Atomic Scale Study of Cosi/Si (111) and CoSi2/Si (111) Interfaces

1989 ◽  
Vol 159 ◽  
Author(s):  
A. Catana ◽  
M. Heintze ◽  
P.E. Schmid ◽  
P. Stadelmann
Keyword(s):  
Electron Microscopy ◽  
Electron Beam ◽  
High Resolution ◽  
Orientation Relationship ◽  
Cross Sections ◽  
High Resolution Electron Microscopy ◽  
Atomic Scale ◽  
Type B ◽  
Initial Stage ◽  
Resolution Electron

ABSTRACTHigh Resolution Electron Microscopy (HREM) was used to study microstructural changes related to the CoSi/Si-CoSi/CoSi2/Si-CoSi2/Si transformations. CoSi is found to grow epitaxially on Si with [111]Si // [111]CoSi and < 110 >Si // < 112 >CoSi. Two CoSi non-equivalent orientations (rotated by 180° around the substrate normal) can occur in this plane. They can be clearly distinguished by HRTEM on cross-sections ( electron beam along [110]Si). At about 500°C CoSi transforms to CoSi2. Experimental results show that the type B orientation relationship satisfying [110]Si // [112]CoSi is preserved after the initial stage of CoSi2 formation. At this stage an epitaxial CoSi/CoSi2/Si(111) system is obtained. The atomic scale investigation of the CoSi2/Si interface shows that a 7-fold coordination of the cobalt atoms is observed in both type A and type B epitaxies.

Interfacial Atomic Structures During Cobalt Silicidation

1990 ◽  
Vol 202 ◽  
Author(s):  
A. Catana ◽  
P.E. Schmid
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
High Resolution Electron Microscopy ◽  
Atomic Scale ◽  
Type B ◽  
Cross Sectional ◽  
Atomic Structures ◽  
Resolution Electron ◽  
Predominant Orientation ◽  
Lower Temperature

ABSTRACTHigh Resolution Electron Microscopy (HREM) and image calculations are combined to study microstructural changes related to the CoSi/Si-CoSi/CoSi2/Si-CoSi2/Si transformations. The samples are prepared by UHV e-beam evaporation of Co layers (2 nm) followed by annealing at 300°C or 400°C. Cross-sectional observations at an atomic scale show that the silicidation of Co at the lower temperature yields epitaxial CoSi/Si domains such that [111]Si // [111]CoSi and <110>Si // <112>CoSi. At about 400°C CoSi2 nucleates at the CoSi/Si interface. During the early stages of this chemical reaction, an epitaxial CoSi/CoSi2/Si system is observed. The predominant orientation is such that (021) CoSi planes are parallel to (220) CoSi2 planes, the CoSi2/Si interface being of type B. The growth of CoSi2 is shown to proceed at the expense of both CoSi and Si.

Quantitative high-resolution electron microscopy (HREM) of defects in ordered polymers

1996 ◽  
Vol 54 ◽  
pp. 166-167
Author(s):  
Patricia M. Wilson ◽  
David C. Martin
Keyword(s):  
Electron Microscopy ◽  
Electron Beam ◽  
High Resolution ◽  
Liquid Crystalline ◽  
High Resolution Electron Microscopy ◽  
Polymer Materials ◽  
Scattered Electron ◽  
Crystalline Polymers ◽  
Resolution Electron ◽  
Beam Damage

Efforts in our laboratory and elsewhere have established the utility of low dose high resolution electron microscopy (HREM) for imaging the microstructure of crystalline and liquid crystalline polymers. In a number of polymer systems, direct imaging of the lattice spacings by HREM has provided information about the size, shape, and relative orientation of ordered domains in these materials. However, because of the extent of disorder typical in many polymer microstructures, and because of the sensitivity of most polymer materials to electron beam damage, there have been few studies where the contrast observed in HREM images has been analyzed in a quantitative fashion.Here, we discuss two instances where quantitative information about HREM images has been used to provide new insight about the organization of crystalline polymers in the solid-state. In the first, we study the distortion of the polymer lattice planes near the core of an edge dislocation and compare these results to theories of dislocations in anisotropic and liquid crystalline solids. In the second, we investigate the variations in HREM contrast near the edge of wedge-shaped samples. The polymer used in this study was the diacetylene DCHD, which is stable to electron beam damage (Jc = 20 C/cm2) and highly crystalline. The instrument used in this work was a JEOL 4000 EX HRTEM with a beam blanidng device. More recently, the 4000 EX has been installed with instrumentation for dynamically recording scattered electron beam currents.

