scholarly journals Long-Term Reliability Characteristics of OLED Panel and Luminaires for General Lighting Applications

2020 ◽  
Vol 11 (1) ◽  
pp. 74
Author(s):  
Jeungmo Kang ◽  
Yoonhee Cho ◽  
Woojin Jang
Keyword(s):  
Light Emitting Diode ◽  
Light Output ◽  
Color Temperature ◽  
Light Sources ◽  
Operating Voltage ◽  
Light Emitting ◽  
Organic Light Emitting Diode ◽  
Reliability Characteristics ◽  
Color Rendering

Organic light-emitting diode is one of the future-proof solid-state-based lighting sources. OLED shows great aesthetic advantages and good color quality without glare. Moreover OLED is a kind of surface light sources naturally. There are some studies on the long-term reliability characteristics of OLED light source. However, these studies focused on the light output degradation of OLED light sources mainly. In this paper, we have investigated the long-term reliability characteristics of OLED panel and luminaires in terms of lumen maintenance, correlated color temperature, color rendering index, and operating voltage. Total twelve OLED panels with four different kinds and six OLED luminaires with two different kinds were analyzed up to six thousand hours and analyzed for the general lighting applications.

scholarly journals Light Output, Thermal Properties, and Reliability of Using Glass Phosphors in WLED Packages

Coatings ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 239
Author(s):  
Chin-Chuan Huang ◽  
Tsung-Han Weng ◽  
Chun-Liang Lin ◽  
Yan-Kuin Su
Keyword(s):  
Thermal Properties ◽  
Yttrium Aluminum Garnet ◽  
Saturated Vapor ◽  
Light Output ◽  
Junction Temperature ◽  
Color Temperature ◽  
Light Emitting ◽  
Chromaticity Coordinate ◽  
White Light Emitting Diodes ◽  
Color Rendering

White-light-emitting diodes (WLED) based on yttrium aluminum garnet (YAG) phosphors sintered with glass (PiG) and with silicone (PiS) are compared in terms of their light properties, temperature properties and reliability.The complete YAG phosphor was doped with an encapsulant traditional WLED (PiS WLED), and the WLED was covered with PiG (PiG WLED). PiG was made by sintering glass powder and YAG phosphor at the ratio of 87:13 (%), and the correlated color temperature (CCT) was 5564 K. The CCT of the PiG WLED with the YAG doping concentration of 8.5 wt.% approximated 5649 K. The initial light output of the PiG WLED was 6.4% lower than that of the PiS WLED. Under 1008 h and 350 mA aging, PiG WLED and PiS WLED’ light output, CCT and color rendering index variation rates were all within 1%. In the saturated vapor-pressure test, no sample exhibited red ink infiltration, light nor peeling between the encapsulant and the lead-frame. Compared with that of the PiS WLED, the junction temperature of the PiG WLED reduced from 88.4 °C to 81.3 °C. Thermal resistance dropped from 37.4 °C/W to 35.6 °C/W. The PiG WLED presented a better CIE (Commission Internationale de l’Eclairage) 1931 chromaticity coordinate (x,y) concentration and thermal properties than the PiS WLED.

scholarly journals Reduction of operating voltage in organic light-emitting diode by corrugated photonic crystal structure

2004 ◽  
Vol 85 (23) ◽  
pp. 5769-5771 ◽  
Author(s):  
Masayuki Fujita ◽  
Tetsuya Ueno ◽  
Kuniaki Ishihara ◽  
Takashi Asano ◽  
Susumu Noda ◽  
...  
Keyword(s):  
Crystal Structure ◽  
Photonic Crystal ◽  
Light Emitting Diode ◽  
Photonic Crystal Structure ◽  
Operating Voltage ◽  
Light Emitting ◽  
Organic Light Emitting Diode ◽  
Organic Light

Cohosts with efficient host-to-emitter energy transfer for stable blue phosphorescent organic light-emitting diodes

