scholarly journals The Digital Integrated Workflow in the Aesthetic Management of the Smile: A Case Report

Prosthesis ◽  
2020 ◽  
Vol 2 (3) ◽  
pp. 196-210
Author(s):  
Paolo Scattarelli ◽  
Paolo Smaniotto ◽  
Serena Leuci ◽  
Gabriele Cervino ◽  
Mario Gisotti

The aesthetic treatment for anterior teeth requires a series of clinical and technical evaluations to obtain a predictable result, following a well-defined operating sequence. Today, the clinical–technical team can use different digital tools in the different steps of the workflow. A preventive assessment, the knowledge of limits, and the possibilities of surgical and prosthetic procedures allow to use these devices. Sharing goals of the treatment with the patient according to their expectations and needs is the key point of the treatment plan. Setting a defined treatment plan avoids invasive procedures. In this clinical case report, a 27-year-old patient affected by Class II div 2 malocclusion with deep bite was treated with a full digital workflow. Previewing the aesthetics was through dedicated software, which shows operators and patients the objectives of the therapy and guides the dental technician in the first phase of the work. The use of digital flows in the prosthetic phases reduces the working time. In this case, it shows the impact of a digital workflow on peri-prosthetic therapy for the aesthetic rehabilitation of the upper central incisors in a young adult.

2019 ◽  
Vol 9 (1) ◽  
pp. 67-73 ◽  
Author(s):  
Sanjay Prasad Gupta

Anterior spacing is a common esthetic problem of patient during dental consultation. The most common etiology include tooth size and arch length discrepancy. Maxillary lateral incisors vary in form more than any other tooth in the mouth except the third molars. Microdontia is a condition where the teeth are smaller than the normal size. Microdontia of maxillary lateral incisor is called as “peg lateral”, that exhibit converging mesial and distal surfaces of crown forming a cone like shape. A carefully documented diagnosis and treatment plan are essential if the clinician is to apply the most effective approach to address the patient’s needs. A patient sometimes requires a multidisciplinary approach to correct the esthetics and to improve the occlusion. This case report describes the management of an adult female patient with a proclined upper anterior teeth, upper anterior spacing, deep bite and peg shaped upper right lateral incisor tooth through orthodontic and restorative treatment approach.


2021 ◽  
Vol 7 (3) ◽  
pp. 382-391
Author(s):  
Joselúcia Da Nóbrega Dias ◽  
Endyara Larissa Araújo Pereira e Souza ◽  
Alex José Souza dos Santos ◽  
Isauremi Vieira de Assunção

Introduction: The aesthetic rehabilitation of endodontically treated teeth depends on the degree of destruction of the crown, the tooth in question, the bone support, the type of prosthesis and the types of forces to which these teeth will be submitted. The indirect composite resins have improved physical and mechanical properties thanks to the incorporation of inorganic components and multifunctional monomers with a greater number of bonding points, making them capable of solving the problems in which ceramic restorations would be indicated. Objective: To present a clinical case report of an aesthetic rehabilitation of anterior teeth with indirect composite resin as a viable and less expensive treatment alternative. Case Report: Upon clinical examination, extensive and deficient restorations were observed in the upper anterior teeth. The proposed treatment plan aesthetic rehabilitation of dental elements with ceromeres. Conclusions: This treatment represented a viable and less expensive option that can be used both in situations of great dental destruction and in small dental absences, in substitution for ceramic restorations.


2020 ◽  
Vol 23 (2) ◽  
pp. 28-33
Author(s):  
Indira Apriantika ◽  
Agung Krismariono

A healthy and beautiful smile can affect appearance and confidence. One of the aesthetic problems in dentistry that is often complained of by patients is excessive gingival display (gummy smile). The excessive gingival display can be caused by several factors, one of which is altered passive eruption (APE). One of the treatments to correct gummy smile related to APE is crown lengthening. Crown lengthening can be with bone reduction (gingivectomy with bone reduction) or without bone reduction (gingivectomy). Crown Lengthening with bone reduction is a surgical procedure that aims to maintain the dentogingival complex and to improve smile aesthetics. The purpose of this case report is to determine the crown lengthening with bone reduction (gingivectomy with bone reduction) procedure as a gummy smile treatment related to APE .A23-year-old female patient, came to Dental Hospital of Universitas Airlangga with complaints of her upper gum which not in the same length and the teeth looked short, she considered her smile was less aesthetic. After conducting analyses relating to aesthetics and periodontal tissue, crown lengthening with bone reduction was chosen for this patient treatment. The treatment results are quite good, visible gingival margins that matched the gingival zenith and improved patient's smile profile. APE as the etiology of patient's gummy smile can be corrected. There are no post-surgical complications such as excessive pain and infection. A proper diagnosis, treatment plan, and good techniques can produce a harmonious smile on the patient.


