scholarly journals Investigation of copper lattice structures using a Split Hopkinson Pressure Bar

PAMM ◽  
2021 ◽  
Vol 21 (1) ◽  
Author(s):  
Sören Bieler ◽  
Sung Gyu Kang ◽  
Daniel Heußen ◽  
Rajaprakash Ramachandramoorthy ◽  
Gerhard Dehm ◽  
...  
Keyword(s):  
Split Hopkinson Pressure Bar ◽  
Lattice Structures ◽  
Hopkinson Pressure Bar ◽  
Split Hopkinson ◽  
Pressure Bar

Analysis of the Impact of the Frequency Range of the Tensometer Bridge and Projectile Geometry on the Results of Measurements by the Split Hopkinson Pressure Bar Method

2013 ◽  
Vol 20 (4) ◽  
pp. 555-564 ◽  
Author(s):  
Wojciech Moćko
Keyword(s):  
Test Bench ◽  
Split Hopkinson Pressure Bar ◽  
Dynamic Deformation ◽  
Spectral Width ◽  
Hopkinson Pressure Bar ◽  
Computing Environment ◽  
Split Hopkinson ◽  
Pressure Bar ◽  
The Impact ◽  
Bench Model

Abstract The paper presents the results of the analysis of the striker shape impact on the shape of the mechanical elastic wave generated in the Hopkinson bar. The influence of the tensometer amplifier bandwidth on the stress-strain characteristics obtained in this method was analyzed too. For the purposes of analyzing under the computing environment ABAQUS / Explicit the test bench model was created, and then the analysis of the process of dynamic deformation of the specimen with specific mechanical parameters was carried out. Based on those tests, it was found that the geometry of the end of the striker has an effect on the form of the loading wave and the spectral width of the signal of that wave. Reduction of the striker end diameter reduces unwanted oscillations, however, adversely affects the time of strain rate stabilization. It was determined for the assumed test bench configuration that a tensometric measurement system with a bandwidth equal to 50 kHz is sufficient

Dynamic Behaviors of near β-Type Ti-5Al-5Mo-5V-3Cr Titanium Alloys under High Strain Rate

2015 ◽  
Vol 816 ◽  
pp. 795-803
Author(s):  
Yan Ling Wang ◽  
Song Xiao Hui ◽  
Wen Jun Ye ◽  
Rui Liu
Keyword(s):  
Strain Rate ◽  
Titanium Alloys ◽  
High Strain ◽  
Split Hopkinson Pressure Bar ◽  
Failure Behavior ◽  
Hopkinson Pressure Bar ◽  
Fracture Failure ◽  
Split Hopkinson ◽  
Pressure Bar ◽  
Dynamic Loading Conditions

The mechanical properties and fracture failure behavior of the near β-type Ti-5Al-5Mo-5V-3Cr-X (X = 1Fe or 1Zr) titanium alloys were studied by Split Hopkinson Pressure Bar (SHPB) experiment under the dynamic loading conditions at a strain rate of 1.5 × 103 s-1–5.0 × 103 s-1. Results showed that the SHPB specimen fractured in the direction of maximum shearing stress at an angle of 45° with the compression axis. The fracture surface revealed the shear and tension zones with cleavage steps and parabolic dimples. Severe early unloading was observed on the Ti-5553 alloy under a strain rate of 4,900 s-1 loading condition, and the dynamic property of the Ti-55531Zr alloy was proved to be the optimal.

Sign in / Sign up

Export Citation Format

Share Document