lithium aluminium
Recently Published Documents


TOTAL DOCUMENTS

507
(FIVE YEARS 18)

H-INDEX

30
(FIVE YEARS 1)

2022 ◽  
Vol 575 ◽  
pp. 121214
Author(s):  
Osama Bagi Aljewaw ◽  
Muhammad Khalis Abdul Karim ◽  
Halimah Mohamed Kamari ◽  
Mohd Hafiz Mohd Zaid ◽  
Ali Aqeel Salim ◽  
...  

Materials ◽  
2021 ◽  
Vol 14 (23) ◽  
pp. 7321
Author(s):  
Agata Stempkowska

The aim of the research was to check whether the system of three fluxes based on lithium aluminium silicate and alkali feldspars has a eutectic point, i.e., with the lowest melting temperature. Lithium was introduced into the mixtures in the form of petalite, which occurs naturally in nature (Bikita Zimbabwe deposit). Using naturally occurring raw materials such as petalite, sodium feldspar, and potassium feldspar, an attempt was made to obtain eutectics with the lowest melting point to facilitate thermal processing of the mineral materials. In addition, the high-temperature viscosity of the mineral alloys and physical parameters such as density, linear shrinkage, and open porosity were studied. The study showed that in these systems, there is one three-component eutectic at 1345 °C, with the lowest viscosity of 1·105 Pas and the highest density of 2.34g/cm3, with a weight content of petalite 20%, sodium feldspar 20%, and potassium feldspar 20%.


2021 ◽  
Author(s):  
◽  
Sujay Prabakar

<p>This thesis is concerned with the synthesis and characterization of nanostructured materials in the solution, in particular silicon and germanium nanocrystals, their applica-tion as fluorescent whitening agents and titanium disulphide nanostructures. The aim of this research with regards to the synthesis of silicon and germanium nanocrystals was to obtain size control and provide functionality using simple room temperature solution techniques. In the case of the nanostructures of titanium disulphide, the focus was to synthesize in the colloid using simple one-pot bench top techniques. The above were realized with chemical techniques in the solution using organic solvents and surfactants to control their size. The morphology, chemical composition and crystal structure of the synthesized nanomaterials were characterized using techniques such as High Resolution Transmission Electron Microscopy (HRTEM), Selected Area Electron Diffraction (SAED), Scanning Electron Microscopy (SEM), Energy Dispersive X-Ray Spectrosco-py (EDX) and Optical Spectroscopies. Whilst chapter one is a brief introduction of the thesis, chapter two talks in detail about the various characterization techniques used in this research.  Chapter three of the thesis focuses on the synthesis of alkyl- and amine-functionalized silicon nanocrystals using a microemlusion technique. The effect of reducing agents, surfactants and precursors on particle size was studied. The surfactant C12E5 was found to be very effective in producing silicon nanocrystals that were freestanding and pure. Whilst the hydride reducing agents lithium aluminium hydride and lithium tri-ethyl borohydride were found to be effective in synthesizing nanocrystals of narrow size distribution, it was found that using silicon tetrachloride yielded smaller particles compared to silicon tetrabromide.  The fourth chapter in the theses is concerned with the synthesis and characterization of germanium nanocrystals by both microemulsion and high temperature techniques. Using lithium aluminium hydride; a strong reducing agent, very small nanocrystals were obtained, whilst weaker reductants such as sodium borohydride produced larger nano-crystals. Another effective method to control the particle size of germanium nanocrystals was found to be by varying the concentration of precursor. The germanium nanocrystals which were amine capped were found to luminesce in the blue and were used to image HePG2 cells. Toxicity studies on these nanocrystals proved their relative non-toxicity. The high temperature experiments, though not as flexible as the room temperature syntheses were found to facilitate a certain degree of size control.  Chapter five of the theses deal with the application of silicon and germanium nanocrys-tals as fluorescent whitening agents in wool fabrics. Both nanocrystals, when applied to the fabric were found to emit matching blue fluorescence that was demonstrated to be more suited to improving the brightness properties of fabric than the commercial fluo-rescing whitening agent Uvitex. In particular Silicon-amine and Silicon-hexene functionalized nanocrystal (low concentration) treated fabrics were found to have improved color stability against both UVA and UVB radiation. The treated fabrics were in addition found to maintain a stable color than untreated fabric. Silicon-amine treated fabrics were found to have a stable color even after 48h exposures to UVA radiation. It should be noted that this is the first evidence of the application of group IV semiconductor nanocrystals as fluorescing whitening agents.  The sixth chapter of this thesis deals with the one-pot synthesis of titanium disulphide nanostructures using both coordinating and non-coordinating solvents and their subse-quent characterization. By varying the injection temperature of the titanium source into the 1-Octadecene sulphur solution, two different morphologies were synthesized. Two different pathways were suggested for the formation of the flower-like and flake-like morphologies; an instant nucleation to form titanium disulphide flakes whilst spherical nuclei to form flower-like nanostructures. The flower-like nanostructures were found to have higher BET surface area compared to the flake-like nanostructures and previously reported surface areas for analogous TiS₂ nanostructures. Whilst using oleylamine as solvent, the low temperature injection yielded hollow spheres of TiS₂ and the high temperature injection, fullerene-like nanoparticles of TiS₂. The property of oleylamine to selectively bind to the nanostructure surface in conjunction with the effect of injection temperature was understood to be behind the growth of these nanostructures. The synthesis of flower-like and flake-like morphologies by solution phase techniques were the first evidence of this kind for titanium disulphide and provides a new and exciting material for a variety of applications.  A final chapter on conclusions and recommendations for future work is then presented.</p>