2020 ◽  
Vol 12 (45) ◽  
pp. 24-33
Author(s):  
Fábio Shiniti Mizutani ◽  
Atila de Freitas ◽  
Adriano Sapata ◽  
Claudio Sato

Keeping in mind the final result is the basis of any type of treatment, especially those in which the morphology, size and proportion of the anterior teeth will be changed. This is where a good treatment plan based on a diagnostic wax-up tested with a mock-up and approved by the patient becomes crucial. This case report aims to exemplify how to transfer the diagnostic information to the patient’s mouth and direct it not only to the restorative dentistry, but also to the surgeon when performing the crown length. Diagnostic waxing was performed by the laboratory technician, obeying anterior posterior incisal and gingival criteria and curvatures, which were transported to an aesthetic guide through mock up to mark the surgical points. Then, surgery to increase the clinical crown with bone access and after healing, direct venners in composite resin also guided by waxing. In conclusion, a workflow can be established using the wax-up / mock-up that serves as a guide for the periodontist in the approach to surgical lengthening of the crown and for the rehabilitator who uses it to produce changes in the shape of dental dimensions .


2015 ◽  
Vol 5 ◽  
pp. 220-224
Author(s):  
Akshai Shetty ◽  
Anjana Shetty ◽  
Krishnamurthy Bonanthaya ◽  
Pritham Shetty ◽  
Dipesh Rao

Cleft orthodontics generally poses a challenge and a missing premaxilla adds to the difficulty in managing them. The lack of bone support and anterior teeth in a case with missing premaxilla accounts not only for difficulty in rehabilitation but also in increasing the maxillary hypoplasia. This article presents a case report where planned orthodontic and surgical management using distraction has helped treat a severe maxillary hypoplasia in a patient with missing premaxilla. The treatment plan and method can be used to treat severe maxillary hypoplasia and yield reasonably acceptable results for such patients.


2010 ◽  
Vol 11 (4) ◽  
pp. 56-62 ◽  
Author(s):  
Yusuf Ziya Bayindir ◽  
Yahya Orcun Zorba ◽  
Cagatay Barutcugil

Abstract Aim The aim of this report is to present five-year follow-ups of two different applications for the use of direct laminate resin-based composite veneers to improve esthetics. Background Defects in the maxillary anterior teeth, such as enamel hypoplasia and peg lateral, can present esthetic challenges. Furthermore, a treatment plan that can be completed in a single appointment is highly desirable. This case report presents two different clinical cases involving the use of direct laminate resin-based composite veneers with five-year follow-ups. Case Report Case 1: A 17-year-old female patient was referred for treatment of her anterior teeth, which were unesthetically altered due to enamel hypoplasia and dental caries. A treatment plan was developed that included restoring the affected teeth with direct resin-based composite laminate veneers to improve the patient's appearance. The six maxillary anterior teeth were prepared for and restored with direct resinbased composite laminate veneers. At the fiveyear follow-up, the patient was satisfied with the restorations both esthetically and functionally. Case 2: A 15-year-old female patient also was referred for treatment to improve the appearance of her maxillary anterior teeth. A treatment plan was developed with two objectives: (1) to restore the undersized supernumerary crown in the area of the maxillary right lateral incisor and (2) to close the anterior diastemas. The facial surfaces were conservatively prepared and resin-based composite was applied with the aid of transparent crown forms. After completion of the treatment, the patient was recalled at six-month intervals. At the five-year follow-up appointment, the restorations were intact, no adverse effects were noted, and the resultant appearance was highly satisfactory for the patient. Summary The use of direct resin-based composite laminate veneers and adhesive bonding systems has been shown to provide an esthetic alternative to metal-ceramic or all-ceramic crowns for the rehabilitation of anterior teeth. This treatment option offers another advantage, namely a lower cost compared to an indirect technique. Other more complex and costly treatment options in the future are not ruled out. Clinical Significance In the present two cases, the initial and five-year follow-up results support the use of direct resin-based composite laminate veneers with minimal altering of healthy tooth structure. Such results should encourage clinicians to seek a cost-effective technique such as direct resin restorations to improve a patient's esthetic appearance in a single appointment. Citation Zorba YO, Bayindir YZ, Barutcugil C. Direct Laminate Veneers with Resin Composites: Two Case Reports with Five-Year Follow-ups. J Contemp Dent Pract [Internet]. 2010 July; 11(4):056-062. Available from: http://www. thejcdp.com/journal/view/volume11-issue4-zorba


