Lower Extremity Biomechanical Demands During Saut de Chat Leaps

2016 ◽  
Vol 31 (4) ◽  
pp. 211-217 ◽  
Author(s):  
Danielle N Jarvis ◽  
Kornelia Kulig

In dance, high demands are placed on the lower extremity joints during jumping tasks. The purpose of this study was to compare biomechanical demands placed on the lower extremity joints during the takeoff and landing phases of saut de chat leaps. METHODS: Thirty healthy, experienced dancers with 20.8±4.9 yrs of dance training performed 5 saut de chat leaps. A three-dimensional motion analysis system and force plates were used to collect kinematic and kinetic data. Ground reaction force (GRF) peaks and impulse and sagittal plane kinematics and kinetics of the hip, knee, ankle, and metatarsophalangeal (MTP) joints were calculated for the takeoff and landing phases of each leap. RESULTS: Saut de chat takeoffs demonstrated greater braking GRF impulse (p<0.001), while landings demonstrated greater peak vertical GRF (p<0.001). During takeoff, greater kinetic demands were placed on the MTP (p<0.001) and ankle (p<0.001) joints, while during landing greater kinetic demands were placed on the hip (p=0.037) joint. CONCLUSIONS: Both the takeoff and landing phases of saut de chat leaps place significant demands on a dancer’s body. Takeoff involves greater demands on the more distal joints and requires more braking forces, while the landing phase involves greater demands on the more proximal joints of the lower extremity and requires the dancer to absorb more vertical force. These demands, combined with extensive repetition of movements during training, may contribute to the high number of chronic injuries seen in dance.

2015 ◽  
Vol 47 (1) ◽  
pp. 9-17 ◽  
Author(s):  
Jonathan Sinclair ◽  
Stephen Atkins ◽  
Jim Richards ◽  
Hayley Vincent

Abstract Research interest in barefoot running has expanded considerably in recent years, based around the notion that running without shoes is associated with a reduced incidence of chronic injuries. The aim of the current investigation was to examine the differences in the forces produced by different skeletal muscles during barefoot and shod running. Fifteen male participants ran at 4.0 m·s-1 (± 5%). Kinematics were measured using an eight camera motion analysis system alongside ground reaction force parameters. Differences in sagittal plane kinematics and muscle forces between footwear conditions were examined using repeated measures or Freidman’s ANOVA. The kinematic analysis showed that the shod condition was associated with significantly more hip flexion, whilst barefoot running was linked with significantly more flexion at the knee and plantarflexion at the ankle. The examination of muscle kinetics indicated that peak forces from Rectus femoris, Vastus medialis, Vastus lateralis, Tibialis anterior were significantly larger in the shod condition whereas Gastrocnemius forces were significantly larger during barefoot running. These observations provide further insight into the mechanical alterations that runners make when running without shoes. Such findings may also deliver important information to runners regarding their susceptibility to chronic injuries in different footwear conditions.


Author(s):  
Inje Lee ◽  
Sunghe Ha ◽  
Seongok Chae ◽  
Hee Seong Jeong ◽  
Sae Yong Lee

Abstract Context: Because motions of one segment affect those of an adjacent segment, biomechanical studies must thoroughly investigate the kinematics and kinetics of the proximal joint as well as the ankle joints in patients with chronic ankle instability (CAI). However, there have been few investigations on the altered movement strategies of the lower extremities of patients with CAI compared with lateral ankle sprain (LAS) copers and controls throughout the full gait cycle of walking and jogging. Objective: To investigate biomechanical differences of the lower extremity in those with CAI, LAS copers, and controls during gait. Design: Case-control study. Setting: Controlled laboratory setting. Patients or Other Participants: Eighteen individuals with CAI (age: 24.6 ± 2.8, height: 173.0 ± 8.0, weight: 67.8 ± 14.6), eighteen LAS copers (age: 26.0 ± 4.6, height: 173.4 ± 7.5, weight: 66.9 ± 10.3), and eighteen controls (age: 26.2 ± 2.3, height: 172.2 ± 8.2, weight: 63.3 ± 11.2). Main Outcome Measure(s): Three-dimensional (3D) kinematics and kinetics of the lower extremity during walking and jogging. Results: Individuals with CAI exhibited dorsiflexion deficits and greater inverted ankles, compared with LAS copers and controls, during walking and jogging. In addition, LAS copers generated greater knee internal rotator moments than individuals with CAI. There were no differences in other variables between groups. Conclusions: Given the results from this study, participants with CAI demonstrated altered biomechanics, which needs addressing through intervention programs.


