Tailoring the Microstructure of a Metal-Reinforced Ceramic Matrix Composite

2000 ◽  
Vol 122 (3) ◽  
pp. 363-367 ◽  
Author(s):  
O. Sbaizero ◽  
G. Pezzotti
Keyword(s):  
Crack Propagation ◽  
Ceramic Matrix Composite ◽  
Spectroscopic Technique ◽  
In Situ Raman Spectroscopy ◽  
Stable Crack Propagation ◽  
Grain Sizes ◽  
In Situ Raman ◽  
Bridging Stresses ◽  
Good Agreement

Alumina matrix was prepared with varying amounts of metal molybdenum particles of two different grain sizes. R-curves were determined during stable crack propagation and a piezo-spectroscopic technique was used to assess the bridging stresses developed along the crack wake (at the metal/matrix interface) at the critical condition for crack propagation. In both kinds of composites, the toughness monotonically increases with the amount of molybdenum added. In addition, bridging stress and therefore toughness were higher when coarser particles were present. The theoretical R-curves calculated from the discrete (microscopic) bridging stress distribution obtained by in situ Raman spectroscopy were in good agreement with the experimental data. [S0094-4289(00)02003-X]

“In-Situ Raman Spectroscopy of Electronic Processes in Fullerene Thin Films

2002 ◽  
Vol 725 ◽  
Author(s):  
S.B. Phelan ◽  
B.S. O'Connell ◽  
G. Farrell ◽  
G. Chambers ◽  
H.J. Byrne
Keyword(s):  
Thin Film ◽  
Indium Tin Oxide ◽  
Low Temperatures ◽  
In Situ Raman Spectroscopy ◽  
State Reduction ◽  
In Situ Raman ◽  
Linear Behavior ◽  
Current Voltage ◽  
Solid State Reduction

AbstractThe current voltage characteristics of C60 thin film sandwich structures fabricated by vacuum deposition on indium tin oxide (ITO) with an aluminium top electrode are presented and discussed. A strongly non-linear behavior and a sharp increase in the device conductivity was observed at relatively low voltages (∼2V), at both room and low temperatures (20K). At room temperature the system is seen to collapse, and in situ Raman measurements indicate a solid state reduction of the fullerene thin film to form a polymeric state. The high conductivity state was seen to be stable at elevated voltages and low temperatures. This state is seen to be reversible with the application of high voltages. At these high voltages the C60 film was seen to sporadically emit white light at randomly localized points analogous to the much documented Electroluminescence in single crystals.

In Situ Raman Spectroscopy Studies on La2CaB10O19 Crystal Growth

2020 ◽  
Vol 20 (10) ◽  
pp. 6604-6609
Author(s):  
Shanshan Liu ◽  
Guochun Zhang ◽  
Kai Feng ◽  
Yanyang Han ◽  
Tao He ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Crystal Growth ◽  
In Situ Raman Spectroscopy ◽  
In Situ Raman ◽  
Spectroscopy Studies

The use of in-situ Raman spectroscopy in investigating carbon materials as the anodes of alkali metal-ion batteries

Carbon ◽  
2021 ◽  
Vol 177 ◽  
pp. 428
Author(s):  
Xiaoqin Cheng ◽  
Huijun Li ◽  
Zhenxin Zhao ◽  
Yong-zhen Wang ◽  
Xiaomin Wang
Keyword(s):  
Raman Spectroscopy ◽  
Alkali Metal ◽  
Metal Ion ◽  
Carbon Materials ◽  
In Situ Raman Spectroscopy ◽  
Alkali Metal Ion ◽  
In Situ Raman

An apparatus for in situ Raman spectroscopy of ion‐irradiated frozen targets

1991 ◽  
Vol 62 (7) ◽  
pp. 1743-1745 ◽  
Author(s):  
F. Spinella ◽  
G. A. Baratta ◽  
G. Strazzulla
Keyword(s):  
Raman Spectroscopy ◽  
In Situ Raman Spectroscopy ◽  
In Situ Raman

Advanced Technique for In Situ Raman Spectroscopy Monitoring of the Freezing-Induced Loading Process

Langmuir ◽  
2021 ◽  
Vol 37 (4) ◽  
pp. 1365-1371
Author(s):  
Sergei V. German ◽  
Gleb S. Budylin ◽  
Evgeny A. Shirshin ◽  
Dmitry A. Gorin
Keyword(s):  
Raman Spectroscopy ◽  
In Situ Raman Spectroscopy ◽  
Advanced Technique ◽  
Loading Process ◽  
In Situ Raman
Sign in / Sign up

Export Citation Format

Share Document