Evaluation of corrosion characteristics of aluminum alloys in the bio-ethanol gasoline blended fuel by 2-electrode electrochemical impedance spectroscopy

Fuel ◽  
2014 ◽  
Vol 126 ◽  
pp. 26-31 ◽  
Author(s):  
In-Jun Park ◽  
Tae-Heum Nam ◽  
Jin-Ho Kim ◽  
Jung-Gu Kim
2016 ◽  
Vol 1815 ◽  
Author(s):  
C. Rodríguez-Rivera ◽  
J.A. García-Hinojosa ◽  
F.J. Rodríguez-Gómez

ABSTRACTThe aim of this study is to compare the corrosion rate of aluminum alloys for ornamental pieces. Three Fe/Cu relationships were tested in order to improve hardness and brightness in aluminum pieces since these alloys are used in the making of ornamental pieces. The variation on Fe/Cu content could result in modification on corrosion rate, since a metallographic characterization must be carried out identifying the presence of intermetallic phases. The presence of these elements could result in increasing corrosion rate, or even in modification of corrosion morphology, so localized corrosion could be expected.The assessment of corrosion rate was carried out in saline media, since chlorides are ions that promote localized corrosion. Electrochemical techniques (polarization curves and Tafel plots) were used in order to evaluate the attack in aluminum pieces; electrochemical impedance spectroscopy was also employed with voltage amplitude of 10 mV rms, and a frequency range from 10,000 Hz to 0.01 Hz. A typical three electrodes cell was used, exposing an area of one cm2. Before polarization, open circuit potential was monitored for an hour looking for a steady state. All conditions were tested for triplicate.The behavior of open circuit potential vs. time, and polarization curves was analyzed; a corrosion mechanism is proposed according to the electrochemical control. Polarization rate was calculated by using Tafel plots and, an electrochemical impedance spectroscopy analysis by using equivalent electric circuits is shown. Electrochemical impedance will yield information about corrosion morphology that is backed with microscopic inspection.The objective of this study is to compare the corrosion rate of aluminum alloys for ornamental pieces in order to determine the effect of the relationship Fe/Cu on the corrosion mechanism in aluminum parts for ornamental pieces.


2019 ◽  
Vol 29 (1) ◽  
pp. 73-80 ◽  
Author(s):  
Ricardo Orozco-Cruz ◽  
Ricardo Galvan-Martinez ◽  
Enrique A. Martínez ◽  
Imelda Fernandez-Gómez

Sign in / Sign up

Export Citation Format

Share Document