2021 ◽  
Vol 1 (Volume 1 No 2) ◽  
pp. 121-130
Author(s):  
Azkya Patria Nawawi ◽  
Suzan Nusantari ◽  
Aprilia Adenan ◽  
Rasmi Rikmasari

Peg shape is one of the abnormalities of dental anatomy, i.e. tooth size is smaller than average and tapered shape. These peg-shaped teeth are often found in the maxillary lateral incisors and third molars. The form on the lateral incisor often causes aesthetic problems because of its anterior position. One of the treatments for peg-shaped teeth is Veneer. Case report: 26 years old woman had a peg-shaped shape on both lateral incisors. Indirect veneer aesthetic treatment was performed using Ceramage to correct the form and cover the diastema to achieve better aesthetics. Wax-up is done to see the suitability of the shape and proportion of the Veneer. Patients get a visual picture of the expected treatment results. The treatment results in Ceramage gave an excellent condition in improving the shape of the Peg-shaped incisor. The veneer colour resembles natural teeth, and the patient is satisfied with the treatment results. Ceramage can be used as a treatment option for anterior teeth with deformities. Ceramage Veneer is an alternative that can be done to improve the aesthetic appearance at a more economical cost for anterior teeth.


2018 ◽  
Vol 1 (1) ◽  
pp. 27
Author(s):  
Satrio Krestiono M ◽  
Harry Laksono

Background: Metal frame denture design is common used for partially dentate patient, one of the problem was a metal appearance from wrought wire or a metal casting clasp as retainer, which is not really aesthetic. Telescopic overdenture with its double crown will be the best solution for those cases. Purpose: The purpose of this case report was to reported telescopic overdenture design and fabrication where the aesthetic was the main consideration. Case: Sixty years old female patient, a businesswoman, came to Dental Hospital of Universitas Airlangga, complained about her upper partially dentate and 6 years lower fixed partial denture, which is not comfortable to wear and her upper anterior teeth doesn’t look quite good. She wanted to make crowns and removable denture. Case management: After the diagnosis were made, the pretreatment plan were remove crown for the upper jaw, remove the bridges on lower jaw, and transitional dentures were made to maintain the VDO. The crowns and veneer were fabricated and inserted while the inner copings were tried up on prepared teeth. After the the dentures were produced, the inner copings were luted to the abutment teeth, and then the dentures were inserted using FGP (Friction GriP) cement for the friction effect. Discussion: Telescopic overdenture is consists of a double crown system known as “the telescopic”, the procedure involves fitting the remaining natural teeth with inner metal crowns, followed by outer crowns as part of an over denture that can be removed by the patient. Conclusion: This technique ensures that telescopic overdentures give natural aesthetic result.


Author(s):  
Kelly Guedes de Oliveira Scudine ◽  
Kelly Maria Silva Moreira ◽  
Micaela Cardoso ◽  
Stéphanie Marani Martins Araújo ◽  
Regina Maria Puppin-Rontani ◽  
...  

Traumatic dental injuries are common clinical problems during childhood, and may have complex etiologies causing physical and physiological impairment. The aim of this study was to report the management of a severe traumatic dental injury in an 8-year-old female patient, victim of a motorcycle accident, who was taken to a pediatric dentistry clinic three months after the accident. After clinical and radiografic examination, we observed the avulsion of the permanent maxillary central incisors and of the permanent left lateral incisor, with considerable lingual interposition, interfering in speech and swallowing. The patient showed low risk of caries and good behavior during the appointments. However, she demonstrated to be embarrassed to smile. Besides the preventive treatment concerning caries, the treatment plan included immediate care and subsequent monitoring of the psychosocial reestablishment. For this purpose, an acrylic partial denture was made in order to replace the missing anterior teeth, maintaining the characteristics of the mixed dentition and preserving the aesthetics and the function. Follow-up appointments were performed one, three and six months after the first visit, aiming to monitor the adaptation of the prosthesis, as well as the growth and development of the child’s dentition. Thus, the aesthetic and functional rehabilitation was achieved regarding the patient’s satisfaction, enabling immediate social reinsertion.


Author(s):  
Hasnat Jahan ◽  
Himadri Shekhar Roy Chowdhury ◽  
Mohammad Emadul Haq ◽  
Md Zakir Hossain

A patient of 21 years old presented with Class II division 2 malocclusion and deep overbite, was treated by fixed orthodontic therapy. After completion of the treatment, extreme deep bite was corrected, proclination of upper anterior teeth and patient was satisfied with new position of his upper anterior teeth. DOI: http://dx.doi.org/10.3329/bjodfo.v2i2.16166 Ban J Orthod & Dentofac Orthop, April 2012; Vol-2, No.2, 46-47


Sign in / Sign up

Export Citation Format

Share Document