Performance Enhancement of Encoding–Decoding Multidiagonal and Walsh Hadamard Codes for Spectral Amplitude Coding-Optical Code Division Multiple Access (SAC-OCDMA) Utilizing Dispersion Compensated Fiber

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Majidah H. Majeed ◽  
Riyadh Khlf Ahmed

AbstractSpectral Amplitude Coding-Optical Codes Division Multiple Access (SAC-OCDMA) is a future multiplexing technique that witnessed a dramatic attraction for eliminating the problems of the internet in optical network field such as multiple-user access and speed’s growth of the files or data traffic. In this research article, the performance of SAC-OCDMA system based on two encoding–decoding multidiagonal (MD) and Walsh Hadamard (WH) codes is enhanced utilizing three different schemes of dispersion compensating fiber (DCF): pre-, post- and symmetrical compensation. The system is simulated using Optisystem version 7.0 and Optigrating version 4.2. The performance of the proposed system is specified in terms of bit error rate (BER), Q-factor and eye diagram. It has been observed that the compensated system based on MD code is performs much better compared to the system based on WH code. On the other hand, the compensated SAC-OCDMA system with symmetrical DCF has the lowest values of BER and largest values of Q-factor, so it is considered the best simulated scheme contrasted with pre- and post-DCF.

2018 ◽  
Vol 39 (2) ◽  
pp. 215-221 ◽  
Author(s):  
Manisha Bharti ◽  
Manoj Kumar ◽  
Ajay K. Sharma

AbstractThe main task of optical code division multiple access (OCDMA) system is the detection of code used by a user in presence of multiple access interference (MAI). In this paper, new method of detection known as XOR subtraction detection for spectral amplitude coding OCDMA (SAC-OCDMA) based on double weight codes has been proposed and presented. As MAI is the main source of performance deterioration in OCDMA system, therefore, SAC technique is used in this paper to eliminate the effect of MAI up to a large extent. A comparative analysis is then made between the proposed scheme and other conventional detection schemes used like complimentary subtraction detection, AND subtraction detection and NAND subtraction detection. The system performance is characterized by Q-factor, BER and received optical power (ROP) with respect to input laser power and fiber length. The theoretical and simulation investigations reveal that the proposed detection technique provides better quality factor, security and received power in comparison to other conventional techniques. The wide opening of eye in case of proposed technique also proves its robustness.


2018 ◽  
Vol 39 (4) ◽  
pp. 459-462 ◽  
Author(s):  
Monika Rani ◽  
Harbax Singh Bhatti ◽  
Vikramjeet Singh

Abstract In this manuscript, we have analyzed a Spectral Amplitude Coding-Optical Code Division Multiple Access (SAC-OCDMA) System. The system performance is enhanced by reducing the effect of Multiple Access Interference (MAI) using uniform Fiber Bragg Gratings (FBGs) encoders and decoders at central office and subscriber’s end. The results are verified through a mathematical model and Modified Double Weight (MDW) codes for the proposed system using Adomian Decomposition Method (ADM). Further, we have demonstrated SAC-OCDMA system for transmission of 40 Gbps data rate up to a distance of 80 km by increasing the number of FBGs. The proposed system has been analyzed in terms of distance, bit error rate (BER) and Quality Factor.


2018 ◽  
Vol 8 (10) ◽  
pp. 1861 ◽  
Author(s):  
Somia Abd El-Mottaleb ◽  
Heba Fayed ◽  
Ahmed Abd El-Aziz ◽  
Mohamed Metawee ◽  
Moustafa Aly

In this paper, the performance of a spectral amplitude coding-optical code division multiple access (SAC-OCDMA) system is investigated utilizing a single photodiode (SPD) detection technique. The proposed system uses enhanced double weight (EDW) codes as signature codes with three simultaneous users to overcome both phase-induced intensity noise (PIIN) and multiple access interference (MAI). In addition, a dispersion compensating fiber (DCF) is used in order to decrease the group velocity dispersion (GVD) caused in the single mode fiber. An erbium-doped fiber amplifier (EDFA) is used to overcome the attenuation. The use of both DCF and EDFA leads to an appreciable enhancement in the system performance. The system performance is evaluated through its bit error rate (BER), Q-factor, and received power. A comparison between the EDW codes and modified double weight (MDW) codes on the SAC-OCDMA system is demonstrated. Simulation is carried out through Optisystem ver. 7. The simulation results show that: (a) using an avalanche photodiode (APD) over PIN photodiode allows data transmission over longer distances; (b) the use of DCF improves the system BER;(c) using MDW codes gives better BER than using EDW codes.