2021 ◽  
Vol 9 (7) ◽  
pp. 232596712110152
Author(s):  
Lucas G. Teske ◽  
Edward C. Beck ◽  
Garrett S. Bullock ◽  
Kristen F. Nicholson ◽  
Brian R. Waterman

Background: Although lower extremity biomechanics has been correlated with traditional metrics among baseball players, its association with advanced statistical metrics has not been evaluated. Purpose: To establish normative biomechanical parameters during the countermovement jump (CMJ) among Major League Baseball (MLB) players and evaluate the relationship between CMJ-developed algorithms and advanced statistical metrics. Study Design: Cohort study; Level of evidence, 3. Methods: MLB players in 2 professional organizations performed the CMJ at the beginning of each baseball season from 2013 to 2017. We collected ground-reaction force data including the eccentric rate of force development (“load”), concentric vertical force (“explode”), and concentric vertical impulse (“drive”) as well as the Sparta Score. The advanced statistical metrics from each baseball season (eg, fielding independent pitching [FIP], weighted stolen base runs [wSB], and weighted on-base average) were also gathered for the study participants. The minimal detectable change (MDC) was calculated for each CMJ variable to establish normative parameters. Pearson coefficient analysis and regression trees were used to evaluate associations between CMJ data and advanced statistical metrics for the players. Results: A total of 151 pitchers and 138 batters were included in the final analysis. The MDC for “load,” “explode,” “drive,” and the Sparta Score was 10.3, 8.1, 8.7, and 4.6, respectively, and all demonstrated good reliability (intraclass correlation coefficient > 0.75). There was a weak but statistically significant correlation between the Sparta Score and wSB ( r = 0.23; P = .007); however, there were no significant correlations with any other advanced metrics. Regression trees demonstrated superior FIP with higher Sparta Scores in older pitchers compared with younger pitchers. Conclusion: There was a positive but weak correlation between the Sparta Score and base-stealing performance among professional baseball players. Additionally, older pitchers with a higher Sparta Score had statistically superior FIP compared with younger pitchers with a similar Sparta Score after adjusting for age.


2017 ◽  
Vol 33 (1) ◽  
pp. 56-63 ◽  
Author(s):  
D.S. Blaise Williams ◽  
Jonathan H. Cole ◽  
Douglas W. Powell

Running during sports and for physical activity often requires changes in velocity through acceleration and deceleration. While it is clear that lower extremity biomechanics vary during these accelerations and decelerations, the work requirements of the individual joints are not well understood. The purpose of this investigation was to measure the sagittal plane mechanical work of the individual lower extremity joints during acceleration, deceleration, and steady-state running. Ten runners were compared during acceleration, deceleration, and steady-state running using three-dimensional kinematics and kinetics measures. Total positive and negative joint work, and relative joint contributions to total work were compared between conditions. Total positive work progressively increased from deceleration to acceleration. This was due to greater ankle joint work during acceleration. While there was no significant change in total negative work during deceleration, there was a greater relative contribution of the knee to total negative work with a subsequent lower relative ankle negative work. Each lower extremity joint exhibits distinct functional roles in acceleration compared with deceleration during level running. Deceleration is dominated by greater contributions of the knee to negative work while acceleration is associated with a greater ankle contribution to positive work.


2015 ◽  
Vol 9 (1) ◽  
pp. 103-107 ◽  
Author(s):  
L Yin ◽  
D Sun ◽  
Q.C Mei ◽  
Y.D Gu ◽  
J.S Baker ◽  
...  

Large number of studies showed that landing with great impact forces may be a risk factor for knee injuries. The purpose of this study was to illustrate the different landing loads to lower extremity of both genders and examine the relationships among selected lower extremity kinematics and kinetics during the landing of a stop-jump task. A total of 35 male and 35 female healthy subjects were recruited in this study. Each subject executed five experiment actions. Lower extremity kinematics and kinetics were synchronously acquired. The comparison of lower extremity kinematics for different genders showed significant difference. The knee and hip maximum flexion angle, peak ground reaction force and peak knee extension moment have significantly decreased during the landing of the stop-jump task among the female subjects. The hip flexion angle at the initial foot contact phase showed significant correlation with peak ground reaction force during landing of the stop-jump task (r=-0.927, p<0.001). The knee flexion angle at the initial foot contact phase had significant correlation with peak ground reaction force and vertical ground reaction forces during landing of the stop-jump task (r=-0.908, p<0.001; r=0.812, P=0.002). A large hip and knee flexion angles at the initial foot contact with the ground did not necessarily reduce the impact force during landing, but active hip and knee flexion motions did. The hip and knee flexion motion of landing was an important technical factor that affects anterior cruciate ligament (ACL) loading during the landing of the stop-jump task.


