Improvement of transient and steady state performance of a scalar controlled induction motor using sliding mode controller

Author(s):  
Swagat Pati ◽  
Sattapriya Mohanty ◽  
Manas Patnaik
2020 ◽  
Vol 14 ◽  
Author(s):  
Gang Liu ◽  
Dong Qiu ◽  
Xiuru Wang ◽  
Ke Zhang ◽  
Huafeng Huang ◽  
...  

Background: The PWM Boost converter is a strongly nonlinear discrete system, especially when the input voltage or load varies widely, therefore, tuning the control parameters of which is a challenge work. Objective: In order to overcome the issues, particle swarm optimization (PSO) is employed for tuning the parameters of a sliding mode controller of a boost converter. Methods: Based on the analysis of the Boost converter model and its non-linear characteristics, a mathematic model of a boost converter with a sliding mode controller is built firstly. Then, the parameters of the Boost controller are adjusted based on the integrated time and absolute error (ITAE), integral square error (ISE) and integrated absolute error (IAE) indexes by PSO. Results: Simulation verification was performed, and the results show that the controllers tuned by the three indexes all have excellent robust stability. Conclusion: The controllers tuned by ITAE and ISE indexes have excellent steady-state performance, but the overshoot is large during the startup. The controller tuned by IAE index has better startup performance and slightly worse steady-state performance.


2021 ◽  
Vol 3 (3) ◽  
pp. 10-19
Author(s):  
Samar Abdulkareem AL-Hashemi ◽  
Ayad AL-Dujaili ◽  
Ahmed R. Ajel

Induction motors are widely used in commercial and industrial applications due to their robustness, high efficiency, low maintenance requirements and durability among other reasons. Consequently, their speed should be controlled for better performance. This paper describes utilization of a scalar speed control of a three-phase squirrel cage induction motor (SCIM) to control a motor’s speed using an integral sliding mode controller (ISMC). The controller was tested under various operating conditions. The results are compared with a case employing a conventional PI controller. It was found that speed control by ISMC has a 0.16 RPM steady-state error, 0.03 s to reach steady-state from a standstill, and a 5% overshoot. All of these are lower values as compared to the results of a conventional PI controller. In this paper, the robustness of each controller to uncertainties is checked. Simulation results show the advantages of ISMC control methods. The system is simulated using MATLAB SIMULINK R2017a.


2021 ◽  
Vol 233 ◽  
pp. 01051
Author(s):  
Tianze Miao ◽  
Xiaona Liu ◽  
Siyuan Liu ◽  
Lihua Wang

The bi-directional DC / DC converter in DC microgrid is a typical nonlinear system which has large voltage disturbance during lead accumulator charging and discharging. In order to solve the problem of voltage disturbance, the linearization of the converter is realized by exact feedback linearization, and the sliding mode controller is designed by using exponential approximation law. The simulation results show that the method has fast response speed, strong anti-interference ability and good steady-state characteristics.


Sign in / Sign up

Export Citation Format

Share Document