Thermal Annealing Effect on the Thermal and Electrical Properties of Organic Semiconductor Thin Films

MRS Advances ◽  
2016 ◽  
Vol 1 (22) ◽  
pp. 1637-1643 ◽  
Author(s):  
Xinyu Wang ◽  
Boyu Peng ◽  
Paddy Chan

ABSTRACTThe thermal and electrical properties of organic semiconductor are playing critical roles in the device applications especially on the devices with large area. Although the effect may be minor in a single device like field effect transistors, the unwanted waste heat would cause much more severe problems in large-scale devices as the power density will go up significantly. The waste heat would lead to performance degradation or even failure of the devices, and thus a more detailed study on the thermal conductivity and carrier mobility of the organic thin film would be beneficial to predict the limits of the device or design a thermally stable device. Here we explore the thermal annealing effect on the thermal and electrical properties of the small molecule organic semiconductor, dinaphtho[2,3-b:2’,3’-f]thieno[3,2-b]thiophene (DNTT). After the post deposition thermal annealing, the grain size of the film increases and in-plane crystallinity improves while cross-plane crystallinity keeps relatively constant. We demonstrated the cross-plane thermal conductivity is independent of the thermal annealing temperature and high annealing temperature will reduce the space-charge-limited current (SCLC) mobility. When the annealing temperature increase from 24 °C to 140 °C, the field effect mobility shows a gradual increase while the threshold voltage shifts from positive to negative. The different dependence of the SCLC mobility and field effect mobility on the annealing temperature suggest the improvement of the film crystallinity after thermal annealing is not the only dominating effect. Our investigation provides the constructive information to tune the thermal and electrical properties of organic semiconductors.

2005 ◽  
Vol 17 (19) ◽  
pp. NA-NA
Author(s):  
D. M. DeLongchamp ◽  
S. Sambasivan ◽  
D. A. Fischer ◽  
E. K. Lin ◽  
P. Chang ◽  
...  

2012 ◽  
Vol 501 ◽  
pp. 319-323
Author(s):  
Hasan A. Alwi ◽  
Lay S. Ewe ◽  
Zahari Ibrahim ◽  
Noor B. Ibrahim ◽  
Roslan Abd-Shukor

We report the room temperature thermal conductivity κ and thermal diffusivity α of polycrystalline La0.7Ca0.3-xSrxMnO3 for x = 0 to 0.1. The samples were prepared by heating at 1220 and 1320oC. The insulator-metal transition temperature, TIM and thermal diffusivity increased with Sr content. Phonon was the dominant contributor to thermal conductivity and the electronic contribution was less than 1%. Enhancement of electrical conductivity σ and thermal diffusivity for x ≥ 0.08 was observed in both series of samples. The grain size of the samples (28 to 46 µm) does not show any affect on the thermal and electrical properties.


2004 ◽  
Vol 146 (1) ◽  
pp. 43-46 ◽  
Author(s):  
Robert R. Burch ◽  
Yu-Hua Dong ◽  
Curtis Fincher ◽  
Marc Goldfinger ◽  
Pierre E. Rouviere

2013 ◽  
Vol 740-742 ◽  
pp. 703-706
Author(s):  
Michael Grieb ◽  
Stefan Noll ◽  
Dick Scholten ◽  
Martin Rambach

In the present work, we studied the influence of the post-implantation annealing temperature on the performance and oxide reliability of lateral 4H-SiC MOSFETs. The maximum field effect mobility of the MOSFETs at 25°C decreases from 22.4cm2/Vs to 17.2cm2/Vs by increasing annealing temperature from 1600°C to 1800°C. Respectively, the measured meantime to failure is about one order of magnitude higher for the 1700°C annealed sample at an applied field of 8.5MV/cm compared to the 1600°C and 1800°C annealed samples.


2012 ◽  
Vol 1454 ◽  
pp. 245-251
Author(s):  
Junjun Jia ◽  
Yu Muto ◽  
Nobuto Oka ◽  
Yuzo Shigesato

ABSTRACTTa doped SnO2 (TTO) films prepared on quartz glass substrates at 200 °C were annealed in the air to investigate the annealing effect on the structural, the optical, and the electrical properties. It is shown that the annealing for TTO films resulted in beneficial effect on the electrical resistivity by improving the carrier density and Hall mobility. The lowest resistivity was 1.4 × 10-3Ω cm obtained at 400 °C annealing temperature. The scattering mechanism in TTO films was discussed from the optical and electrical perspectives. The variation in Hall mobility with increasing the annealing temperature may be attributed to the scattering from the ionized and neutral impurities in TTO films.


1997 ◽  
Vol 467 ◽  
Author(s):  
S. Kobayashi ◽  
S. Nonomura ◽  
K. Abe ◽  
T. Gotoh ◽  
S. Hirata ◽  
...  

ABSTRACTNano-crystalline GaN (nc-GaN) and hydrogenated nc-GaN (nc-GaN:H) thin films and thin film transistors (TFT) prepared by a reactive sputtering method have been studied. Hydrogen incorporation in nc-GaN film induces localized states at mid-gap energy. Thermal annealing at 400 °C and 600 °C creates mid-gap states which is detectable by electron spin resonance. Further thermal annealing treatment at 800 °C reduces the deep states in nc-GaN and nc-GaN:H. Photoluminescence spectra of the nc-GaN film have two broad peaks at 2.4 eV and 3.2 eV. The source-drain current voltage characteristics of the nc-GaN TFT is demonstrated for the first time. The obtained field effect mobility is 10−4 cm2/V-s. Thermal annealing at 800 °C improves the field effect mobility to 10−2 cm2/V-s.


1937 ◽  
Vol 10 (4) ◽  
pp. 798-800
Author(s):  
P. Schidrowitz ◽  
C. A. Redfarn

Abstract In a previous publication (J. Soc. Chem. Ind., 54, 263T–267T (1935); Rubber Chem. and Tech., 8, 613 (1935)) some particulars were given regarding the production and development of a hard spongy material from chlorinated rubber (British Patent No. 424,561). Thermal and Electrical Properties Some preliminary tests on the thermal and electrical properties of the material have now been carried out, and these serve to confirm the view that expanded chlorinated rubber should prove to be a very good insulating material. Thermal Conductivity.—The details given herewith are taken from a report by the Research Association of British Rubber Manufacturers. The thermal conductivity was determined by comparison with cork, a good insulating material of which the thermal properties are fairly well known. The method used consisted in placing slabs of cellular rubber and of cork each between a pair of aluminum plates, and then interposing between the two sets of plates an electric heating plate made of wire enclosed between sheets of mica. The plates, heater, and sheets of expanded chlorinated rubber material and cork were all of the same size, namely, 20.3 by 10.25 cm. The aluminum plates were 0.625 cm. thick.


2016 ◽  
Vol 4 (19) ◽  
pp. 4143-4149 ◽  
Author(s):  
Vasyl Skrypnychuk ◽  
Nicolas Boulanger ◽  
Victor Yu ◽  
Michael Hilke ◽  
Michael F. Toney ◽  
...  

We report on the effect of the annealing temperature on the crystallization and the electrical properties of the semiconducting polymer poly(3-hexylthiophene) (P3HT) on single layer graphene.


2005 ◽  
Vol 17 (19) ◽  
pp. 2340-2344 ◽  
Author(s):  
D. M. DeLongchamp ◽  
S. Sambasivan ◽  
D. A. Fischer ◽  
E. K. Lin ◽  
P. Chang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document