Indirect Coupling Constants in a Thallium Single Crystal

1974 ◽  
Vol 52 (8) ◽  
pp. 687-693
Author(s):  
J. Schratter ◽  
D. Llewelyn Williams

We have measured the angular dependence of the line width in thallium and related it to the second moment to estimate the pseudodipolar and pseudoexchange contributions for the first two shells of neighbors. These values are very different, despite the fact that both shells have nearly the same radius, and this establishes experimentally for the first time an orientation dependence of the indirect coupling constants.

1989 ◽  
Vol 160 ◽  
Author(s):  
David J. Godbey ◽  
Mark E. Twigg

Single crystal undoped germanium has been grown successfully for the first time on (1102) sapphire [1,2]. Germanium was found to grow (110) with an in plane registry of Ge(111)/Al203(1012) [1]. When a 2μm germanium film was grown on (1102) sapphire at 800°C and after a substrate preanneal of 1400°C, the X-ray line width of the Ge(220) reflection was measured to be 230 arcseconds [2]. Strain was observed only in germanium films that were thinner than 40 nm [2].


1995 ◽  
Vol 10 (5) ◽  
pp. 1187-1195 ◽  
Author(s):  
Y. He ◽  
R.B. Schwarz ◽  
A. Migliori ◽  
S.H. Whang

The six independent second-order elastic stiffness coefficients of a Ti44Al56 single crystal (L10 structure) have been measured at room temperature for the first time using a resonant ultrasonic spectroscopy (RUS) technique. These data were used to calculate the orientation dependence of Young's modulus and the shear modulus. Young's modulus is found to reach a maximum near a [111] direction, close to the normal to the most densely packed planes. The elastic moduli and Poisson's ratio for polycrystalline materials, calculated by the averaging scheme proposed by Hill, are in good agreement with experimental data and theoretical calculations.


2018 ◽  
Author(s):  
C. Michael McGuirk ◽  
Tomče Runčevski ◽  
Julia Oktawiec ◽  
Ari Turkiewicz ◽  
mercedes K. taylor ◽  
...  

<p>Metal–organic frameworks that display step-shaped adsorption profiles arising from discrete pressure-induced phase changes are promising materials for applications in both high-capacity gas storage and energy-efficient gas separations. The thorough investigation of such materials through chemical diversification, gas adsorption measurements, and <i>in situ </i>structural characterization is therefore crucial for broadening their utility. We examine a series of isoreticular, flexible zeolitic imidazolate frameworks (ZIFs) of the type M(bim)<sub>2</sub> (SOD; M = Zn<sup> </sup>(ZIF-7), Co (ZIF-9), Cd (CdIF-13); bim<sup>–</sup> = benzimidazolate), and elucidate the effects of metal substitution on the pressure-responsive phase changes and the resulting CO<sub>2</sub> and CH<sub>4</sub> step positions, pre-step uptakes, and step capacities. Using ZIF-7 as a benchmark, we reexamine the poorly understood structural transition responsible for its adsorption steps and, through high-pressure adsorption measurements, verify that it displays a step in its CH<sub>4 </sub>adsorption isotherms. The ZIF-9 material is shown to undergo an analogous phase change, yielding adsorption steps for CO<sub>2</sub> and CH<sub>4</sub> with similar profiles and capacities to ZIF-7, but with shifted threshold pressures. Further, the Cd<sup>2+</sup> analogue CdIF-13 is reported here for the first time, and shown to display adsorption behavior distinct from both ZIF-7 and ZIF-9, with negligible pre-step adsorption, a ~50% increase in CO<sub>2</sub> and CH<sub>4</sub> capacity, and dramatically higher threshold adsorption pressures. Remarkably, a single-crystal-to-single-crystal phase change to a pore-gated phase is also achieved with CdIF-13, providing insight into the phase change that yields step-shaped adsorption in these flexible ZIFs. Finally, we show that the endothermic phase change of these frameworks provides intrinsic heat management during gas adsorption. </p>


Molbank ◽  
10.3390/m1200 ◽  
2021 ◽  
Vol 2021 (2) ◽  
pp. M1200
Author(s):  
R. Alan Aitken ◽  
Dheirya K. Sonecha ◽  
Alexandra M. Z. Slawin

The X-ray structure of the title compound has been determined for the first time. Data on its 1H–13C-NMR coupling constants and 15N-NMR spectrum are also given.


1969 ◽  
Vol 47 (1) ◽  
pp. 1-17 ◽  
Author(s):  
L. D. Hall ◽  
J. F. Manville ◽  
N. S. Bhacca

A detailed study has been made of both the 1H and 19F nuclear magnetic resonance (n.m.r.) spectra of a series of hexopyranosyl fluoride derivatives. Some of the 1H spectra were measured at 220 MHz. The 1H spectral parameters define both the configuration and the conformation of each of these derivatives. Study of the 19F n.m.r. parameters revealed several stereospecific dependencies. The 19F chemical shifts depend upon, (a) the orientation of the fluorine substituent with respect to the pyranose ring and, (b) the relative orientation of other substituents attached to the ring; for acetoxy substituents, these configurational dependencies appear to be additive. The vicinal19F–1H coupling constants exhibit a marked angular dependence for which Jtrans = ca. 24 Hz whilst Jgauche = 1.0 to 1.5 Hz for [Formula: see text] and 7.5 to 12.6 Hz for [Formula: see text] The geminal19F–1H couplings depend on the orientation of the substituent at C-2; when this substituent is equatorial JF,H is ca. 53.5 Hz and when it is axial the value is ca. 49 Hz.


Author(s):  
Alexander Glotka ◽  
Vadim Ol’shanetskii

Abstract The purpose of the investigation was to obtain the predictive regression models that help correct the calculation of the mechanical properties of single crystal nickel-based superalloys without conducting prior experiments. The paper considers the influence of alloying elements on their tendency to form phases in foundry nickel-based superalloys. Using the elements influence on the phase formation, the coefficient Kc’ of the ratio of alloying elements for this class of alloys was set for the first time. We have revealed the short correlation of the ratio Kc’ with the dimensional misfit of γ and γ’ crystal lattices. Also, a high probability to predict the misfit for multicomponent nickel systems is shown, which significantly affected the strength properties. The regression models of correlation dependencies on the dimensional γ/γ’- misfit were offered to predict the short-term and long-term limits of the strength of alloys. We determined the operating temperature at which the misfit value should decrease to zero. The structure stability should increase because of the structural stresses minimizing. This has a positive effect on strength and plastic properties.


2015 ◽  
Vol 3 (34) ◽  
pp. 8804-8809 ◽  
Author(s):  
Afzaal Qamar ◽  
Hoang-Phuong Phan ◽  
Jisheng Han ◽  
Philip Tanner ◽  
Toan Dinh ◽  
...  

This communication reports for the first time, the impact of device geometry on the stress-dependent offset voltage of single crystal p-type 3C–SiC four terminal devices.


Sign in / Sign up

Export Citation Format

Share Document