.7% versus 72.3%;P= 0.03) and killing by cathelicidin LL37 (P< 0.01) and reduced cell wall thickness (P< 0.001). Fluorescence-labeled daptomycin was bound over 7-fold more in ceftaroline-exposed cells. Whole-genome sequencing and mutation analysis of these strains indicated that change in daptomycin susceptibility is related to anfmtC(mprF) mutation. The combination of daptomycin plus ceftaroline appears to be potent, with rapid and sustained bactericidal activity against both daptomycin-susceptible and -nonsusceptible strains of MRSA.

scholarly journals Cell-wall thickness: possible mechanism of acriflavine resistance in meticillin-resistant Staphylococcus aureus

2009 ◽  
Vol 58 (3) ◽  
pp. 331-336 ◽  
Author(s):  
Mako Kawai ◽  
Sakuo Yamada ◽  
Ai Ishidoshiro ◽  
Yoshihiro Oyamada ◽  
Hideaki Ito ◽  
...  
Keyword(s):  
Staphylococcus Aureus ◽  
Cell Wall ◽  
Wall Thickness ◽  
Bacterial Growth ◽  
Cell Wall Thickness ◽  
Susceptible Strain ◽  
Permeability Barrier ◽  
Multidrug Efflux ◽  
Multidrug Efflux Pumps ◽  
Conceivable Mechanism

Acriflavine resistance in the clinical meticillin-resistant Staphylococcus aureus isolate KT24 was found not to be mediated by multidrug efflux pumps encoded by qacA/B, smr, qacE, qacG, qacH, qacJ or norA. Early uptake and accumulation of ethidium bromide in MRSA KT24 was significantly lower than that in a susceptible strain, although the efflux rates were similar. Therefore, a permeability barrier in MRSA KT24 may be the conceivable mechanism of acriflavine resistance. Interestingly, it was found that MRSA KT24 had a significantly thickened cell wall, and that cell-wall thickness increased gradually during bacterial growth. In contrast, cell size and surface area in MRSA KT24 were not different from those in the susceptible strain. Moreover, MRSA KT24 exposure to sub-MIC concentrations of acriflavine resulted in a thicker cell wall. These results indicate that cell-wall thickness may be responsible for acriflavine resistance in S. aureus.

Properties of Gliricidia Wood (Gliricidia sepium) lntercropped with Cocoa (Theobroma cocoa) in Malaysia

2014 ◽  
Vol 11 (1) ◽  
pp. 51
Author(s):  
Mohd Helmy Ibrahim ◽  
Mohd Nazip Suratman ◽  
Razali Abd Kader
Keyword(s):  
Cell Wall ◽  
Specific Gravity ◽  
Moisture Content ◽  
Wall Thickness ◽  
Age Groups ◽  
Gliricidia Sepium ◽  
Cell Wall Thickness ◽  
Tree Age ◽  
Lumen Diameter ◽  
Significant Difference

Trees planted from agroforestry practices can become valuable resources in meeting the wood requirements of many nations. Gliricidia sepium is an exotic species introduced to the agricultural sector in Malaysia mainly for providing shade for cocoa and coffee plantations. This study investigates its wood physical properties (specific gravity and moisture content) and fibre morphology (length, lumen diameter and cell wall thickness) of G. sepium at three intervals according to age groups ( three, five and seven years of ages). Specific gravity (0.72) was significantly higher at seven years ofage as compared to five (0.41) and three (0.35) years age group with a mean of 0.43 (p<0.05). Mean moisture content was 58.3% with no significant difference existing between the tree age groups. Fibre diameter (22.4 mm) was significantly lower (p<0.05) for the trees which were three years of age when compared to five and seven years age groups (26.6 mm and 24. 7 mm), respectively. Means of fibre length, lumen diameter and cell wall thickness were 0.83 mm, 18.3 mm, and 6.2 mm, respectively, with no significant differences detected between trees in all age groups. Further calculation on the coefficient of suppleness and runkel ratio suggest that wood from G.sepium may have the potential for insulation board manufacturing and paper making. However, future studies should experiment the utilisation of this species for these products to determine its full potential.

Characterization of microstructures of SAN foam core using micro-computed tomography

2021 ◽  
pp. 026248932110068
Author(s):  
Youming Chen ◽  
Raj Das ◽  
Hui Wang ◽  
Mark Battley
Keyword(s):  
Cell Wall ◽  
Cell Size ◽  
Wall Thickness ◽  
Strain Localization ◽  
Cell Wall Thickness ◽  
Micro Computed Tomography ◽  
Average Cell Size ◽  
Average Cell ◽  
3D Images ◽  
Compressive Tests

In this study, the microstructure of a SAN foam was imaged using a micro-CT scanner. Through image processing and analysis, variations in density, cell wall thickness and cell size in the foam were quantitatively explored. It is found that cells in the foam are not elongated in the thickness (or rise) direction of foam sheets, but rather equiaxed. Cell walls in the foam are significantly straight. Density, cell size and cell wall thickness all vary along the thickness direction of foam sheets. The low density in the vicinity of one face of foam sheets leads to low compressive stiffness and strength, resulting in the strain localization observed in our previous compressive tests. For M80, large open cells on the top face of foam sheets are likely to buckle in compressive tests, therefore being another potential contributor to the strain localization as well. The average cell wall thickness measured from 2D slice images is around 1.4 times that measured from 3D images, and the average cell size measured from 2D slice images is about 13.8% smaller than that measured from 3D images. The dispersions of cell wall thickness measured from 2D slice images are 1.16–1.20 times those measured from 3D images. The dispersions of cell size measured from 2D slice images are 1.12–1.36 times those measured from 3D images.

Summer temperature in northeastern Siberia since 1642 reconstructed from tracheid dimensions and cell numbers of Larix cajanderi

2003 ◽  
Vol 33 (10) ◽  
pp. 1905-1914 ◽  
Author(s):  
Irina P Panyushkina ◽  
Malcolm K Hughes ◽  
Eugene A Vaganov ◽  
Martin AR Munro
Keyword(s):  
Cell Wall ◽  
Wall Thickness ◽  
Cell Number ◽  
Cell Wall Thickness ◽  
Cell Dimension ◽  
Cell Numbers ◽  
Age Related ◽  
Cambial Age ◽  
Northeastern Siberia ◽  
Larix Cajanderi

We reconstructed air temperature for two periods in the growth season from cell dimension and cell number variability in cross-dated tree rings of Larix cajanderi Mayr. from northeastern Siberia. Thirteen tree-ring chronologies based on cell size, cell wall thickness, and cell number were developed for AD 1642–1993. No clear evidence was found of an age-related trend in cell dimensions in the sampled materials, but cell numbers were correlated with cambial age. The chronologies contain strong temperature signals associated with the timing of xylem growth. We obtained reliable reconstructions of mean June temperature from the total cell number and July–September temperature from the cell wall thickness of latewood. June temperature and July–September temperature covaried for most of the period from AD 1642 to AD 1978. After that time, June temperature became cooler relative to July–September temperature. This difference caused disproportional changes in earlywood tracheids because of the late start of growth and cool conditions in June followed by warming during the rest of the season. The identification of this unusual recent change has shown that intraseasonal resolution may be achieved by cell dimension and cell number chronologies.

Sign in / Sign up

Export Citation Format

Share Document