Capillary electrophoresis-UV analysis using silica-layer coated capillary for separation of seven phenolic acids and caffeine and its application to tea analysis

This work presents an innovative silica-layer coated capillary with comparison study of the silica-layer coated capillary and the fused-silica capillary for the separation of seven phenolic acids viz. p-hydroxyphenylacetic acid (PHPA), p-coumaric acid (PCA), p-hydroxybenzoic acid (PHBA), caffeic acid (CFA), (3,4-dihydroxyphenyl)acetic acid (DHPA), gallic acid (GLA), and 2,3,4-trihydroxybenzoic acid (THBA), together with caffeine (CF), by capillary electro-chromatography (CEC) and micellar electrokinetic chromatography (MEKC), respectively. The running buffer was 25.0 mM borate at pH 9.0, with addition of 50.0 mM sodium dodecyl sulfate for the MEKC mode. The non-coated capillary could not separate all seven phenolic acids by CEC or MEKC. This was achieved using the coated capillary for both CEC and MEKC. The innovative coated capillary with CEC had plate number N ≥ 2.0 × 104 m−1 and resolution Rs ≥ 1.6 for all adjacent pairs of peaks. The capillary was also able to separate GLA and THBA which are structural isomers. Although MEKC mode provided comparable efficiency and selectivity, the reduced EOF of the coated capillary led to longer separation time. The linear calibration range of the seven phenolic acids and caffeine were different but the coefficients of determinations (r2) were all > 0.9965. The precisions of the relative migration times and peak area ratios of analyte to internal standard were 0.1–1.8% and 1.8–6.8%, respectively. There were no statistical differences in the efficiency of separation of the phenolic acids and caffeine for three coated capillaries. It was applied to the analysis of caffeine and phenolic acids in brewed tea using tyramine as the internal standard. The tea samples were diluted prior to analysis by CEC. The separation was less than 15 min. Caffeine, gallic acid and p-coumaric acid were detected and quantified. Caffeine and gallic acid contents were 10.8–15.0 and 2.6–4.8 mg g−1 dry tea leaves, respectively. p-Coumaric acid was detected in only one of the samples with a content of 0.4 mg g−1. Percent recoveries of spiked diluted samples were 90 ± 9 to 106 ± 13%, respectively. Article highlights Silica-layer coated capillary is first reported for simultaneous separation of seven phenolic acids by non-MEKC analysis. Performance between coated, and non-coated capillaries with analysis by CEC and MEKC were compared. Plate number, resolution, capillary reproducibility, and electroosmotic flow mobility are investigated. Graphical abstract

Functionalization of Graphene Oxide with Polysilicone: Synthesis, Characterization, and Its Flame Retardancy in Epoxy Resin

A novel polysilicone flame retardant (PMDA) has been synthesized and covalently grafted onto the surfaces of graphene oxide (GO) to obtain GO-PMDA. The chemical structure and morphology of GO-PMDA was characterized and confirmed by the Fourier transform infrared (FTIR) spectroscopy, X-ray photoelectron spectrometer (XPS), atomic force microscope (AFM), and thermogravimetric analysis (TGA). The results of dynamic mechanical analysis (DMA) indicated that the grafting of PMDA improved the dispersion and solubility of GO sheets in the epoxy resin (EP) matrix. The TGA and cone calorimeter measurements showed that compared with the GO, GO-PMDA could significantly improve the thermal stability and flame retardancy of EP. In comparison to pure EP, the peak heat release rate (pHRR) and total heat release (THR) of EP/GO-PMDA were reduced by 30.5% and 10.0% respectively. This greatly enhanced the flame retardancy of EP which was mainly attributed to the synergistic effect of GO-PMDA. Polysilicone can create a stable silica layer on the char surface of EP, which reinforces the barrier effect of graphene.

