scholarly journals Using a microheterogeneous model to assess the applicability of ion-exchange membranes in the process of reverse electrodialysis

2021 ◽  
Vol 8 (2) ◽  
pp. 20218205
Author(s):  
A. N. Korzhov ◽  
A. R. Achoh ◽  
S. A. Loza ◽  
E. N. Nosova ◽  
D. V. Davidov ◽  
...  
Keyword(s):  
Ion Exchange ◽  
Open Circuit Potential ◽  
Transport Number ◽  
Storage Conditions ◽  
Open Circuit ◽  
Transport Numbers ◽  
Ion Exchange Membranes ◽  
Reverse Electrodialysis ◽  
Two Samples ◽  
Microheterogeneous Model

This paper shows the possibility of using a microheterogeneous model to describe the properties of ion-exchange membranes and calculate the characteristics of a reverse electrodialyzer from the data obtained. We studied the properties of eight samples of heterogeneous cation exchange membranes (two samples of each type of membrane). The samples differed in the year of issue and storage conditions. It is shown that for heterogeneous ion-exchange membranes MK-40 and MA-41, the samples' properties can differ significantly. The counterions transport numbers calculated within the framework of the microheterogeneous model for Ralex membranes differ insignificantly. The counterion transport number in 1 mol/L sodium chloride solution is 0.96 for Ralex CM and 0.98 ± 0.01 for Ralex AMH. For the MK-40 membrane, the transport number in the same solution is 0.94 ± 0.04, and for the MA-41 membrane, it is 0.85 ± 0.1. The possibility of calculating the transport numbers and predicting the open-circuit voltage based on simple physicochemical measurements allows selecting the best membrane pairs for the reverse electrodialysis process. Comparison of the open-circuit potential value calculated using the obtained transfer numbers with experimental data showed that in the case of using Ralex membranes, the difference between the experimental and calculated values is 2%. The calculated value of the open circuit potential was 0.19 V/membrane pair or 1.69 V for the investigated reverse electrodialyzer with nine pair chambers.

scholarly journals Use of the Microheterogeneous Model to Assess the Applicability of Ion-Exchange Membranes in the Process of Generating Electricity from a Concentration Gradient

Membranes ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 406
Author(s):  
Denis Davydov ◽  
Elena Nosova ◽  
Sergey Loza ◽  
Aslan Achoh ◽  
Alexander Korzhov ◽  
...  
Keyword(s):  
Ion Exchange ◽  
Power Density ◽  
Open Circuit Potential ◽  
Open Circuit ◽  
Transport Numbers ◽  
Ion Exchange Membranes ◽  
Reverse Electrodialysis ◽  
Two Samples ◽  
Microheterogeneous Model ◽  
Experimental Values

The paper shows the possibility of using a microheterogeneous model to estimate the transport numbers of counterions through ion-exchange membranes. It is possible to calculate the open-circuit potential and power density of the reverse electrodialyzer using the data obtained. Eight samples of heterogeneous ion-exchange membranes were studied, two samples for each of the following types of membranes: Ralex CM, Ralex AMH, MK-40, and MA-41. Samples in each pair differed in the year of production and storage conditions. In the work, these samples were named “batch 1” and “batch 2”. According to the microheterogeneous model, to calculate the transport numbers of counterions, it is necessary to use the concentration dependence of the electrical conductivity and diffusion permeability. The electrolyte used was a sodium chloride solution with a concentration range corresponding to the conditional composition of river water and the salinity of the Black Sea. During the research, it was found that samples of Ralex membranes of different batches have similar characteristics over the entire range of investigated concentrations. The calculated values of the transfer numbers for membranes of different batches differ insignificantly: ±0.01 for Ralex AMH in 1 M NaCl. For MK-40 and MA-41 membranes, a significant scatter of characteristics was found, especially in concentrated solutions. As a result, in 1 M NaCl, the transport numbers differ by ±0.05 for MK-40 and ±0.1 for MA-41. The value of the open circuit potential for the Ralex membrane pair showed that the experimental values of the potential are slightly lower than the theoretical ones. At the same time, the maximum calculated power density is higher than the experimental values. The maximum power density achieved in the experiment on reverse electrodialysis was 0.22 W/m2, which is in good agreement with the known literature data for heterogeneous membranes. The discrepancy between the experimental and theoretical data may be the difference in the characteristics of the membranes used in the reverse electrodialysis process from the tested samples and does not consider the shadow effect of the spacer in the channels of the electrodialyzer.

