Effects of Leading Edge Separation Vortex of Flexible Structure Delta Wing on Its Aerodynamic Characteristics(Wing and Airfoil)

Author(s):  
Hiromitsu Kawazoe ◽  
Susumu Kato
1961 ◽  
Vol 65 (603) ◽  
pp. 195-198 ◽  
Author(s):  
B. J. Elle ◽  
J. P. Jones

A description is given of the distribution of vorticity in the surface of thin wings with large leading edge sweep. Although the delta wing is chosen as the basic plan form the deductions are general and applicable to other types of wing. The conclusions are illustrated with experimental evidence from a water tunnel.


2014 ◽  
Vol 2014.20 (0) ◽  
pp. _20506-1_-_20506-2_
Author(s):  
Tadateru ISHIDE ◽  
Hiroki NAKAYAMA ◽  
Kazuya NAGANUMA ◽  
Keiju MAKIMOTO ◽  
Hiroyuki ISHIKAWA ◽  
...  

1992 ◽  
Vol 29 (2) ◽  
pp. 203-209 ◽  
Author(s):  
S. Naomi McMillin ◽  
James L. Pittman ◽  
James L. Thomas

2016 ◽  
Vol 138 (6) ◽  
Author(s):  
T. Lee

The impact of Gurney flaplike strips, of different geometric configurations and heights, on the aerodynamic characteristics and the tip vortices generated by a reverse delta wing (RDW) was investigated via force-balance measurement and particle image velocimetry (PIV). The addition of side-edge strips (SESs) caused a leftward shift of the lift curve, resembling a conventional trailing-edge flap. The large lift increment overwhelmed the corresponding drag increase, thereby leading to an improved lift-to-drag ratio compared to the baseline wing. The lift and drag coefficients were also found to increase with the strip height. The SES-equipped wing also produced a strengthened vortex compared to its baseline wing counterpart. The leading-edge strips (LESs) were, however, found to persistently produce a greatly diffused vortex flow as well as a small-than-baseline-wing lift in the prestall α regime. The downward LES delivered a delayed stall and an increased maximum lift coefficient compared to the baseline wing. The LESs provide a potential wingtip vortex control alternative, while the SESs can enhance the aerodynamic performance of the RDW.


1976 ◽  
Vol 27 (1) ◽  
pp. 1-14 ◽  
Author(s):  
L C Squire

SummaryThis paper concerns the boundaries between flow regimes for sharp-edged delta wings in supersonic flow and the relation of some predictions of thin-shock-layer theory to these boundaries. In particular, it is shown that the theory predicts that the attachment lines on the lower surface of a thin delta wing at supersonic speeds suddenly jump from just inboard of the leading edges to the centre line in certain flight conditions. In general there is close agreement between the conditions for this jump and the flight conditions corresponding to the change-over from attached flow to the leading-edge separation on the upper surface. Since the movement of the attachment lines on the lower surface must change the position of the sonic line and the nature of the expansion around the edge, it is suggested that the two phenomena are directly related. Thus thin-shock-layer theory can be used to establish the boundaries of the various flow regimes for a wide range of Mach number, incidence and wing sweep. The theory can also be used to predict the effects of wing thickness on leading-edge separation, but here the experimental data is very sparse and somewhat contradictory, so the value of the prediction in the case of thickness requires further investigation.


Sign in / Sign up

Export Citation Format

Share Document