Super Magnetic Niosomal Nanocarrier as a New Approach for Treatment of Breast Cancer: A Case Study on SK-BR-3 and MDA-MB-231 Cell Lines

In the present study, a magnetic niosomal nanocarrier for co-delivery of curcumin and letrozole into breast cancer cells has been designed. The magnetic NiCoFe2O4 core was coated by a thin layer of silica, followed by a niosomal structure, allowing us to load letrozole and curcumin into the silica layer and niosomal layer, respectively, and investigate their synergic effects on breast cancer cells. Furthermore, the nanocarriers demonstrated a pH-dependent release due to the niosomal structure at their outer layer, which is a promising behavior for cancer treatment. Additionally, cellular assays revealed that the nanocarriers had low cellular uptake in the case of non-tumorigenic cells (i.e., MCF-10A) and related high viability but high cellular uptake in cancer cell lines (i.e., MDA-MB-231 and SK-BR-3) and related low viability, which is evidenced in their high cytotoxicity against different breast cancer cell lines. The cytotoxicity of the letrozole/curcumin co-loaded nanocarrier is higher than that of the aqueous solutions of both drugs, indicating their enhanced cellular uptake in their encapsulated states. In particular, NiCoFe2O4@L-Silica-L@C-Niosome showed the highest cytotoxicity effects on MDA-MB-231 and SK-BR-3 breast cancer cells. The observed cytotoxicity was due to regulation of the expression levels of the studied genes in breast cancer cells, where downregulation was observed for the Bcl-2, MMP 2, MMP 9, cyclin D, and cyclin E genes while upregulation of the expression of the Bax, caspase-3, and caspase-9 genes was observed. The flow cytometry results also revealed that NiCoFe2O4@L-Silica-L@C-Niosome enhanced the apoptosis rate in both MDA-MB-231 and SK-BR-3 cells compared to the control samples. The findings of our research show the potential of designing magnetic niosomal formulations for simultaneous targeted delivery of both hydrophobic and hydrophilic drugs into cancer cells in order to enhance their synergic chemotherapeutic effects. These results could open new avenues into the future of nanomedicine and the development of theranostic agents.

A Magnetic Nanocomposite Modifier for Improved Ultrasensitive Detection of Hexavalent Chromium in Water Samples

In this work, different electrodes were employed for the determination of Cr(VI) by the cathodic square‑wave voltammetry (SWV) technique and the square-wave adsorptive stripping voltammetry (SWAdSV) technique in combination with diethylenetriaminepentaacetic acid. Using SWV, a comparison of the analytical performance of the bare glassy carbon electrode (GCE), ex situ electrodes (antimony-film—SbFE, copper-film—CuFE, and bismuth-film—BiFE), and the GCE modified with a new magnetic nanocomposite (MNC) material was performed. First, the MNC material was synthesized, i.e., MNPs@SiO2@Lys, where MNPs stands for magnetic maghemite nanoparticles, coated with a thin amorphous silica (SiO2) layer, which was additionally functionalized with derived lysine (Lys). The crystal structure of the prepared MNCs was confirmed by X-ray powder diffraction (XRD), while the morphology and nano-size of the MNCs were investigated by field emission scanning electron microscopy (FE-SEM) and transmission electron microscopy (TEM), where TEM was additionally used to observe the MNP core and silica layer thickness. The presence of functional groups of the MNCs was investigated by attenuated total reflection Fourier transform infrared spectroscopy (ATR-FTIR) and surface analysis was performed by X-ray photoelectron spectroscopy (XPS). The hydrophilicity of the modified electrodes was also tested by static contact angle measurements. Then, MNPs@SiO2@Lys was applied onto the electrodes and used with the SWV and SWAdSV techniques. All electrodes tested with the SWV technique were effective for Cr(VI) trace determination. On the other hand, the SWAdSV technique was required for ultra-trace determination of Cr(VI). Using the SWAdSV technique, it was shown that a combination of ex situ BiFE with the deposited MNPs@SiO2@Lys resulted in excellent analytical performance (LOQ = 0.1 µg/L, a linear concentration range of 0.2–2.0 µg/L, significantly higher sensitivity compared to the SWV technique, an RSD representing reproducibility of 9.0%, and an average recovery of 98.5%). The applicability of the latter system was also demonstrated for the analysis of a real sample.