2021 ◽  
Author(s):  
Soo-Ghang Ihn ◽  
Eun Suk Kwon ◽  
Yongsik Jung ◽  
Jong Soo Kim ◽  
Sungho Nam ◽  
...  
Keyword(s):  
Energy Transfer ◽  
High Performance ◽  
Light Emitting Diode ◽  
Organic Light Emitting Diodes ◽  
Operating Voltage ◽  
Light Emitting ◽  
Organic Light Emitting Diode ◽  
Organic Light ◽  
Low Efficiency ◽  
Blue Phosphorescent

We present a high-performance blue phosphorescent organic light-emitting diode exhibiting a low operating voltage (4.1 V), high external quantum efficiency (23.4%, at 500 cd m-2) with a low efficiency roll-off...

scholarly journals Chromaticity Study of Curcumin Dye Extracted from Curcuma longa L. Using for UV Light down Conversion for White Light Emitting Diode

2019 ◽  
Vol 290 ◽  
pp. 183-189
Author(s):  
Mahmood Al Shafouri ◽  
Naser Mahmoud Ahmed ◽  
Zainuriah Hassan ◽  
Munirah Abdullah Almessiere
Keyword(s):  
White Light ◽  
Uv Light ◽  
Light Emitting Diode ◽  
Curcuma Longa ◽  
Color Temperature ◽  
Light Emitting ◽  
Chromaticity Coordinates ◽  
Major Factors ◽  
Color Rendering ◽  
Down Conversion

In thus study, Turmeric phosphor dye was extracted from Curcuma Longa L. via a simple technique using silica gel. The phosphor was used for light down-conversion of UV light for the manufacture white light emitting diode (WLED). The UV-LED was analyzed over 395nm wavelengths. The characteristics of the white light chromaticity were controlled by tuning the current and phosphor concentration. An optimum color rendering index (CRI) value of 63.4 was obtained. The chromaticity coordinates (CIE) and correlated color temperature (CCT) were measured for various currents and phosphor concentrations. The white phosphor exhibited CIE value of 0.355,0.338 and CCT of 4567 K. The concentration of phosphor and amount of applied current were confirmed to be major factors that control the intensity of white light emitted from the sample, where CIE and CRI of the emitted light steadily increased with the concentration of phosphor and current. Thus, phosphor concentration has a critical effect on conversion efficiency. Key words: Turmeric, phosphor, WLED, curcumin

scholarly journals Reflectance-Based Organic Pulse Meter Sensor for Wireless Monitoring of Photoplethysmogram Signal

Biosensors ◽  
2019 ◽  
Vol 9 (3) ◽  
pp. 87 ◽  
Author(s):  
Fahed Elsamnah ◽  
Anubha Bilgaiyan ◽  
Muhamad Affiq ◽  
Chang-Hoon Shim ◽  
Hiroshi Ishidai ◽  
...  
Keyword(s):  
Power Consumption ◽  
Structural Design ◽  
Signal To Noise Ratio ◽  
Light Emitting Diode ◽  
Light Emitting ◽  
Organic Light Emitting Diode ◽  
Wireless Monitoring ◽  
Organic Light ◽  
Reduced Power Consumption

This paper compares the structural design of two organic biosensors that minimize power consumption in wireless photoplethysmogram (PPG) waveform monitoring. Both devices were fabricated on the same substrate with a red organic light-emitting diode (OLED) and an organic photodiode (OPD). Both were designed with a circular OLED at the center of the device surrounded by OPD. One device had an OLED area of 0.06 cm2, while the other device had half the area. The gap distance between the OLED and OPD was 1.65 mm for the first device and 2 mm for the second. Both devices had an OPD area of 0.16 cm2. We compared the power consumption and signal-to-noise ratio (SNR) of both devices and evaluated the PPG signal, which was successfully collected from a fingertip. The reflectance-based organic pulse meter operated successfully and at a low power consumption of 8 µW at 18 dB SNR. The device sent the PPG waveforms, via Bluetooth low energy (BLE), to a PC host at a maximum rate of 256 kbps data throughput. In the end, the proposed reflectance-based organic pulse meter reduced power consumption and improved long-term PPG wireless monitoring.

