scholarly journals Pollution Performance of RTV Coated Insulators

2020 ◽  
Vol 8 (6S) ◽  
pp. 35-40
Keyword(s):  
Leakage Current ◽  
Room Temperature ◽  
Pollution Level ◽  
Test Results ◽  
Solid Layer ◽  
Hydrophobic Coatings ◽  
Layer Method ◽  
Pollution Accumulation ◽  
Insulator Flashover ◽  
Ceramic Insulators

Theincrease in power demand necessitates the usage of EHV and UHV transmission system. The growth of industries causes higher pollution level in the ambient condition on insulators. This increases the pollution severity of the site which results in pollution accumulation on the surface of Insulators. This causes flashover across insulator. Flashover across polluted insulators poses a serious threat to the reliability of the system and leads to system outages. There are many remedial measures to minimize the flashover of a porcelain insulator under pollution conditions. One such method is the application of hydrophobic coatings such as Room Temperature Vulcanizing Silicone Rubber on the surface of ceramic insulators. Laboratory testing of coated insulators has been carried out based on the solid layer method and by the inclined plane tests at constant voltage to evaluate the RTV coatings withstands capability against tracking and erosion. The performance of the coatings was assessed by monitoring the leakage current on the insulator surfaces. The applied voltage and leakage current were monitored throughout the tests. In order to optimize and economize the usage of RTV coatings various tests were performed and results are analyzed. It was possible to conclude from the test results that one fourth length of RTV coating is sufficient to withstand the pollution severity.

scholarly journals Effect of Substrate Plate Heating on the Microstructure and Properties of Selective Laser Melted Al-20Si-5Fe-3Cu-1Mg Alloy

Materials ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 330
Author(s):  
Pan Ma ◽  
Pengcheng Ji ◽  
Yandong Jia ◽  
Xuerong Shi ◽  
Zhishui Yu ◽  
...  
Keyword(s):  
Room Temperature ◽  
Internal Stresses ◽  
Test Results ◽  
Laser Melting ◽  
Microstructure And Properties ◽  
Uniform Microstructure ◽  
Heat Treated ◽  
Fine Microstructure ◽  
Plate Heating ◽  
Substrate Plate

The Al-20Si-5Fe-3Cu-1Mg alloy was fabricated using selective laser melting (SLM). The microstructure and properties of the as-prepared SLM, post-treated SLM, and SLM with substrate plate heating are studied. The as-prepared SLM sample shows a non-uniform microstructure with four different phases: fcc-αAl, eutectic Al-Si, Al2MgSi, and δ-Al4FeSi2. With thermal treatment, the phases become coarser and the δ-Al4FeSi2 phase transforms partially to β-Al5FeSi. The sample produced with SLM substrate plate heating shows a relatively uniform microstructure without a distinct difference between hatch overlaps and track cores. Room temperature compression test results show that an as-prepared SLM sample reaches a maximum strength (862 MPa) compared to the heat-treated (524 MPa) and substrate plate heated samples (474 MPa) due to the presence of fine microstructure and the internal stresses. The reduction in strength of the sample produced with substrate plate heating is due to the coarsening of the microstructure, but the plastic deformation shows an improvement (20%). The present observations suggest that substrate plate heating can be effectively employed not only to minimize the internal stresses (by impacting the cooling rate of the process) but can also be used to modulate the mechanical properties in a controlled fashion.

Study on Schottky Diode Characteristics Improving by X-Ray Irradiation

2013 ◽  
Vol 717 ◽  
pp. 113-116
Author(s):  
Sani Klinsanit ◽  
Itsara Srithanachai ◽  
Surada Ueamanapong ◽  
Sunya Khunkhao ◽  
Budsara Nararug ◽  
...  
Keyword(s):  
Leakage Current ◽  
Schottky Diode ◽  
Room Temperature ◽  
The Other ◽  
Low Power Consumption ◽  
Initial Value ◽  
X Ray ◽  
Forward Current ◽  
Current Voltage ◽  
Current Voltage Characteristics

The effect of soft X-ray irradiation to the Schottky diode properties was analyzed in this paper. The built-in voltage, leakage current, and work function of Schottky diode were investigated. The current-voltage characteristics of the Schottky diode are measured at room temperature. After irradiation at 70 keV for 55 seconds the forward current and leakage current are increase slightly. On the other hand, the built-in voltage is decrease from the initial value about 0.12 V. Consequently, this method can cause the Schottky diode has low power consumption. The results show that soft X-ray can improve the characteristics of Schottky diode.