Demonstration of Tunable Fano Resonances In A Meta-Material Absorber Composed of Asymmetric Double Bars With Bent Arms

In this paper a Metal-Insulator-Metal (MIM) plasmonic absorber consisting of asymmetric double bars with bent arms located on top of a silica layer coated on a metal film is proposed, and its resonant features are analyzed. The suggested structure supports both Fano and dipole perfect absorption resonances at the Near-Infrared Region (NIR). The asymmetry introduced into the structure can be induced by changing the bending angle or rotation angle of one of the antennas while the other one remains fixed. Simulation results demonstrate that by applying both asymmetry factors to the structure, one can have two individual Fano peaks at the same time. It is shown that the magnitude, central wavelength and line-width of the Fano peaks are adjustable by controlling the geometrical parameters of the structure. It is also indicated that, the quality factor (Q-factor) of the Fano resonance is inversely related to the degree of asymmetry introduced into the structure. According to the simulations, an ultra-narrow resonance peak with a bandwidth of 1.87 nm at the wavelength of 710 nm (corresponding to a Q-factor of 387) can be obtained by controlling the geometrical parameters. It is also discussed that, the absorptivity of Fano and the dipole peaks can be adjusted inversely, by manipulating the grapheme chemical potential. The ratio of the absorptivity to the chemical potential of graphene about-275 %/eV and 226 %/eV is calculated for the Fano peak and dipole peak, respectively. Accordingly, the presented structure is an adjustable NIR absorber with a fully tunable absorption spectrum which can be utilized in various applications from tunable reflectors and photo-detectors to ultra-narrowband and broadband optical modulators.

Deposition of a SiO2 Shell of Variable Thickness and Chemical Composition to Carbonyl Iron: Synthesis and Microwave Measurements

Protective SiO2 coating deposited to iron microparticles is highly demanded both for the chemical and magnetic performance of the latter. Hydrolysis of tetraethoxysilane is the crucial method for SiO2 deposition from a solution. The capabilities of this technique have not been thoroughly studied yet. Here, two factors were tested to affect the chemical composition and the thickness of the SiO2 shell. It was found that an increase in the hydrolysis reaction time thickened the SiO2 shell from 100 to 200 nm. Moreover, a decrease in the acidity of the reaction mixture not only thickened the shell but also varied the chemical composition from SiO3.0 to SiO8.6. The thickness and composition of the dielectric layer were studied by scanning electron microscopy and energy-dispersive X-ray analysis. Microwave permeability and permittivity of the SiO2-coated iron particles mixed with a paraffin wax matrix were measured by the coaxial line technique. An increase in thickness of the silica layer decreased the real quasi-static permittivity. The changes observed were shown to agree with the Maxwell Garnett effective medium theory. The new method developed to fine-tune the chemical properties of the protective SiO2 shell may be helpful for new magnetic biosensor designs as it allows for biocompatibility adjustment.

Reduced Self-Aggregation and Improved Stability of Silica-Coated Fe3O4/Ag SERS-Active Nanotags Functionalized With 2-Mercaptoethanesulfonate

Nanocomposites combining magnetic and plasmonic properties are very attractive within the field of surface-enhanced Raman scattering (SERS) spectroscopy. Applications presented so far take advantage of not only the cooperation of both components but also synergy (enhanced properties), leading to multi-approach analysis. While many methods were proposed to synthesize such plasmonic-magnetic nanoparticles, the issue of their collective magnetic behavior, inducing irreversible self-aggregation, has not been addressed yet. Thus, here we present a simple and fast method to overcome this problem, employing 2-mercaptoethanesulfonate (MES) ions as both a SERS tag and primer molecules in the silica-coating process of the previously fabricated Fe3O4/Ag nanocomposite. The use of MES favored the formation of silica-coated nanomaterial comprised of well-dispersed small clusters of Fe3O4/Ag nanoparticles. Furthermore, adsorbed MES molecules provided a reliable SERS response, which was successfully detected after magnetic assembly of the Fe3O4/Ag@MES@SiO2 on the surface of the banknote. Improved chemical stability after coating with a silica layer was also found when the nanocomposite was exposed to suspension of yeast cells. This work reports on the application of 2-mercaptoethanesulfonate not only providing a photostable SERS signal due to a non-aromatic Raman reporter but also acting as a silica-coating primer and a factor responsible for a substantial reduction of the self-aggregation of the plasmonic-magnetic nanocomposite. Additionally, here obtained Fe3O4/Ag@MES@SiO2 SERS nanotags showed the potential as security labels for the authentication purposes, retaining its original SERS performance after deposition on the banknote.