scholarly journals Oblique internal-wave chain resonance over seabed corrugations

2017 ◽  
Vol 833 ◽  
pp. 538-562
Author(s):  
Louis-Alexandre Couston ◽  
Yong Liang ◽  
Mohammad-Reza Alam

Here we show that monochromatic long-crested corrugations on an otherwise flat seafloor can coherently scatter the energy of an oblique incident internal wave to multiple multi-directional higher-mode internal waves via a series of resonant interactions. We demonstrate that a resonance between seabed corrugations and a normally or slightly oblique incident internal wave results in a series of follow-up resonant interactions, which take place between the same corrugations and successively resonated shorter waves. A chain resonance of internal waves that carries energy to small scales is thus obtained, and we find that the Richardson number decreases by several orders of magnitude over the corrugated patch. If the incidence angle is large, and the incident wave perfectly satisfies a resonance condition with the topography, it turns out that not many higher-mode resonance or near-resonance conditions can be satisfied, such that energy stays confined within the first few modes. Nevertheless, if the incident waves are sufficiently detuned from satisfying a perfect resonance condition with the seabed corrugations, then we show that this frequency detuning may balance off the large detuning due to oblique incidence, leading to a chain resonance that again carries energy to small scales. The evolution of the incident and resonated wave amplitudes is predicted from the envelope equation for internal waves over resonant seabed topography in a three-dimensional rotating fluid, which we derive considering the Boussinesq and $f$-plane approximations with $f$ the Coriolis frequency, linear density stratification and small-amplitude corrugations. Our results suggest that topographic features on the ocean floor with a well-defined dominant wavenumber vector, through the chain resonance mechanism elucidated here, may play a more important role than previously thought in the enhancement of diapycnal mixing and energy dissipation.

2013 ◽  
Vol 732-733 ◽  
pp. 417-420
Author(s):  
Xiao Chao Fan ◽  
Rui Jing Shi ◽  
Feng Ting Li ◽  
Bo Wei ◽  
Yue Dang

The numerical simulations of the flow around different pillars acted by the cnoidal internal waves have been made by building numerical wave flume based on FLUENT software. The cnoidal internal wave was created by using the push-pedal method, and the free surface was tracked by using VOF (volume of fluid) method. The three-dimensional different amplitude and period cnoidal internal waves were simulated. The inertia force and viscous force trends were analyzed, and for different pillars the total wave force were compared. There were some significance for stress analysis of the offshore terminal pillars. The converted wave force could alternative and treatment problems about square columns.


2020 ◽  
Vol 28 (03) ◽  
pp. 1950013
Author(s):  
Alexey Shmelev ◽  
Ying-Tsong Lin ◽  
James Lynch

Crossing internal wave trains are commonly observed in continental shelf shallow water. In this paper, we study the effects of crossing internal wave structures on three-dimensional acoustic ducts with both theoretical and numerical approaches. We show that, depending on the crossing angle, acoustic energy, which is trapped laterally between internal waves of one train, can be either scattered, cross-ducted or reflected by the internal waves in the crossing train. We describe the governing physics of these effects and illustrate them for selected internal wave scenarios using full-field numerical simulations.


2018 ◽  
Vol 845 ◽  
pp. 203-225 ◽  
Author(s):  
G. Pillet ◽  
E. V. Ermanyuk ◽  
L. R. M. Maas ◽  
I. N. Sibgatullin ◽  
T. Dauxois

We study experimentally the propagation of internal waves in two different three-dimensional (3D) geometries, with a special emphasis on the refractive focusing due to the 3D reflection of obliquely incident internal waves on a slope. Both studies are initiated by ray tracing calculations to determine the appropriate experimental parameters. First, we consider a 3D geometry, the classical set-up to get simple, two-dimensional (2D) parallelogram-shaped attractors in which waves are forced in a direction perpendicular to a sloping bottom. Here, however, the forcing is of reduced extent in the along-slope, transverse direction. We show how the refractive focusing mechanism explains the formation of attractors over the whole width of the tank, even away from the forcing region. Direct numerical simulations confirm the dynamics, emphasize the role of boundary conditions and reveal the phase shifting in the transverse direction. Second, we consider a long and narrow tank having an inclined bottom, to simply reproduce a canal. In this case, the energy is injected in a direction parallel to the slope. Interestingly, the wave energy ends up forming 2D internal wave attractors in planes that are transverse to the initial propagation direction. This focusing mechanism prevents indefinite transmission of most of the internal wave energy along the canal.


2012 ◽  
Vol 201-202 ◽  
pp. 503-507
Author(s):  
David O. Manyanga ◽  
Wen Yang Duan

The influence of internal waves is very important in the Engineering Analysis, Design and Optimization. To study the internal wave properties, we model a two-layer fluid and generalize to multiple layers. In a two-layer fluid with the upper layer having a free surface, there exist two modes of waves propagating due to the free surface and the interface. This is due to the density difference in the vertical direction of the water, due to the variation in salinity and temperature where waves from underwater structures are of importance. In this case the fluid is assumed to be non viscous, incompressible and the flow is non rotational. On the other hand, there is need for appropriate Green functions to analyze these properties. In this paper, we use the three dimensional Green functions for a stationary oscillating source to study the internal wave characteristics. Some of the behavior studied in this work includes effects of internal waves on the surface and internal wave amplitudes. Further, an investigation of the influence of internal waves on the wave length, frequency and period is made.


2019 ◽  
Vol 485 (4) ◽  
pp. 428-433
Author(s):  
V. G. Baydulov ◽  
P. A. Lesovskiy

For the symmetry group of internal-wave equations, the mechanical content of invariants and symmetry transformations is determined. The performed comparison makes it possible to construct expressions for analogs of momentum, angular momentum, energy, Lorentz transformations, and other characteristics of special relativity and electro-dynamics. The expressions for the Lagrange function are defined, and the conservation laws are derived. An analogy is drawn both in the case of the absence of sources and currents in the Maxwell equations and in their presence.


Sign in / Sign up

Export Citation Format

Share Document