Cryogenic Interlaminar Properties of PBO Fiber/Epoxy Composites

2011 ◽  
Vol 391-392 ◽  
pp. 1445-1449
Author(s):  
Chun Hua Zhang ◽  
Shi Lin Luan ◽  
Xiu Song Qian ◽  
Bao Hua Sun ◽  
Wen Sheng Zhang
Keyword(s):  
Liquid Nitrogen ◽  
Room Temperature ◽  
Liquid Nitrogen Temperature ◽  
Epoxy Composites ◽  
Bending Test ◽  
Test Results ◽  
Sem Images ◽  
Three Point Bending ◽  
Pbo Fiber ◽  
Interlaminar Shear

The influences of low temperature on the interlaminar properties for PBO fiber/epoxy composites have been studied at liquid nitrogen temperature (77 K) in terms of three point bending test. Results showed that the interlaminar shear strength at 77 K were significantly higher than those at room temperature (RT). For the analysis of the test results, the tensile behaviors of epoxy resin at both room temperature and liquid nitrogen temperature were investigated. The interface between fiber and matrix was observed using SEM images.

Reducing the leakage current for a CsPbBr3 detector via asymmetric area electrodes and heterostructures

2021 ◽  
Author(s):  
YingFeng Ruan ◽  
Pengju Guo ◽  
Zhiping Zheng ◽  
Qiuyun Fu ◽  
Rongda Zhou ◽  
...  
Keyword(s):  
Leakage Current ◽  
Room Temperature ◽  
Next Generation ◽  
Typical Representative ◽  
X Ray ◽  
Inorganic Lead ◽  
Halide Perovskites ◽  
Lead Halide

As a typical representative of all-inorganic lead halide perovskites, cesium lead bromine (CsPbBr3) has been regarded as the workhorse of next-generation room temperature X-ray detectors in recent years.

scholarly journals Monitoring System of The Temperature for Mini Fish Storage using Internet of Things

2021 ◽  
Vol 324 ◽  
pp. 01011
Author(s):  
Eko Prayetno ◽  
Tonny Suhendra ◽  
Jeremya Lukmanto Saputra
Keyword(s):  
Internet Of Things ◽  
Human Brain ◽  
Monitoring System ◽  
Room Temperature ◽  
High Protein ◽  
Test Results ◽  
Error Level ◽  
The Right ◽  
Monitoring Temperature

Fish is one of the high-protein foods that are very helpful for the development of the human brain. Then, it is necessary to maintain the freshness of the fish for consumption. At this time, fishers and fishmongers preserve the freshness of fish by using Ice in the fish storage. However, it is considered ineffective due to improper ice change time. Therefore, monitoring temperature is very important and helpful to find the right time when replacing the Ice used to ensure the quality of fish. The development of this device uses Arduino ESP32, DHT21 Sensor, Micro SD Module, Internet of Things system, monitoring using Blynk Application and notifications using Telegram App. DHT21 sensor test results obtained a data conformity level (Error Level) of 2%. At the fish storage room temperature, there is the lowest temperature of 10.50 oC and ice temperature conditions in the storage of 0 oC. Therefore, the best state to keep fish fresh that researchers want is 0 oC to 2 oC at ice temperatures or 11.50 oC obtained in testing the time it takes to replace Ice by about 10 hours.

scholarly journals EFFEKTIVITAS MIKROKAPSUL OLEORESIN FULI PALA (Myristica fragrans HOUTT) SEBAGAI PENGAWET DAGING AYAM BROILER

2020 ◽  
Vol 25 (1) ◽  
pp. 52
Author(s):  
Alston Millan
Keyword(s):  
Water Content ◽  
Broiler Chicken ◽  
Room Temperature ◽  
Ph Value ◽  
Chicken Meat ◽  
Test Results ◽  
Coating Technology ◽  
Randomized Design ◽  
Myristica Fragrans Houtt ◽  
Solid Liquid

