The Potential of Natural Ventilation in Single-Sided Ventilated Apartment to Improve Indoor Thermal Comfort and Air Quality

2011 ◽  
Author(s):  
M. F. Mohamed ◽  
M. Behnia ◽  
S. King ◽  
D. Prasad
Keyword(s):  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Natural Ventilation ◽  
Architectural Element ◽  
Flat Design ◽  
Effective Ventilation ◽  
Computational Fluid Dynamics Cfd ◽  
Ventilation Performance

Cross ventilation is a more effective ventilation strategy in comparison to single-sided ventilation. In the NSW Residential Flat Design Code1 (RFDC) the majority of apartments are required to adopt cross ventilation. However, in the case of studio and one-bedroom apartments, it is acknowledged that single-sided ventilation may prevail. Deep plan studio and one-bedroom apartments may achieve lower amenity of summer thermal comfort and indoor air quality where mechanical ventilation is not provided by air conditioning. Since compliance with the code may allow up to 40% of apartments in a development in Sydney to be single sided, it is important to understand the natural ventilation performance of such apartments. The objective of this paper is to investigate the natural ventilation potential in single-sided ventilated apartments to improve indoor air quality and thermal comfort. This investigation includes simulating various facade treatments involving multiple opening and balcony configurations. Balcony configurations are included in this study because, in Sydney, a balcony is a compulsory architectural element in any apartment building. The study uses computational fluid dynamics (CFD) software to simulate and predict the ventilation performance of each apartment configuration. This study suggests that properly configured balconies and openings can significantly improve indoor ventilation performance for enhanced indoor air quality and thermal comfort, by optimizing the available prevailing wind. However, it is important to note that inappropriately designed fac¸ade treatments also could diminish natural ventilation performance.

scholarly journals The Determination of Indoor Air Quality and Thermal Comfort with Different Space and Ventilation in the Teracce and Bungalow Houses

2021 ◽  
Vol 16 (3) ◽  
pp. 774-793
Author(s):  
Nur Baitul Izati Rasli ◽  
Nor Azam Ramli ◽  
Mohd Rodzi Ismail
Keyword(s):  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Natural Ventilation ◽  
Ventilation System ◽  
Physical Parameters ◽  
Air Contaminants ◽  
Code Of Practice ◽  
Air Movement

This study observed the influence of different ventilation, indoor and outdoor activities (i.e., cooking, praying, sweeping, gathering, and exhaust from motorcycle) between a bungalow house (i.e., stack and cross ventilation applications) and a terrace house (i.e., one-sided ventilation application). We appraised the indoor air quality (IAQ) and thermal comfort. We monitored the indoor air contaminants (i.e., TVOC, CO, CH2O, PM10, O3, and CO2) and specific physical parameters (i.e., T, RH, and AS) for four days in the morning (i.e., 6.00 a.m. – 9.00 a.m.), morning-evening (i.e., 11.00 a.m. – 2.00 p.m.), and evening-night (i.e., 5.00 p.m. – 8.00 p.m.) sessions. The results found that cooking activities are the major activities that contributed to the increase of the TVOC, CO, PM10, O3, and CO2 concentrations in the bungalow and terrace houses. However, IAQ exceeded the Industry Code of Practice on IAQ (ICOP) limit in the terrace house. The bungalow house applies stack and cross ventilation, double area, and a long pathway of indoor air contaminants movements. Besides that, the results indicated that cooking activities worsen the ventilation system because CO2 exceeded the ICOP limit on Day 2 at 74.1 % (evening-night session) and Day 3 at 13.2 % (morning session), 11% (morning-evening session), and 50.1 % (evening-night session). Moreover, the combination of mechanical (i.e., opened all fans) and natural ventilation (i.e., opened all doors, windows, and fans) is the best application in the house without a cooking ventilator with lower indoor air movement. Furthermore, the temperatures exceeding the ICOP limit of 23-26 °C for both bungalow and terrace houses could be lower indoor air movement, which is less than the ICOP limit of 0.15-0.5 m/s and high outdoor air temperature. Therefore, it is prudent to have an efficient ventilation system for acceptable indoor air quality and thermal comfort in the family house.

