Modes of motion of the medium and universal curves for gravity separation processes

.

Ultra-Fine Centrifugal Concentration of Bastnaesite Ore

Historically, the ability to effectively separate carbonate gangue from bastnaesite via flotation has frequently proven to be challenging without sacrificing significant rare earth oxide (REO) grade or recovery. However, in light of the fact that the rare earth bearing minerals often exhibit higher specific gravities than the carbonate gangue, the possibility exists that the use of gravity separation could be used to achieve such a selective separation. This however is complicated by the fact that, in cases such as this study when the liberation size is finer than 50 µm, most traditional gravity separation methods become increasingly challenging. The purposes of this study is to determine the applicability of gravity concentrators to beneficiate bastnaesite from deleterious calcite bearing flotation feed material. Via the use of a UF Falcon, it was possible to achieve rougher gravity REO recoveries approaching the upper 80% range while rejecting on the order of 30% of the total calcium. In terms of purely REO recovery, this represents a significant improvement over results obtained via a traditional Falcon in previously reported studies.

Recovery of Rare Erath Oxides from Flotation Concentrates of Bastnaesite Ore by Ultra-Fine Centrifugal Concentration

Historically, the ability to effectively separate carbonate gangue from bastnaesite via flotation has frequently proven to be challenging without sacrificing significant rare earth oxide (REO) grade or recovery. However, in light of the fact that the rare earth bearing minerals often exhibit higher specific gravities than the carbonate gangue, the possibility exists that the use of gravity separation could be used to achieve such a selective separation. This however is complicated by the fact that, in cases such as this study when the liberation size is finer than 50 microns, most traditional gravity separation methods become increasingly challenging. The aim of this study is to determine the applicability of centrifugal concentrators to beneficiate ultra-fine (UF) bastnaesite and calcite bearing flotation concentrates. By using a UF Falcon, it was possible to achieve initial gravity REO recoveries exceeding 90% while rejecting on the order of 25% to 35% of the total calcium from an assortment of rougher and cleaner flotation concentrates. Additionally, when additional stages of cleaner UF Falcon gravity separation were operated in an open circuit configuration, it was possible, from an original fine feed of 35 microns containing 50.5% REO and 5.5% Ca, to upgrade up to approximately 59% REO and 2.0% calcium. While not the goal of this study, these results also support previous limited data to suggest that UF Falcons are potentially capable of treating a wider range of materials than they were originally designed for, including feeds rich in heavy mineral content.

Recovery of Metals from Heat-Treated Printed Circuit Boards via an Enhanced Gravity Concentrator and High-Gradient Magnetic Separator

The recovery and reuse of waste printed circuit boards (PCBs) has attracted more and more attention from global researchers, as recycling of waste PCB metals is of great significance to the rational utilization of metal material resources. This study puts forward a clean and economical method in which enhanced gravity separation and wet high-gradient magnetic separation were combined to recover waste PCBs with heat treatment at a temperature of 240 °C. The heat treatment could improve the metal liberation effect of the PCBs, and the thermal behavior was measured by thermogravimetric analysis (TGA). The pyrolysis of the non-metal fraction (NMF) began around 300 °C, and the glass transition temperature of epoxy resin was 135.17 °C. The enhanced gravity separation technique was used for the separation of metals and NMF under the compound force field. The metals grade of the gravity concentrates fraction (GRF) was 82.97% under the optimal conditions, and the metals recovery reached 90.55%. A wet high-gradient magnetic separator was applied to classify the GRF into magnetic (MA) and non-magnetic (NMA) fractions, which could achieve iron and copper enrichment. After the three stages combined process, the copper and iron grades of the NMA and MA fractions were 70.17% and 73.42%, and the recovery reached 74.02% and 78.11%, respectively.