In a special boiling cell, vapor bubbles are generated at single nucleation sites on top of a 20μm thick stainless steel heating foil. An infrared camera captures the rear side of the heating foil for analyzing the temperature distribution. The bubble shape is recorded through side windows with a high-speed camera. Global measurements were conducted, with the pure fluids FC-84 and FC-3284 and with its binary mixtures of 0.25, 0.5, and 0.75mole fraction. The heat transfer coefficient (HTC) in a binary mixture is less than the HTC in either of the single component fluid alone. Applying the correlation of Schlünder showed good agreement with the measurements (1982, “Über den Wärmeübergang bei der Blasenverdampfung von Gemischen,” Verfahrenstechnik, 16(9), pp. 692–698). Furthermore, local measurements were arranged with high lateral and temporal resolution for single bubble events. The wall heat flux was computed and analyzed, especially at the three-phase-contact line between liquid, vapor, and heated wall. The bubble volume and the vapor production rate were also investigated. For pure fluids, up to 50–60% of the latent heat flows through the three-phase-contact region. For mixtures, this ratio is clearly reduced and is about 35%.
Experiments on the Capillary Condensation/Evaporation Hysteresis of Pure Fluids and Binary Mixtures in Cylindrical Nanopores