Efficient very-high color rendering index organic light-emitting diode

2011 ◽  
Vol 12 (5) ◽  
pp. 865-868 ◽  
Author(s):  
Jwo-Huei Jou ◽  
Shih-Ming Shen ◽  
Chuen-Ren Lin ◽  
Yi-Shan Wang ◽  
Yi-Chieh Chou ◽  
...  
Keyword(s):  
Light Emitting Diode ◽  
Light Emitting ◽  
Organic Light Emitting Diode ◽  
Organic Light ◽  
Color Rendering Index ◽  
Color Rendering ◽  
Very High

Modeling and Analysis of Organic Light Emitting Diode with Thin Film Anti-Reflective Coatings

2020 ◽  
Vol 15 (4) ◽  
pp. 425-431
Author(s):  
B. M. Chaya ◽  
Prasant Kumar Pattnaik ◽  
K. Narayan
Keyword(s):  
Power Efficiency ◽  
Light Emitting Diode ◽  
Fdtd Method ◽  
Light Output ◽  
Single Layer ◽  
Light Emitting ◽  
Organic Light Emitting Diode ◽  
Reflective Coating ◽  
Organic Light ◽  
Reflective Coatings

The effects of anti-reflective coatings (ARC) on organic light emitting diode (OLED) optical characteristics are reported in this paper. The light output produced from the OLED is not 100%. But the emitted light is trapped due to various Modes. The losses at the glass air substrate interfaces of an OLED are addressed in this work. The Anti-Reflective coatings increase the light output by reducing OLED reflections at the interface between glass and air. The Finite Difference Time Domain (FDTD) method and the Fresnel theory have been used to design the device and study the effects on OLED of the Single Layer Anti-Reflective Coating (SLAR) and Double Layer Anti-Reflective Coating (DLAR). The thicknesses and refractive indices of the layers of the anti-reflective coatings were optimized. We also compared the light out coupling power efficiency of the SLAR coated OLED with that of an OLED with a DLAR coating and also with Conventional OLED. The results show that the enhancement in light output efficiency of the DLAR coated OLED was slightly higher than that of the SLAR coated OLED.

A Novel Voltage-Programmed Pixel Circuit with Poly-Si TFTs for AMOLED Displays

2018 ◽  
Vol 27 (14) ◽  
pp. 1850221
Author(s):  
Zunkai Huang ◽  
Li Tian ◽  
Hui Wang ◽  
Songlin Feng
Keyword(s):  
Threshold Voltage ◽  
Light Emitting Diode ◽  
Active Matrix ◽  
Light Emitting ◽  
Organic Light Emitting Diode ◽  
Electrical Stress ◽  
Organic Light ◽  
Pixel Circuit ◽  
Display Performance

In this paper, we propose a novel voltage-programmed pixel circuit with polysilicon thin–flim transistors (poly-Si TFTs) for active matrix organic light-emitting diode (AMOLED) displays, which consists of one programming transistor, one driving transistor, four switching transistors and two storage capacitors, respectively. Specifically, the proposed pixel circuit is able to not only efficiently compensate for the threshold variations of TFTs, but also largely suppresses the electrical degradations of the devices caused by the long-term electrical stress. Moreover, the mobility variation of the driving transistor can be compensated as well. The simulation has been performed by HSPICE, and results indicate that the average values of nonuniformities are, respectively, 7.3% as the threshold-voltage varies by [Formula: see text][Formula: see text]V and 2.1%, as the mobility of the driving transistor varies by [Formula: see text]%, both of which are much lower than that of the conventional two-transistor and one-capacitor (2T1C) pixel. Furthermore, since the OLED is reverse-biased during the nonemission phases, the lifetime of OLED will be extended naturally. As a consequence, the proposed pixel circuit can substantially improve the display performance.

Sign in / Sign up

Export Citation Format

Share Document