scholarly journals Transport Characteristics of Fujifilm Ion-Exchange Membranes as Compared to Homogeneous Membranes АМХ and СМХ and to Heterogeneous Membranes MK-40 and MA-41

Membranes ◽  
2019 ◽  
Vol 9 (7) ◽  
pp. 84 ◽  
Author(s):  
Sarapulova ◽  
Shkorkina ◽  
Mareev ◽  
Pismenskaya ◽  
Kononenko ◽  
...  
Keyword(s):  
Ion Exchange ◽  
Volume Fraction ◽  
Transport Numbers ◽  
Type I ◽  
Type Ii ◽  
Ion Exchange Membranes ◽  
Electrospinning Method ◽  
Microheterogeneous Model ◽  
First Time

Ion-exchange membranes (IEMs) find more and more applications; the success of an application depends on the properties of the membranes selected for its realization. For the first time, the results of a comprehensive characterization of the transport properties of IEMs from three manufactures (Astom, Japan; Shchekinoazot, Russia; and Fujifilm, The Netherlands) are reported. Our own and literature data are presented and analyzed using the microheterogeneous model. Homogeneous Neosepta AMX and CMX (Astom), heterogeneous MA-41 and MK-40 (Shchekinoazot), and AEM Type-I, AEM Type-II, AEM Type-X, as well as CEM Type-I, CEM Type-II, and CEM Type-X produced by the electrospinning method (Fujifim) were studied. The concentration dependencies of the conductivity, diffusion permeability, as well as the real and apparent ion transport numbers in these membranes were measured. The counterion transport number characterizing the membrane permselectivity increases in the following order: CEM Type-I MA-41 < AEM Type-I < MK-40<CMX CEM Type-II CEM Type-X AEM Type-II < AMX < AEM Type-X. It is shown that the properties of the AEM Type-I and CEM Type-I membranes are close to those of the heterogeneous MA-41 and MK-40 membranes, while the properties of Fujifilm Type-II and Type-X membranes are close to those of the homogeneous AMX and CMX membranes. This difference is related to the fact that the Type-I membranes have a relatively high parameter f2, the volume fraction of the electroneutral solution filling the intergel spaces. This high value is apparently due to the open-ended pores, formed by the reinforcing fabric filaments of the Type-I membranes, which protrude above the surface of these membranes.

scholarly journals The Influence of Concentration and Temperature on the Membrane Resistance of Ion Exchange Membranes and the Levelised Cost of Hydrogen from Reverse Electrodialysis with Ammonium Bicarbonate

Membranes ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 135
Author(s):  
Yash Dharmendra Raka ◽  
Robert Bock ◽  
Håvard Karoliussen ◽  
Øivind Wilhelmsen ◽  
Odne Stokke Burheim
Keyword(s):  
Ion Exchange ◽  
Waste Heat ◽  
Ammonium Bicarbonate ◽  
Operating Efficiency ◽  
Membrane Thickness ◽  
Ion Exchange Membranes ◽  
Reverse Electrodialysis ◽  
Ohmic Resistance ◽  
Production Of Hydrogen ◽  
The Impact