Author(s):  
M. K.A. Abdullah ◽  
S. A. Aljunid ◽  
M. D.A. Samad ◽  
S. B.A. Anas ◽  
R. K.Z. Sahbudin

Many codes have been proposed for optical CDMA system as discussed in Svetislav, Mari, Zoran, Kosti, and Titlebaum (1993), Salehi (1989), Liu and Tsao (2002), Maric, Moreno, and Corrada (1996), Wei and Ghafouri-Shiraz (2002), and Prucnal, Santoro, and Ting (1986). Optical code division multiple access (OCDMA) has been recognized as one of the most important technologies for supporting many users in shared media simultaneous, and in some cases can increase the transmission capacity of an optical fiber. OCDMA is an exciting developments in short haul optical networking because it can support both wide and narrow bandwidth applications on the same network, it connects large number of asynchronous users with low latency and jitter, and permits quality of service guarantees to be managed at the physical layer, offers robust signal security and has simplified network topologies. However, for improperly designed codes, the maximum number of simultaneous users and the performance of the system can be seriously limited by the multiple access interference (MAI) or crosstalk from other users. Another issue in OCDMA is how the coding is implemented. The beginning idea of OCDMA was restricted in time domain, in which the encoding/decoding could not been fully utilized in optical domain. Therefore a new coding in OCDMA has been introduced based on spectral encoding (Kavehrad & Zaccarin, 1995; Pearce & Aazhang, 1994; Smith, Blaikie, & Taylor, 1998; Wei & Ghafouri-Shiraz, 2002). The system, called Optical Spectrum CDMA, or OS-CDMA, has the advantage of using inexpensive optical sources, and simple direct detection receivers. In this article with an emphasis on the Spectral Amplitude Coding scheme, a new code known as Khazani-Syed (KS) code is introduced.


Photonics ◽  
2019 ◽  
Vol 6 (2) ◽  
pp. 60 ◽  
Author(s):  
Kai-Sheng Chen

Supporting multi-rate transmission is an essential factor in current optical packet switching (OPS) networks. In this paper, the author studied a multi-rate scheme capable of forwarding packets with different signal rates based on label switching. The multiple-code (MC) technique was employed to label a packet by conveying its payload bits to multiple optical code-division multiple-access (OCDMA) labels. Spectral-amplitude-coding (SAC), which represents the chips in an OCDMA code as a set of wavelengths, was introduced to remove the multiple-access interference (MAI) from the overlapping among labels. The author tested the system effectiveness by conducting numerical analysis to formulate bit-error probability (BEP) and spectral efficiency (SE). The simulation results showed that the proposed network had a stable BEP performance when switching the packet flows of multiple data-rates.


2019 ◽  
Vol 9 (7) ◽  
pp. 1513
Author(s):  
Kai-Sheng Chen

We present packet switching applications based on extended spectral-amplitude-coding (SAC) labels in generalized multi-protocol label switching (GMPLS) networks. The proposed approach combines the advantages of wavelength-division multiplexing (WDM) and optical code-division multiple access (OCDMA). The extended SAC labels preserve the orthogonal property to avoid the effect of multiple access interference (MAI) shown at the decoder. We investigate the node architecture of label generation/recognition based on arrayed waveguide grating (AWG). Combining cyclic-shifted maximal length sequence (MLS) codes with the wavelength routed property of AWG simplifies the node structure. The simulation results show that the proposed labels achieve good performances against receiver noise due to the low average cross-correlation values. Under a given bit-error-rate (BER), the switching efficiency of the extended SAC labels outperforms the previous OCDMA schemes, as the network nodes are capable of processing a large number of labels simultaneously.


Sign in / Sign up

Export Citation Format

Share Document