Experimental Approach for the Failure Mode of Small Laminated Rubber Bearings for Seismic Isolation of Nuclear Components

Response characteristics of small-sized laminated rubber bearings (LRBs) with partial damage and total failure were investigated. For nuclear component seismic isolation, ultimate response characteristics are mainly reviewed using a beyond design basis earthquake (BDBE). Static tests, 3D shaking table tests, and verification analyses were performed using optional LRB design prototypes. During the static test, the hysteresis curve behavior from buckling to potential damage was observed by applying excessive shear deformation. The damaged rubber surface of the laminated section inside the LRB was checked through water jet cutting. A stress review by response spectrum analysis was performed to simulate the dynamic tests and predict seismic inputs’ intensity level that triggers LRB damage. Shaking table tests were executed to determine seismic response characteristics with partial damage and to confirm the stability of the superstructure when the supporting LRBs completely fail. Shear buckling in LRBs by high levels of BDBE may be quickly initiated via partial damage or total failure by the addition of torsional or rotational behavior caused by a change in the dynamic characteristics. Furthermore, the maximum seismic displacement can be limited within the range of the design interface due to the successive slip behavior, even during total LRB failure.

Discussion On Failure Behavior of Piping Systems Under Extremely Large Seismic Loads in BDBE

To investigate the failure behavior of piping systems under severe seismic loads considering beyond design basis event (BDBE), an experimental approach to use pipes made of simulation materials was applied. "Simulation material" means the substitute material for steel to realize the structural experiment by the existing testing facilities. The simulation materials adopted in this study were pure lead (Pb) or lead-antimony (Pb-Sb) alloy. Using pipe elbows made of simulation materials, static loading tests on elbows and shaking table tests on simple piping system models composed of one or two elbows and an additional mass were conducted. From the static loading tests, the load-deflection relationship of an elbow under monotonic loading was obtained as well as the fatigue failure modes under cyclic loading depending on the several cyclic displacement levels. From the shaking table tests, several failure modes were obtained, namely, "Collapse by self-weight", "Collapse by a few cycles of input", "Ratchet and subsequent collapse", "Overall deformation", and "No failure". It was considered that the occurrence of these failure modes was affected by the ratio of the input frequency to the specimen's natural frequency, the ratio of additional mass weight to the limit mass weight, the configuration of the specimen, and the input acceleration level. The experimental results indicated that it was crucial to understand the structure's ultimate behavior when treating BDBE, and that the research approach using simulation material is effective to investigate the ultimate behavior of piping systems.

Experimental Study on Out-of-Plane Seismic Performance of New Type Masonry System

The authors developed two types of block systems, consisting only of main and key blocks, without joint mortar, to improve the in- and out-of-plane seismic performances and enhance the workability. Two types of block systems have different key block shapes. One is the peanuts shape, and the other is the H shape. The proposed block systems have a half-height difference between the main and key blocks, to significantly improve seismic performance in in- and out-of-plane directions, compared to typical masonry wall with joint mortar. In this study, in order to evaluate the out-of-plane seismic performance of the proposed block systems, two types of block walls are experimentally investigated, including the typical block wall. Firstly, the shaking table tests are carried out to investigate the fundamental out-of-plane behaviors of three specimens. Next, four-point bending tests are planned to evaluate the out-of-plane seismic performance, since all specimens do not occur the out-of-plane collapse in the shaking table tests from the preliminary calculation. In this paper, the development of predominant period, profiles of acceleration and displacement, and maximum tensile strength of each specimen are discussed in detail. As a result, the maximum loads of the proposed block walls were about three to four times that of the typical block wall. This result means that the proposed block system has significantly improved seismic performance in the out-of-plane direction.