HEAT TRANSFER ENHANCEMENT CAUSED BY IMPINGING JETS OF Al2O33-WATER NANOFLUID ON A MICRO-PIN FIN ROUGHENED SURFACE UNDER CROSSFLOW CONDITIONS-A NUMERICAL STUDY

2020 ◽  
Vol 27 (4) ◽  
pp. 367-387 ◽  
Author(s):  
Usman Allauddin ◽  
Tariq Jamil ◽  
Muhammad Shakaib ◽  
H. M. Usman Khan ◽  
Rafay Mohiuddin ◽  
...  
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Numerical Study ◽  
Impinging Jets ◽  
Transfer Enhancement ◽  
Pin Fin ◽  
Roughened Surface

An Experimental and Numerical Study of Heat Transfer and Pressure Loss in a Rectangular Channel With V-Shaped Ribs

2006 ◽  
Author(s):  
Michael Maurer ◽  
Jens von Wolfersdorf ◽  
Michael Gritsch
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Thermal Performance ◽  
Pressure Loss ◽  
Numerical Study ◽  
Rectangular Channel ◽  
Reynolds Numbers ◽  
Transfer Enhancement ◽  
High Reynolds Numbers ◽  
High Reynolds

An experimental and numerical study was conducted to determine the thermal performance of V-shaped ribs in a rectangular channel with an aspect ratio of 2:1. Local heat transfer coefficients were measured using the steady state thermochromic liquid crystal technique. Periodic pressure losses were obtained with pressure taps along the smooth channel sidewall. Reynolds numbers from 95,000 to 500,000 were investigated with V-shaped ribs located on one side or on both sides of the test channel. The rib height-to-hydraulic diameter ratios (e/Dh) were 0.0625 and 0.02, and the rib pitch-to-height ratio (P/e) was 10. In addition, all test cases were investigated numerically. The commercial software FLUENT™ was used with a two-layer k-ε turbulence model. Numerically and experimentally obtained data were compared. It was determined that the heat transfer enhancement based on the heat transfer of a smooth wall levels off for Reynolds numbers over 200,000. The introduction of a second ribbed sidewall slightly increased the heat transfer enhancement whereas the pressure penalty was approximately doubled. Diminishing the rib height at high Reynolds numbers had the disadvantage of a slightly decreased heat transfer enhancement, but benefits in a significantly reduced pressure loss. At high Reynolds numbers small-scale ribs in a one-sided ribbed channel were shown to have the best thermal performance.

scholarly journals Efficiency Improvement of Miniaturized Heat Exchangers

Fluids ◽  
2021 ◽  
Vol 6 (1) ◽  
pp. 25
Author(s):  
Iris Gerken ◽  
Thomas Wetzel ◽  
Jürgen J. Brandner
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Heat Exchangers ◽  
Assessment Method ◽  
Flow Path ◽  
Transfer Enhancement ◽  
Pressure Losses ◽  
Pin Fin ◽  
Additional Pressure ◽  
The Impact

Micro heat exchangers have been revealed to be efficient devices for improved heat transfer due to short heat transfer distances and increased surface-to-volume ratios. Further augmentation of the heat transfer behaviour within microstructured devices can be achieved with heat transfer enhancement techniques, and more precisely for this study, with passive enhancement techniques. Pin fin geometries influence the flow path and, therefore, were chosen as the option for further improvement of the heat transfer performance. The augmentation of heat transfer with micro heat exchangers was performed with the consideration of an improved heat transfer behaviour, and with additional pressure losses due to the change of flow path (pin fin geometries). To capture the impact of the heat transfer, as well as the impact of additional pressure losses, an assessment method should be considered. The overall exergy loss method can be applied to micro heat exchangers, and serves as a simple assessment for characterization. Experimental investigations with micro heat exchanger structures were performed to evaluate the assessment method and its importance. The heat transfer enhancement was experimentally investigated with microstructured pin fin geometries to understand the impact on pressure loss behaviour with air.

Heat transfer enhancement of a microchannel heat sink with the combination of impinging jets, dimples, and side outlets

2019 ◽  
Vol 141 (1) ◽  
pp. 45-56 ◽  
Author(s):  
Ting Gan ◽  
Tingzhen Ming ◽  
Weijie Fang ◽  
Yang Liu ◽  
Lei Miao ◽  
...  
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Heat Sink ◽  
Impinging Jets ◽  
Microchannel Heat Sink ◽  
Transfer Enhancement
Sign in / Sign up

Export Citation Format

Share Document