Quartz Solubility in the Vapor Phase of the H2O–HF System at 200°С and Saturated Vapor Pressure: Experimental Data

2018 ◽  
Vol 56 (11) ◽  
pp. 1109-1115
Author(s):  
A. A. Konyshev ◽  
A. M. Aksyuk ◽  
V. S. Korzhinskaya
Keyword(s):  
Experimental Data ◽  
Vapor Pressure ◽  
Vapor Phase ◽  
Saturated Vapor Pressure ◽  
Saturated Vapor ◽  
Quartz Solubility

Influence of Nano-Refrigeration-Oil on Saturated Vapor Pressure of R22

2011 ◽  
Vol 694 ◽  
pp. 309-314 ◽  
Author(s):  
Jiang Feng Lou ◽  
Rui Xiang Wang ◽  
Min Zhang
Keyword(s):  
Experimental Data ◽  
Vapor Pressure ◽  
Mass Fraction ◽  
Saturated Vapor Pressure ◽  
Saturated Vapor ◽  
Experimental Results ◽  
Vapor Pressures ◽  
Temperature Range ◽  
Mass Fractions

The saturated vapor pressures of R22 uniformly mixed with refrigeration oil and nano- refrigeration-oil were measured experimentally at a temperature range from 263 to 333K and mass fractions from 1 to 5%. The experimental results showed that the saturated vapor pressure of R22/KT56 mixture was lower than that of pure R22; the pressure deviation between them increased with a raising mass fraction of refrigeration oil and temperature. After adding nano-NiFe2O4 and nano-fullerene into KT56, the pressure deviation increased at the same mass fraction and temperature. A saturated vapor pressure correlation for R22 and refrigeration oil/nano-refrigeration-oil mixture was proposed, and the calculated values agreed with the experimental data within the deviation of ± 0.77%.

scholarly journals Investigation of applicability of Peng–Robinson and GERG-2008 equations of state of real gas for calculating properties of Freons for refrigeration machines and compressors

2021 ◽  
Vol 5 (1) ◽  
pp. 34-43
Author(s):  
M. I. Sokolov ◽  
◽  
Yu. V. Kozhukhov ◽  
Keyword(s):  
Experimental Data ◽  
Vapor Pressure ◽  
Mathematical Modelling ◽  
Equations Of State ◽  
Saturated Vapor Pressure ◽  
Saturated Vapor ◽  
Saturation Pressure ◽  
State Equations ◽  
Real Gas ◽  
Enthalpy And Entropy

A study of real gas state equations Peng–Robinson and GERG-2008 with respect to calculation of Freons R404A, R408A and R410A has been carried out. Four Freon parameters are calculated during the study: saturated vapor pressure at the saturation line at some Freon temperature, Freon density at saturation pressure and some temperature, enthalpy and entropy at the same pressures and temperature. The data obtained from the calculation of Freon by the above equations are compared with the experimental data for each of the above Freons. As a result of this work, data have been obtained to evaluate the accuracy of the Peng–Robinson and GERG-2008 equations of state for each of the three CFCs, to evaluate the effectiveness of these equations, and to provide recommendations for the calculation and application of these equations in the design and mathematical modelling of refrigeration machines

scholarly journals Effects of nanoparticles on hydraulic cavitation

2018 ◽  
Vol 240 ◽  
pp. 03004
Author(s):  
Min-rui Chen ◽  
Jin-yuan Qian ◽  
Zan Wu ◽  
Chen Yang ◽  
Zhi-jiang Jin ◽  
...  
Keyword(s):  
Vapor Pressure ◽  
Saturated Vapor Pressure ◽  
Saturated Vapor ◽  
Geometric Model ◽  
Pressure Ratio ◽  
Perforated Plate ◽  
Significant Parameter ◽  
Operation Conditions ◽  
Small Bubbles ◽  
Crucial Condition

When liquids flowing through a throttling element, such as a perforated plate, the velocity increases and the pressure decreases. If the pressure is below the saturated vapor pressure, the liquid will vaporize into small bubbles, which is called hydraulic cavitation. In fact, vaporization nucleus is another crucial condition for vaporizing. The nanoparticles contained in the nanofluids play a significant role in vaporization of liquids. In this paper, the effects of the nanoparticles on hydraulic cavitation are investigated. Firstly, a geometric model of a pipe channel equipped with a perforated plate is established. Then with different nanoparticle volume fractions and diameters, the nanofluids flowing through the channel is numerically simulated based on a validated numerical method. The operation conditions, such as the temperature and the pressure ratio of inlet to outlet, are the considered variables. As a significant parameter, cavitation numbers under different operation conditions are achieved to investigate the effects of nanoparticles on hydraulic cavitation. Meanwhile, the contours are extracted to research the distribution of bubbles for further investigation. This study is of interests for researchers working on hydraulic cavitation or nanofluids.