Analysis of Thermal Comfort and Air Quality in the Kindergarten Hart - A Case Study of a Unique Sustainable Building Design

2019 ◽  
Vol 887 ◽  
pp. 500-507
Author(s):  
Matthias Schuss ◽  
Mahnameh Taheri ◽  
Ulrich Pont ◽  
Ardeshir Mahdavi
Keyword(s):  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Environmental Conditions ◽  
Natural Ventilation ◽  
Building Design ◽  
Present Contribution ◽  
Ongoing Research ◽  
Indoor And Outdoor

The present contribution, reports on the results of ongoing research efforts on performance assessment of a number of buildings designed by the Austrian architect, Konrad Frey. He is a pioneer of energy-efficient architecture, and his designs, those dating back to the 1970s, adapted the principles of modern solar houses. The current study focuses on the Kindergarten Hart, which was especially designed focusing on the availability of cross ventilation option in building. For the purpose of analyzing thermal comfort, indoor air quality, and the occupants’ adaptive actions with respect to natural ventilation, we conducted long-term monitoring under summer and winter conditions. The monitoring efforts covered indoor and outdoor environmental conditions, as well as the state of windows. Thereby, study of the monitored dataset provides a better understanding of the building performance. Moreover, it makes it possible to examine whether the architect’s expectations in terms of thermal comfort and indoor air quality levels are fulfilled or not. In addition, investigation of the occupants’ interactions with windows, together with indoor and outdoor environmental conditions, assists understanding of possible associations between the window opening/closing and environmental parameters, as well as potential optimization of the control-oriented actions.

scholarly journals Application of Wind as a Renewable Energy Source for Passive Cooling through Windcatchers Integrated with Wing Walls

Energies ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 2536 ◽  
Author(s):  
Payam Nejat ◽  
Fatemeh Jomehzadeh ◽  
Hasanen Hussen ◽  
John Calautit ◽  
Muhd Abd Majid
Keyword(s):  
Air Quality ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Natural Ventilation ◽  
Passive Cooling ◽  
Quality Factors ◽  
Ventilation Performance ◽  
Wing Walls ◽  
The Impact ◽  
Ventilation Systems

Generally, two-third of a building’s energy is consumed by heating, ventilation and air-conditioning systems. One green alternative for conventional air conditioner systems is the implementation of passive cooling. Wing walls and windcatchers are two prominent passive cooling techniques which use wind as a renewable resource for cooling. However, in low wind speed regions and climates, the utilization of natural ventilation systems is accompanied by serious uncertainties. The performance of ventilation systems can be potentially enhanced by integrating windcatchers with wing walls. Since previous studies have not considered this integration, in the first part of this research the effect of this integration on the ventilation performance was assessed and the optimum angle was revealed. However, there is still gap of this combination; thus, in the second part, the impact of wing wall length on the indoor air quality factors was evaluated. This research implemented a Computational Fluid Dynamics (CFD) method to address the gap. The CFD simulation was successfully validated with experimental data from wind tunnel tests related to the previous part. Ten different lengths from 10 cm to 100 cm were analyzed and it was found that the increase in wing wall length leads to a gradual reduction in ventilation performance. Hence, the length does not have a considerable influence on the indoor air quality factors. However, the best performance was seen in 10 cm, that could provide 0.8 m/s for supply air velocity, 790 L/s for air flow rate, 39.5 1/h for air change rate, 107 s for mean age of air and 92% for air change effectiveness.

scholarly journals A review on windcatcher for passive cooling and natural ventilation in buildings, Part 1: Indoor air quality and thermal comfort assessment

2017 ◽  
Vol 70 ◽  
pp. 736-756 ◽  
Author(s):  
Fatemeh Jomehzadeh ◽  
Payam Nejat ◽  
John Kaiser Calautit ◽  
Mohd Badruddin Mohd Yusof ◽  
Sheikh Ahmad Zaki ◽  
...  
Keyword(s):  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Natural Ventilation ◽  
Passive Cooling

scholarly journals Assessing low energy school buildings using the new Building Bulletin 101

2019 ◽  
pp. 43-52
Author(s):  
Yingchun Ji ◽  
Jiangtao Du
Keyword(s):  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Natural Ventilation ◽  
Building Design ◽  
Guidance Document ◽  
School Building ◽  
Learning And Teaching ◽  
Design Alternatives

