A study of gain and noise figure performance of an L-band erbium doped fibre amplifier (EDFA) with 980 nm and amplified spontaneous emission (ASE) pumps

Author(s):  
F.R.M. Adikan ◽  
M.A. Mahdi ◽  
K. Dimyati ◽  
H. Ahmad
2001 ◽  
Vol 13 (1) ◽  
pp. 22-24 ◽  
Author(s):  
M. Soderlund ◽  
S. Tammela ◽  
P. Poyhonen ◽  
M. Leppihalme ◽  
N. Peyghambarian

2012 ◽  
Author(s):  
Sulaiman Wadi Harun ◽  
T. Subramaniam ◽  
Nizam Tamchek ◽  
Harith Ahmad

Kesan suntikan pancaran spontan terkuat (ASE) jalur–C terhadap prestasi jalur–L penguat gentian terdop–erbium (EDFA) ditunjukkan. Sebuah pekeliling dan parutan gentian Bragg lebar jalur luas digunakan untuk menyalurkan ASE jalur–C ke dalam sistem penguat. Dengan penyuntikan sejumlah kecil ASE (20 dB pelemahan dan lebih), gandaan isyarat kecil ditingkatkan tanpa peningkatan nilai hingar berbanding penguat tanpa suntikan ASE. Peningkatan gandaan maksimum adalah sebanyak 3.5 dB dan dicapai semasa pelemahan 20 dB untuk isyarat 1580 nm. Walau bagaimanapun, jika penguat disuntik dengan jumlah ASE yang besar (VOA=0 dB), gandaan penguat didapati mendatar pada 15.2 dB dari –40 hingga –10 dBm dengan variasi gandaan kurang daripada 0.3 dB. Kuasa tepu juga bertambah dari –8 dBm (semasa tiada ASE) kepada 2 dBm (VOA=0 dB) dengan sedikit peningkatan nilai hingar. Keputusan ini menunjukkan bahawa teknik menyuntik ASE boleh digunakan sama ada untuk meningkatkan gandaan atau untuk menetapkan nilai gandaan dalam EDFA jalur–L. Kata kunci: Penetapan gandaan, penguat optik, EDFA jalur-L, penambahan gandaan, pancaran spontan terkuat The effect of injecting conventional band amplified spontaneous emission (C–band ASE) on the performance of long wavelength band erbium–doped fiber amplifier (L–band EDFA) is demonstrated. A circulator and a broadband fiber Bragg grating (FBG) were used to route a C–band ASE into amplifier system. Injection of a small amount of ASE (attenuation of 20 dB and above) improves the small signal gain with a negligible noise figure penalty compared to that of an amplifier without the ASE injection. A maximum gain improvement of 3.5 dB is obtained at an attenuation of 20 dB for signal wavelength of 1580 nm. At very large amount of ASE injection (VOA=0 dB), the gain of the amplifier is clamped at 15.2 dB from –40 to –10 dBm with a gain variation of less than 0.3 dB. The saturation power is also increased from –8 dBm (for without ASE injection) to 2 dBm (VOA=0 dB) with a slight noise figure penalty. These results show that the ASE injection technique can be used either for gain improvement or gain clamping in L–band EDFA. Keywords: Gain clamping, optical amplifier, L-band EDFA, gain enhancement, amplified spontaneous emission


1996 ◽  
Vol 32 (19) ◽  
pp. 1800 ◽  
Author(s):  
A. Altuncu ◽  
A.S. Siddiqui ◽  
A.D. Ellis ◽  
M.A. Newhouse ◽  
A.J. Antos

2004 ◽  
Vol 13 (02) ◽  
pp. 315-319
Author(s):  
S. W. HARUN ◽  
H. AHMAD

The effect of injecting of C-band amplified spontaneous emission (ASE) from C-band erbium-doped fiber amplifier (EDFA) on the performance of L-band EDFA is demonstrated using a circulator and broadband fiber Bragg grating (FBG). Injecting a large amount of ASE (VOA=0 dB) clamps the gain at 15.2 dB from -40 to -10 dBm with a gain variation of less than 0.3 dB. Injecting a small amount of ASE (attenuation of 20 dB and above) improves the small signal gain with a negligible noise figure penalty compared to that of an amplifier without the ASE injection. A maximum gain improvement of 3.5 dB is obtained at an attenuation of 20 dB. These results show that the ASE injection technique can be used either for gain improvement or gain clamping in L-band EDFA.


Sign in / Sign up

Export Citation Format

Share Document