Porous Hydroxyapatite with Tailored Crystal Surface Prepared by Hydrothermal Method

2005 ◽  
Vol 284-286 ◽  
pp. 353-356 ◽  
Author(s):  
Koji Ioku ◽  
Giichiro Kawachi ◽  
Nakamichi Yamasaki ◽  
Hirotaka Fujimori ◽  
Seishi Goto
Keyword(s):  
Aspect Ratio ◽  
Vapor Pressure ◽  
Hydrothermal Method ◽  
Saturated Vapor Pressure ◽  
Crystal Surface ◽  
Saturated Vapor ◽  
Pure Water ◽  
Porous Hydroxyapatite ◽  
Exposure Method ◽  
The Mean

Porous plates of hydroxyapatite (Ca10(PO4)6(OH)2; HA) with about 0.5 to 5 mm in thickness and porous HA granules of about 40 µm to 1 mm in size with tailored crystal surface were prepared by the hydrothermal vapor exposure method at the temperatures above 105 °C under saturated vapor pressure of pure water. Porous HA plates with about 75 % porosity prepared at 120 °C were composed of rod-shaped crystals of about 20 µm in length. Porous HA granules prepared at 160 °C were also composed of rod-shaped crystals of about 20 µm in length with the mean aspect ratio of 30. These crystals were elongated along the c-axis. Rod-shaped HA crystals were locked together to make micro-pores of about 0.1 to 0.5 µm in size. Both of materials were nonstoichiometric HA with calcium deficient composition. These materials must have the advantage of adsorptive activity, because they had large specific crystal surface and much micro-pores.

scholarly journals Application of a Micro-Flow Regulating Valve in Saturated Vapor Pressure Measurements

Daxue Huaxue ◽  
2021 ◽  
Vol 0 (0) ◽  
pp. 2107062-0
Author(s):  
Shuai Zhang ◽  
Jian Zhang ◽  
Shaowei Bian ◽  
Yaping Zhao ◽  
Li Shen ◽  
...  
Keyword(s):  
Vapor Pressure ◽  
Saturated Vapor Pressure ◽  
Saturated Vapor ◽  
Pressure Measurements ◽  
Micro Flow ◽  
Vapor Pressure Measurements

IMPROVING THE DESIGN OF THE FILM DEODORIZER

2019 ◽  
Author(s):  
О.И. НИКОНОВ ◽  
Н.Н. БЕЛИНА ◽  
А.В. ГУКАСЯН
Keyword(s):  
Vapor Pressure ◽  
Thin Layer ◽  
Saturated Vapor Pressure ◽  
Saturated Vapor ◽  
Live Steam ◽  
Deodorization Temperature ◽  
Improved Design

Приведены характеристики содержащихся в масле одорирующих веществ. Проведен анализ конструкции существующих дезодораторов. Рассчитаны параметры, влияющие на процесс дезодорации в тонком слое. Получена зависимость давления насыщенных паров от температуры дезодорации. На основе проведенных расчетов предложены способы интенсификации процесса дезодорации. Предложена усовершенствованная конструкция дезодоратора, позволяющая интенсифицировать процесс дезодорации: сократить время и уменьшить расход острого пара. The characteristics of the odorizing substances contained in the oil are given. An analysis of the design of already existing deodorizers is given. The parameters affecting the deodorization process in a thin layer are calculated. The dependence of the saturated vapor pressure on the deodorization temperature was obtained. On the basis of the calculations performed, methods for intensifying the deodorization process have been proposed. The proposed improved design of the deodorizer, which allows intensify the deodorization process: to reduce the time and reduce the consumption of live steam.

Sign in / Sign up

Export Citation Format

Share Document