A Novel Method to Construct Capillary Pressure Curves by Using NMR Log Data and Its Application in Reservoir Evaluation

2008 ◽  
Author(s):  
Liang Xiao ◽  
Zhao ming Chen ◽  
Yun chao Yuan
Keyword(s):  
Capillary Pressure ◽  
Log Data ◽  
Reservoir Evaluation ◽  
Novel Method ◽  
Capillary Pressure Curves

A Novel Method to Construct Capillary Pressure Curves by Using NMR Log Data and Its Application in Reservoir Evaluation

2009 ◽  
Author(s):  
Chong Zhang ◽  
Liang Xiao ◽  
Zhi-qiang Mao ◽  
Zhong-chun Sun ◽  
Xing-ping Luo
Keyword(s):  
Capillary Pressure ◽  
Log Data ◽  
Reservoir Evaluation ◽  
Novel Method ◽  
Capillary Pressure Curves

Construction of synthetic capillary pressure curves from the joint use of NMR log data and conventional well logs

2013 ◽  
Vol 111 ◽  
pp. 50-58 ◽  
Author(s):  
Maede Eslami ◽  
Ali Kadkhodaie-Ilkhchi ◽  
Yousef Sharghi ◽  
Naser Golsanami
Keyword(s):  
Capillary Pressure ◽  
Well Logs ◽  
Log Data ◽  
Capillary Pressure Curves

Capillary Equilibrium in Porous Materials

1965 ◽  
Vol 5 (01) ◽  
pp. 15-24 ◽  
Author(s):  
Norman R. Morrow ◽  
Colin C. Harris
Keyword(s):  
Mass Transfer ◽  
Fluid Flow ◽  
Porous Materials ◽  
Capillary Pressure ◽  
Chemical Engineering ◽  
Fluid Distribution ◽  
Bulk Fluid ◽  
Fluid Saturation ◽  
Capillary Pressure Curves ◽  
The Relationship

Abstract The experimental points which describe capillary pressure curves are determined at apparent equilibria which are observed after hydrodynamic flow has ceased. For most systems, the time required to obtain equalization of pressure throughout the discontinuous part of a phase is prohibitive. To permit experimental points to be described as equilibria, a model of capillary behavior is proposed where mass transfer is restricted to bulk fluid flow. Model capillary pressure curves follow if the path described by such points is independent of the rate at which the saturation was changed to attain a capillary pressure point. A modified suction potential technique is used to study cyclic relationships between capillary pressure and moisture content for a porous mass. The time taken to complete an experiment was greatly reduced by using small samples. Introduction Capillary retention of liquid by porous materials has been investigated in the fields of hydrology, soil science, oil reservoir engineering, chemical engineering, soil mechanics, textiles, paper making and building materials. In studies of the immiscible displacement of one fluid by another within a porous bed, drainage columns and suction potential techniques have been used to obtain relationships between pressure deficiency and saturation (Fig. 1). Except where there is no hysteresis of contact angle and the solid is of simple geometry, such as a tube of uniform cross section, there is hysteresis in the relationship between capillary pressure and saturation. The relationship which has received most attention is displacement of fluid from an initially saturated bed (Fig. 1, Curve Ro), the final condition being an irreducible minimum fluid saturation Swr. Imbibition (Fig. 1, Curve A), further desaturation (Fig. 1, Curve R), and intermediate scanning curves have been studied to a lesser but increasing extent. This paper first considers the nature of the experimental points tracing the capillary pressure curves with respect to the modes and rates of mass transfer which are operative during the course of measurement. There are clear indications that the experimental points which describe these curves are obtained at apparent equilibria which are observed when viscous fluid flow has ceased; and any further changes in the fluid distribution are the result of much slower mass transfer processes, such as diffusion. Unless stated otherwise, this discussion applies to a stable packing of equal, smooth, hydrophilic spheres supported by a suction plate with water as the wetting phase and air as the nonwetting phase. SPEJ P. 15ˆ

Sign in / Sign up

Export Citation Format

Share Document