The ohmic resistances of the anion and cation ion-exchange membranes (IEMs) that constitute a reverse electrodialysis system (RED) are of crucial importance for its performance. In this work, we study the influence of concentration (0.1 M, 0.5 M, 1 M and 2 M) of ammonium bicarbonate solutions on the ohmic resistances of ten commercial IEMs. We also studied the ohmic resistance at elevated temperature 313 K. Measurements have been performed with a direct two-electrode electrochemical impedance spectroscopy (EIS) method. As the ohmic resistance of the IEMs depends linearly on the membrane thickness, we measured the impedance for three different layered thicknesses, and the results were normalised. To gauge the role of the membrane resistances in the use of RED for production of hydrogen by use of waste heat, we used a thermodynamic and an economic model to study the impact of the ohmic resistance of the IEMs on hydrogen production rate, waste heat required, thermochemical conversion efficiency and the levelised cost of hydrogen. The highest performance was achieved with a stack made of FAS30 and CSO Type IEMs, producing hydrogen at 8.48× 10−7 kg mmem−2s−1 with a waste heat requirement of 344 kWh kg−1 hydrogen. This yielded an operating efficiency of 9.7% and a levelised cost of 7.80 € kgH2−1.

scholarly journals Transport Characteristics of CJMAED™ Homogeneous Anion Exchange Membranes in Sodium Chloride and Sodium Sulfate Solutions

2021 ◽  
Vol 22 (3) ◽  
pp. 1415
Author(s):  
Veronika Sarapulova ◽  
Natalia Pismenskaya ◽  
Valentina Titorova ◽  
Mikhail Sharafan ◽  
Yaoming Wang ◽  
...  
Keyword(s):  
Ion Exchange ◽  
Anion Exchange ◽  
Volume Fraction ◽  
Exchange Capacity ◽  
Polymer Materials ◽  
Transport Numbers ◽  
Anion Exchange Membranes ◽  
Microheterogeneous Model ◽  
Pass Through ◽  
Pes Membrane

The interplay between the ion exchange capacity, water content and concentration dependences of conductivity, diffusion permeability, and counterion transport numbers (counterion permselectivity) of CJMA-3, CJMA-6 and CJMA-7 (Hefei Chemjoy Polymer Materials Co. Ltd., China) anion-exchange membranes (AEMs) is analyzed using the application of the microheterogeneous model to experimental data. The structure–properties relationship for these membranes is examined when they are bathed by NaCl and Na2SO4 solutions. These results are compared with the characteristics of the well-studied homogenous Neosepta AMX (ASTOM Corporation, Japan) and heterogeneous AMH-PES (Mega a.s., Czech Republic) anion-exchange membranes. It is found that the CJMA-6 membrane has the highest counterion permselectivity (chlorides, sulfates) among the CJMAED series membranes, very close to that of the AMX membrane. The CJMA-3 membrane has the transport characteristics close to the AMH-PES membrane. The CJMA-7 membrane has the lowest exchange capacity and the highest volume fraction of the intergel spaces filled with an equilibrium electroneutral solution. These properties predetermine the lowest counterion transport number in CJMA-7 among other investigated AEMs, which nevertheless does not fall below 0.87 even in 1.0 eq L−1 solutions of NaCl or Na2SO4. One of the reasons for the decrease in the permselectivity of CJMAED membranes is the extended macropores, which are localized at the ion-exchange material/reinforcing cloth boundaries. In relatively concentrated solutions, the electric current prefers to pass through these well-conductive but nonselective macropores rather than the highly selective but low-conductive elements of the gel phase. It is shown that the counterion permselectivity of the CJMA-7 membrane can be significantly improved by coating its surface with a dense homogeneous ion-exchange film.

scholarly journals The permselectivity and water transference number of ion exchange membranes in reverse electrodialysis

2017 ◽  
Vol 523 ◽  
pp. 402-408 ◽  
Author(s):  
A. Zlotorowicz ◽  
R.V. Strand ◽  
O.S. Burheim ◽  
Ø. Wilhelmsen ◽  
S. Kjelstrup
Keyword(s):  
Ion Exchange ◽  
Transference Number ◽  
Ion Exchange Membranes ◽  
Reverse Electrodialysis
Sign in / Sign up

Export Citation Format

Share Document