Comparison of PDD1/2 and PDu Position Controls of a Second Order Linear System

Author(s):  
Luca Bruzzone ◽  
Pietro Fanghella
Author(s):  
Qingyu Su ◽  
Georgi M. Dimirovski ◽  
Jun Zhao

In this paper, the synthesis and optimization problems of the transient performances, such as overshoot and setting time, of the output response with respect to a step signal for an under-damped second-order linear system are studied. The traditional control strategy and the switching control strategy are used, respectively. Our control objective is twofold: Objective 1 is to ensure that the overshoot of the system output does not violate the given safety bound and objective 2 is to ensure that the settling time is smaller than the given allowable time. The obtained results indicate that the switching control strategy has main two evident advantages: firstly, the switching proportional controllers can take advantages of both the quick response and the small overshoot of the output response. Secondly, the switching controller is always available, while the single proportional controller is available in some special cases. Finally, an example of servomotor is given to demonstrate the effectiveness of the proposed method.


1995 ◽  
Vol 1 (2) ◽  
pp. 183-199 ◽  
Author(s):  
Jong-Lick Lin ◽  
Jer-Nan Juang

Several sufficient conditions are derived for a second-order linear system to be minimum phase. It is commonly known that a second-order linear system with collocated sensors and actuators is minimum phase. In general, this common knowledge is correct mathematically when the input influence matrix is the transpose of the output influence matrix. In this paper, we extend this knowledge to the case with noncollocated actuators and sensors. First, a conventional approach is used to prove some sufficient conditions of sensor and actuator locations for a system to be minimum phase. Second, a geometrical approach is introduced to discuss the sufficient conditions, and then used to derive other more useful sufficient conditions for a minimum-phase second-order linear system. Many illustrative examples are provided for the readers to better understand the theories developed in this paper.


2012 ◽  
Vol 538-541 ◽  
pp. 2582-2585 ◽  
Author(s):  
Feng Bao Li ◽  
Xiao Yan Lei ◽  
Fu Cheng Zhu

An over-damped second-order linear system with fluctuant coefficient of the second-order derivative and signal-modulated noise is considered. Based on linear-system theory, the expression of the output amplitude is obtained. Analytical results shows that the output amplitude is a non-monotonic function of the noise strength, and it varies non-monotonously with the increase of the system parameter a and b, while it decreases monotonously with the increase of the signal frequency and the system parameter c.


1969 ◽  
Vol 91 (2) ◽  
pp. 207-210 ◽  
Author(s):  
E. J. Davison

Necessary and sufficient conditions are obtained for the stability of the following second order linear system: x˙=θ(t)x,θ(t)=θt+∑i=1lTi and θ(t) =A1,0<t<T1=A2,T1<t<T1+T2⋮=Al,∑i=1l−1Ti<t<∑i=1lTi in terms of the eigenvalues and elements of the matrices Ai, i = 1, 2…l. The conditions become very simple for the case that l = 2. An example of a pendulum with a vibrating support is included.


Sign in / Sign up

Export Citation Format

Share Document