X-Ray-Optical Multilayer Structures Studied Using High Resolution Electron Microscopy.

1986 ◽  
Vol 77 ◽  
Author(s):  
Mary Beth Stearns ◽  
Amanda K. Petford-Long ◽  
C.-H. Chang ◽  
D. G. Stearns ◽  
N. M. Ceglio ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Substrate Surface ◽  
High Resolution Electron Microscopy ◽  
Atomic Scale ◽  
Degree Of Crystallinity ◽  
Multilayer Systems ◽  
Layer Width ◽  
X Ray ◽  
Resolution Electron

ABSTRACTThe technique of high resolution electron microscopy has been used to examine the structure of several multilayer systems (MLS) on an atomic scale. Mo/Si multilayers, in use in a number of x-ray optical element applications, and Mo/Si multilayers, of interest because of their magnetic properties, have been imaged in cross-section. Layer thicknesses, flatness and smoothness have been analysed: the layer width can vary by up to 0.6nm from the average value, and the layer flatness depends on the quality of the substrate surface for amorphous MLS, and on the details of the crystalline growth for the crystalline materials. The degree of crystallinity and the crystal orientation within the layers have also been investigated. In both cases, the high-Z layers are predominantly crystalline and the Si layers appear amorphous. Amorphous interfacial regions are visible between the Mo and Si layers, and crystalline cobalt suicide interfacial regions between the Co and Si layers. Using the structural measurements obtained from the HREM results, theoretical x-ray reflectivity behaviour has been calculated. It fits the experimental data very well.

High Resolution Electron Microscopy Observations About The Interface Structure In A Ti/TiN Multilayer Material

1991 ◽  
Vol 238 ◽  
Author(s):  
X. G. Ning ◽  
L. P. Guo ◽  
R. F. Huang ◽  
J. Gong ◽  
B. H. Yu ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Orientation Relationship ◽  
High Resolution Electron Microscopy ◽  
Interface Structure ◽  
Multilayer Material ◽  
Transition Layers ◽  
Transmission Electron ◽  
Resolution Electron ◽  
Specific Orientation

ABSTRACTThe interface structure in a Ti/TiN multilayer material has been investigated by high resolution transmission electron microscopy (HRTEM). It was shown that the α-Ti and β-TiN layers consisted of many cylindrical crystals growing along the close packed directions normal to the surface of a stainless steel. There existed specific orientation relationship at the Ti/TiN interfaces without transition layers: (111)TiN ‖ (001)Ti, [110]TiN ‖ [100]Ti. However there was no such orientation relationship at the Ti/TiN interfaces with TixN (x >1) transition layers.

Orientation Relationship between Fe2M and Martensite in M50NiL Steel

2013 ◽  
Vol 456 ◽  
pp. 533-536
Author(s):  
Yan Zhi Lou
Keyword(s):  
Crystal Structure ◽  
Electron Microscopy ◽  
High Resolution ◽  
Electron Diffraction ◽  
Orientation Relationship ◽  
High Resolution Electron Microscopy ◽  
Lattice Parameters ◽  
Selected Area Electron Diffraction ◽  
Resolution Electron ◽  
Martensite Matrix

In this paper, high resolution electron microscopy (HREM) was used to observe nanosized Fe2M precipitates in M50NiL steel, and crystal structure of which was also investigated by selected area electron diffraction (SAED). At the same time, the orientation relationship between the Fe2M and the martensite matrix was also studied. The results suggested that crystal structure of Fe2M is close-packed hexagonal, and lattice parameters about a=b=0.473nm, c=0.772nm, α=β=90°, γ=120°. The orientation relationship between the nanoprecipitates Fe2M and martensite is and .

Sign in / Sign up

Export Citation Format

Share Document