Three-Dimensional Dynamic Behavior of Embankment on Liquefiable Ground

In recent years, there has been serious damage to embankments on liquefied ground because of large earthquakes. To understand such damage, many two-dimensional shaking table model tests have been performed, in both gravitational and centrifugal fields, to investigate the dynamic behavior and residual displacement of embankments and river dikes on liquefiable ground. In recent years, three-dimensional numerical analysis has been used in practical design because it is difficult to consider the complex dynamic behaviors of three-dimensional embankments and the surrounding liquefied ground in a two-dimensional analysis. However, there are only a limited number of cases in which the applicability of three-dimensional analysis has been validated based on comparisons with true values derived from model tests or data from actual disasters. Therefore, in this study, a series of shaking table tests were conducted to investigate the seismic behavior of a three-dimensional embankment on liquefiable ground. In addition, the effect of the shaking direction on the seismic behavior of the embankment was evaluated. The experiment revealed that the residual deformation and its dominant direction were significantly affected by the three-dimensional shape and total weight of the embankment, not by the shaking direction. This result indicates that the influence of the three-dimensional shape of the embankment on the deformation behavior cannot be ignored, and that the influence should be properly evaluated in seismic design.

Seismic performance of a continuous bridge with winding rope device activated by a fluid viscous damper

The seismic requirements of piers with fixed bearings (the fixed pier) for continuous girder bridges are relatively high, while the potential seismic capabilities of piers with sliding bearings (the sliding piers) are not fully utilized. To solve this contradiction, a new type of winding rope shock absorption device activated by a fluid viscous damper (WRD-D) was proposed. The WRD-D was installed on the top of the sliding piers, and the both ends of a fluid viscous damper were connected to the superstructure by winding ropes. During an earthquake, the damping force rises with the increase of relative speed between the sliding piers and the superstructure, activating the WRD-D and producing large frictional resistance, subsequently causing the sliding piers and the fixed pier to bear the seismic load cooperatively. In this study, the working mechanism of the WRD-D was researched. The shaking table test of a scaled continuous girder bridge model employing the WRD-D was conducted. The test results reveal that the WRD-D can effectively reduce the seismic requirements of the fixed pier and the superstructure displacements.

Numerical Modelling of Underground Water Pipelines exposed to Seismic Loading

The essential factor that must get the interest by the engineers during the primary design stage of underground pipes is understanding mechanism of damage during earthquakes. The attention during design period increased due to the increment of seismic catastrophes throughout the few past decades. Therefore, finite element procedure was used for studying the seismic performance of buried pipes. PLAXIS-2D program was using for simulating the seismic performance of buried pipes using earthquake motion of single frequency. The response of both seismic vertical displacement, and acceleration of the buried pipe were simulated. The experiments of shaking table for two models of buried pipe in dry case that surrounded with sand and gravel were compared with numerical simulation results. According to the obtained results, the amplification of seismic wave raised considerably from the buried pipe base to the pipe crown, the biggest amplification occurred in the highest point of the pipe model. It can be noticed that Plaxis-2D software provides an accurate method for the prediction of seismic behaviour of buried pipe due to the obvious compatibility between the results of experiments and numerical simulation.

An Arc-Consistent Viscous-Spring Artificial Boundary for Numerical Analysis of Seismic Response of Underground Structures

A new arc-consistent viscous-spring artificial boundary (ACVAB) was proposed by changing a traditional flat artificial boundary based on the theory of viscous-spring artificial boundaries. Through examples, the concept underpinning the establishment and specific setting of the boundary in the finite element software were described. Through comparison with other commonly used artificial boundaries in an example for near-field wave analysis using the two-dimensional (2D) half-space model, the reliability of the ACVAB was verified. Furthermore, the ACVAB was used in the numerical analysis of the effects of an earthquake on underground structures. The results were compared with the shaking table test results on underground structures. On this basis, the applicability of the ACVAB to a numerical model of seismic response of underground structures was evaluated. The results show that the boundary is superior to common viscous-spring boundaries in terms of accuracy and stability, and therefore, it can be used to evaluate radiation damping effects of seismic response of underground structures and is easier to use.