Nutmeg oleoresin microcapsule is the solid, liquid, and gas coating technology of the nutmeg fruit.  The purpose of this study was to know how mace nutmeg oleoresin microcapsules could preserve the broiler chicken meat at room temperature during 4 days of observation. The experimental design used was a Completely Randomized Design (CRD) consisting of 5 treatments with mace concentration of nutmeg microcapsules oleoresin (0, 50, 100, 150, and 200) ppm. The variables observed were water content, pH value, total microbes, and organoleptic properties (color, aroma, and texture). The results showed that mace nutmeg oleoresin microcapsules did not affect (p> 0.05)  water content and sensory properties of broiler chicken meat, but had a significant effect (p <0.05) on the pH value and total microbe at the same day of room temperature storage. Panel organoleptic test results on the level of preference for meat color, aroma, and texture of chicken meat were in the range score of 3 (somewhat like) to 4 (somewhat dislike). The treatments of nutmeg oleoresin did not affect (p> 0.05) on color, the aroma, and the texture of broiler chicken meat. This research shows that marinating using oleoresin microcapsules has not been effective as a preservative to broiler chicken meat at room temperature. Keywords: chicken meat, mace nutmeg oleoresin microcapsules

scholarly journals A Preliminary Study on the Physical Properties of an Alternative Coarse Aggregate Made with Red Soil and Fly Ash

2018 ◽  
Vol 12 (1) ◽  
pp. 1-8
Author(s):  
J. Bright Brabin Winsley ◽  
M. Muthukannan
Keyword(s):  
Fly Ash ◽  
Specific Gravity ◽  
Room Temperature ◽  
Coarse Aggregate ◽  
Environmental Issues ◽  
Red Soil ◽  
Test Results ◽  
Ordinary Concrete ◽  
Preliminary Study ◽  
Natural Aggregates

Background and Objective: The demand for course aggregate is increasing every day. Natural aggregate used for ordinary concrete is obtained by quarrying, which cause serious environmental issues. An alternate course aggregate is needed for sustainable development. The objective of this research is to produce an alternative course aggregate in combination with soil available locally near site along with fly ash, to test its properties to make it fit for concrete. Method: An alternative coarse aggregate is produced from red soil and fly ash mixed at various ratios, 100:0, 90:10, 80:20, 70:30, 60:40, 50:50, fresh aggregate granules of different sizes less than 10mm is prepared using hand press, the aggregates were sundried in shade for 24hours, oven dried at 110°C, burned in Muffle furnace at temperature of 950°C and cooled gradually to reach room temperature. After the production, the specific gravity, bulk density, water absorption, Impact and aggregate crushing of the aggregates were tested. Result: Test results showed that aggregates produced are of lesser specific gravity, density with relatively appreciable impact value and crushing value. Conclusion: The test results show that the aggregates produced can be used in construction as replacement for natural aggregates.

3 kV Normally-Off 4H-SiC Buried Gate Static Induction Transistors (SiC-BGSITs)

2014 ◽  
Vol 778-780 ◽  
pp. 899-902 ◽  
Author(s):  
Akio Takatsuka ◽  
Yasunori Tanaka ◽  
Koji Yano ◽  
Norio Matsumoto ◽  
Tsutomu Yatsuo ◽  
...  
Keyword(s):  
Leakage Current ◽  
Leakage Current Density ◽  
Current Density ◽  
Threshold Voltage ◽  
Room Temperature ◽  
Fabrication Process ◽  
Drain Voltage ◽  
Static Induction Transistors ◽  
Static Induction

3 kV normally-off SiC-buried gate static induction transistors (SiC-BGSITs) were fabricated by using an innovative fabrication process that was used by us previously to fabricate 0.7–1.2 kV SiC-BGSITs. The fabricated device shows the lowest specific on-resistance of 9.16 mΩ·cm2, compared to all other devices of the same class. The threshold voltage of this device was 1.4 V at room temperature and was maintained at values more than 1 V with normally-off characteristics at 200 °C. The device can block drain voltage of 3 kV with a leakage current density of 6.9 mA/cm2.

Tuning the magnetic phase transition above room temperature through Fe and Mn modification in gallium ferrite with reduced leakage current

2020 ◽  
Vol 53 (22) ◽  
pp. 225001
Author(s):  
Sita Dugu ◽  
Shalini Kumari ◽  
Dhiren K Pradhan ◽  
Claudia Zuluaga Gómez ◽  
Mikel Holcomb ◽  
...  
Keyword(s):  
Phase Transition ◽  
Leakage Current ◽  
Magnetic Phase Transition ◽  
Room Temperature ◽  
Magnetic Phase ◽  
Fe And Mn
Sign in / Sign up

Export Citation Format

Share Document