Numerical simulation of the effects of a suction line heat exchanger on vapor compression refrigeration cycle performance

2012 ◽  
Vol 26 (4) ◽  
pp. 1213-1226 ◽  
Author(s):  
Ji Hwan Jeong ◽  
Sang-Goo Park ◽  
Debasish Sarker ◽  
Keun Sun Chang
Keyword(s):  
Numerical Simulation ◽  
Heat Exchanger ◽  
Cycle Performance ◽  
Refrigeration Cycle ◽  
Vapor Compression ◽  
Vapor Compression Refrigeration Cycle ◽  
Suction Line ◽  
Vapor Compression Refrigeration ◽  
Suction Line Heat Exchanger

scholarly journals THEORETICAL AND EXPERIMENTAL ANALYSIS OF A VAPOR-COMPRESSION REFRIGERATION CYCLE WITH A HEAT EXCHANGER BETWEEN THE SUCTION AND LIQUID LINES

2019 ◽  
Vol 18 (2) ◽  
pp. 19
Author(s):  
L. S. Santana ◽  
J. Castro ◽  
L. M. Pereira
Keyword(s):  
Heat Exchanger ◽  
Experimental Analysis ◽  
Thermodynamic Cycle ◽  
Electrical Energy ◽  
Coefficient Of Performance ◽  
Refrigeration Cycle ◽  
Vapor Compression ◽  
Vapor Compression Refrigeration Cycle ◽  
Vapor Compression Refrigeration ◽  
Liquid Heat

Vapor-compression refrigeration systems require a significant amount of electrical energy. Therefore, there is a need for finding efficient ways of operating this equipment, reducing their energy consumption. The use of heat exchangers between the suction line and the liquid line can produce a better performance of the thermodynamic cycle, as well as reduce it. The present work aims at an experimental analysis of the suction/liquid heat exchanger present in a freezer running with refrigerant fluid R-134a. Three different scenarios were used in order to evaluate the thermal performance of the refrigeration cycle. The first scenario was the conventional freezer set up to collect the required data for further comparison. Moreover, the second and third scenarios were introduced with a 20 cm and 40 cm suction/liquid heat exchanger, respectively, into the system. From the experiments, it was observed that the heat exchange does not significantly affect the coefficient of performance (COP) of the freezer. It was concluded from this work that the best scenario analyzed was the 20 cm suction/liquid heat exchanger where most of the thermodynamic properties were improved, one of them being the isentropic efficiency.

scholarly journals Energy Analysis of Vapor Compression Refrigeration Cycle Using a New Generation Refrigerants with Low Global Warming Potential

2021 ◽  
Vol 87 (2) ◽  
pp. 106-117
Author(s):  
Rabah Touaibi ◽  
Hasan Koten
Keyword(s):  
Global Warming ◽  
Global Warming Potential ◽  
Energy Analysis ◽  
Coefficient Of Performance ◽  
Cycle Performance ◽  
Refrigeration Cycle ◽  
Vapor Compression ◽  
Vapor Compression Refrigeration Cycle ◽  
Vapor Compression Refrigeration ◽  
Low Global Warming Potential

An energy analysis study carried out on a vapor compression refrigeration cycle using refrigerants with low global warming potential (GWP) of the Hydro-Fluoro-Olefin (HFO) type, in particular R1234yf and R1234ze fluids to replace HFC refrigerants . Computer code was developed using software for solving engineering equations to calculate performance parameters; for this, three HFC type fluids (R134a, R404A and R410A) were selected for a comparative study. The results showed that R1234ze is the best refrigerant among those selected for the mechanical vapor compression refrigeration cycle. The thermodynamic analysis showed the effect of the evaporator temperature (-22 °C to 10 °C) and the condenser temperature (30 °C to 50 °C) on the steam cycle performance. Compression refrigeration, including the coefficient of performance. The results showed that the HFO-R1234ze with low GWP gives the best coefficient of performance of 3.14 close to that of the R134a fluid (3.17). In addition, R1234ze is considered an alternative fluid to R134a for their ecological properties.

Application of Suction Line Heat Exchanger on Adsorption Refrigeration System

2004 ◽  
Vol 126 (1) ◽  
pp. 671-673 ◽  
Author(s):  
Wen Wang ◽  
Tianfei Qu ◽  
Zhonghua Li ◽  
Ruzhu Wang
Keyword(s):  
Experimental Data ◽  
Heat Exchanger ◽  
Cooling Capacity ◽  
Cycle Performance ◽  
Refrigeration Cycle ◽  
Refrigeration System ◽  
Adsorption Refrigeration ◽  
Suction Line ◽  
Suction Line Heat Exchanger ◽  
Condensed Liquid

Quantitative thermodynamic analysis demonstrates that an adsorption refrigeration cycle could get higher cycle performance by employing a suction line heat exchanger (SLHX). Low temperature evaporated gas not only helps to cool down the adsorbent, it further increases the cooling output by recovering heat and cooling the condensed liquid. Experimental data also verifies that a SLHX recovers heat from the evaporated gas and helps the evaporator to provide higher cooling capacity.

scholarly journals Parametric analysis of a combined ejector-vapor compression refrigeration cycle

2020 ◽  
Vol 15 (3) ◽  
pp. 398-408
Author(s):  
I Ouelhazi ◽  
Y Ezzaalouni ◽  
L Kairouani
Keyword(s):  
Current Model ◽  
Operating Conditions ◽  
Coefficient Of Performance ◽  
Refrigeration Cycle ◽  
Vapor Compression ◽  
Refrigeration System ◽  
Entrainment Ratio ◽  
Constant Area ◽  
Vapor Compression Refrigeration Cycle ◽  
Vapor Compression Refrigeration

Abstract From the last few years, the use of efficient ejector in refrigeration systems has been paid a lot of attention. In this article a description of a refrigeration system that combines a basic vapor compression refrigeration cycle with an ejector cooling cycle is presented. A one-dimensional mathematical model is developed using the flow governing thermodynamic equations based on a constant area ejector flow model. The model includes effects of friction at the constant-area mixing chamber. The current model is based on the NIST-REFPROP database for refrigerant property calculations. The model has basically been used to determine the effect of the ejector geometry and operating conditions on the performance of the whole refrigeration system. The results show that the proposed model predicts ejector performance, entrainment ratio and the coefficient of performance of the system and their sensitivity to evaporating and generating temperature of the cascade refrigeration cycle. The simulated performance has been then compared with the available experimental data from the literature for validation.

Sign in / Sign up

Export Citation Format

Share Document