This paper reports an assessment of a school building design using the newly published Building Bulletin 101 2018. The requirements on thermal comfort and CO2 based indoor air quality from this new guidance document are very different from its earlier version published in 2006. Existing research reported that the new requirements are much tougher to meet compared with the previous version. The aim of this research is to examine whether design alternatives on an existing school building with 10 learning and teaching spaces can help in passing the new requirements using dynamic thermal simulation tool - IESVE. It is found that promoting ventilation, shading and night purging can all help mitigating overheating in the ten learning and teaching spaces evaluated. With the ‘as built’ condition, these learning and teaching spaces failed all three overheating criteria from the new BB101. Promoting ventilation can help some of the spaces pass the overheating occurrence criterion but not the overheating severity criteria. With added shading to block excessive solar gains, half of the evaluated spaces were able to pass the thermal comfort requirement. Boosting the night purging also helps to some extent in bridging the gap against the target requirements on overheating severity, however, there are still spaces which will not pass the comfort requirement. This may indicate that natural ventilation itself may not be able to provide thermal comfort for the given design. CO2 based indoor air quality requirements are less of an issue as higher CO2 concentrations always happen when the outdoor air temperature is low, boosting ventilation using automatic or manual control can easily resolve this. The research also highlights that one of the overheating criteria is much more difficult to meet, the appropriateness of this criterion is therefore in question. As the new BB101 was only launched very recently, it will be subject to further tests and evaluations in order to examine whether it fits for purpose.

scholarly journals Numerical analysis of the impact of natural ventilation on the Indoor Air Quality and Thermal Comfort in a classroom

2019 ◽  
Vol 111 ◽  
pp. 01023 ◽  
Author(s):  
George-Mãdãlin Chitaru ◽  
Andrei Istrate ◽  
Tiberiu Catalina
Keyword(s):  
Numerical Simulation ◽  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Natural Ventilation ◽  
Simulation Software ◽  
Educational Institutions ◽  
Research School ◽  
The Impact

Indoor air quality (IAQ) inside educational institutions is an important topic in the field of building and health research. School absenteeism and educational performance have been linked to poor air quality inside classrooms. A numerical simulation software has been used to test 5 different scenarios of natural ventilation during summer and winter. CO2 levels, air relative humidity, operative temperature and PMV were used as indoor air quality and thermal comfort indicators. Results have shown high CO2 and humidity levels when all windows are closed, and a variable improvement when different natural ventilations strategies are employed. A detailed procedure for the numerical simulation has been presented.

Effect of natural ventilation on indoor air quality and thermal comfort in dormitory during winter

2017 ◽  
Vol 125 ◽  
pp. 240-247 ◽  
Author(s):  
Zhangping Lei ◽  
Chuanping Liu ◽  
Li Wang ◽  
Na Li
Keyword(s):  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Natural Ventilation

scholarly journals Keeping Cool in the Desert: Using Wind Catchers for Improved Thermal Comfort and Indoor Air Quality at Half the Energy

Buildings ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 100
Author(s):  
Jamal Saif ◽  
Andrew Wright ◽  
Sanober Khattak ◽  
Kasem Elfadli
Keyword(s):  
Air Quality ◽  
Thermal Comfort ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Energy Demand ◽  
Air Conditioning ◽  
Natural Ventilation ◽  
Energy Use ◽  
Cooling System ◽  
Evaporative Cooling

In hot arid climates, air conditioning in the summer dominates energy use in buildings. In Kuwait, energy demand in buildings is dominated by cooling, which also determines the national peak electricity demand. Schools contribute significantly to cooling demand, but also suffer from poor ventilation. This paper presents analysis of a ventilation and cooling system for school classrooms using a wind catcher for natural ventilation and evaporative cooling. A school classroom in Kuwait with single-sided ventilation was modelled using the DesignBuilder V5.4/EnergyPlus V9.1 software and calibrated using field data. The model was used to analyse the performance of a wind catcher, with and without evaporative cooling, in terms of energy use, thermal comfort and indoor air quality. Compared to the baseline of using air-conditioning only, a wind catcher with evaporative cooling was found to reduce energy use by 52% during the summer months while increasing the comfortable hours from 76% to 100% without any supplementary air conditioning. While the time below the ASHRAE CO2 limit also improved from 11% to 24% with the wind catcher, the indoor air quality was still poor. These improvements came at the cost of a 14% increase in relative humidity. As the wind catcher solution appears to have potential with further development; several avenues for further research are proposed.

Sign in / Sign up

Export Citation Format

Share Document