2010 ◽  
Vol 26 (4) ◽  
pp. 444-453 ◽  
Author(s):  
Joshua T. Weinhandl ◽  
Mukta Joshi ◽  
Kristian M. O’Connor

The increased number of women participating in sports has led to a higher knee injury rate in women compared with men. Among these injuries, those occurring to the ACL are commonly observed during landing maneuvers. The purpose of this study was to determine gender differences in landing strategies during unilateral and bilateral landings. Sixteen male and 17 female recreational athletes were recruited to perform unilateral and bilateral landings from a raised platform, scaled to match their individual jumping abilities. Three-dimensional kinematics and kinetics of the dominant leg were calculated during the landing phase and reported as initial ground contact angle, ranges of motion (ROM) and peak moments. Lower extremity energy absorption was also calculated for the duration of the landing phase. Results showed that gender differences were only observed in sagittal plane hip and knee ROM, potentially due to the use of a relative drop height versus the commonly used absolute drop height. Unilateral landings were characterized by significant differences in hip and knee kinematics that have been linked to increased injury risk and would best be classified as “stiff” landings. The ankle musculature was used more for impact absorption during unilateral landing, which required increased joint extension at touchdown and may increase injury risk during an unbalanced landing. In addition, there was only an 11% increase in total energy absorption during unilateral landings, suggesting that there was a substantial amount of passive energy transfer during unilateral landings.


2017 ◽  
Vol 22 (4) ◽  
pp. 51-57 ◽  
Author(s):  
Adam B. Rosen ◽  
Jupil Ko ◽  
Kathy J. Simpson ◽  
Cathleen N. Brown

Patellar tendinopathy is often managed with a patellar tendon strap, however, their effectiveness is unsubstantiated. The purpose of this study was to determine if straps altered pain or lower extremity kinetics of individuals with patellar tendinopathy during landing. Thirty participants with patellar tendinopathy and 30 controls completed drop jumps with and without patellar tendon straps. Wearing the strap, tendinopathy participants demonstrated significantly decreased pain and reduced knee adductor moment; all participants displayed significantly decreased anterior ground reaction force while wearing a strap. Patellar tendon strapping may reduce pain due to alterations in direction and magnitude of loading.


2013 ◽  
Vol 38 ◽  
pp. 23-31 ◽  
Author(s):  
Gavin L. Moir ◽  
Kyle F. Erny ◽  
Shala E. Davis ◽  
John J. Guers ◽  
Chad A. Witmer

Abstract The purpose of the present study was to develop a repetition-load scheme for the eccentric-only bench press exercise. Nine resistance trained men (age: 21.6 ± 1.0 years; 1-repetition maximum [RM] bench press: 137.7 ± 30.4 kg) attended four testing sessions during a four week period. During the first session each subject’s 1-RM bench press load utilizing the stretch-shortening cycle was determined. During the remaining sessions they performed eccentric-only repetitions to failure using supra-maximal loads equivalent to 110%, 120% and 130% of their 1-RM value with a constant cadence (30 reps·min-1). Force plates and a three dimensional motion analysis system were used during these final three sessions in order to evaluate kinematic and kinetic variables. More repetitions were completed during the 110% 1-RM condition compared to the 130% 1-RM condition (p=0.01). Mean total work (p=0.046) as well as vertical force (p=0.049), vertical work (p=0.017), and vertical power output (p=0.05) were significantly greater during the 130% 1-RM condition compared to the 110% 1-RM condition. A linear function was fitted to the number of repetitions completed under each load condition that allowed the determination of the maximum number of repetitions that could be completed under other supra-maximal loads. This linear function predicted an eccentric-only 1-RM in the bench press with a load equivalent to 164.8% 1-RM, producing a load of 227.0 ± 50.0 kg. The repetition-load scheme presented here should provide a starting point for researchers to investigate the kinematic, kinetic and metabolic responses to eccentric-only bench press workouts.


Sign in / Sign up

Export Citation Format

Share Document