2021 ◽  
Author(s):  
◽  
Sujay Prabakar

<p>This thesis is concerned with the synthesis and characterization of nanostructured materials in the solution, in particular silicon and germanium nanocrystals, their applica-tion as fluorescent whitening agents and titanium disulphide nanostructures. The aim of this research with regards to the synthesis of silicon and germanium nanocrystals was to obtain size control and provide functionality using simple room temperature solution techniques. In the case of the nanostructures of titanium disulphide, the focus was to synthesize in the colloid using simple one-pot bench top techniques. The above were realized with chemical techniques in the solution using organic solvents and surfactants to control their size. The morphology, chemical composition and crystal structure of the synthesized nanomaterials were characterized using techniques such as High Resolution Transmission Electron Microscopy (HRTEM), Selected Area Electron Diffraction (SAED), Scanning Electron Microscopy (SEM), Energy Dispersive X-Ray Spectrosco-py (EDX) and Optical Spectroscopies. Whilst chapter one is a brief introduction of the thesis, chapter two talks in detail about the various characterization techniques used in this research.  Chapter three of the thesis focuses on the synthesis of alkyl- and amine-functionalized silicon nanocrystals using a microemlusion technique. The effect of reducing agents, surfactants and precursors on particle size was studied. The surfactant C12E5 was found to be very effective in producing silicon nanocrystals that were freestanding and pure. Whilst the hydride reducing agents lithium aluminium hydride and lithium tri-ethyl borohydride were found to be effective in synthesizing nanocrystals of narrow size distribution, it was found that using silicon tetrachloride yielded smaller particles compared to silicon tetrabromide.  The fourth chapter in the theses is concerned with the synthesis and characterization of germanium nanocrystals by both microemulsion and high temperature techniques. Using lithium aluminium hydride; a strong reducing agent, very small nanocrystals were obtained, whilst weaker reductants such as sodium borohydride produced larger nano-crystals. Another effective method to control the particle size of germanium nanocrystals was found to be by varying the concentration of precursor. The germanium nanocrystals which were amine capped were found to luminesce in the blue and were used to image HePG2 cells. Toxicity studies on these nanocrystals proved their relative non-toxicity. The high temperature experiments, though not as flexible as the room temperature syntheses were found to facilitate a certain degree of size control.  Chapter five of the theses deal with the application of silicon and germanium nanocrys-tals as fluorescent whitening agents in wool fabrics. Both nanocrystals, when applied to the fabric were found to emit matching blue fluorescence that was demonstrated to be more suited to improving the brightness properties of fabric than the commercial fluo-rescing whitening agent Uvitex. In particular Silicon-amine and Silicon-hexene functionalized nanocrystal (low concentration) treated fabrics were found to have improved color stability against both UVA and UVB radiation. The treated fabrics were in addition found to maintain a stable color than untreated fabric. Silicon-amine treated fabrics were found to have a stable color even after 48h exposures to UVA radiation. It should be noted that this is the first evidence of the application of group IV semiconductor nanocrystals as fluorescing whitening agents.  The sixth chapter of this thesis deals with the one-pot synthesis of titanium disulphide nanostructures using both coordinating and non-coordinating solvents and their subse-quent characterization. By varying the injection temperature of the titanium source into the 1-Octadecene sulphur solution, two different morphologies were synthesized. Two different pathways were suggested for the formation of the flower-like and flake-like morphologies; an instant nucleation to form titanium disulphide flakes whilst spherical nuclei to form flower-like nanostructures. The flower-like nanostructures were found to have higher BET surface area compared to the flake-like nanostructures and previously reported surface areas for analogous TiS₂ nanostructures. Whilst using oleylamine as solvent, the low temperature injection yielded hollow spheres of TiS₂ and the high temperature injection, fullerene-like nanoparticles of TiS₂. The property of oleylamine to selectively bind to the nanostructure surface in conjunction with the effect of injection temperature was understood to be behind the growth of these nanostructures. The synthesis of flower-like and flake-like morphologies by solution phase techniques were the first evidence of this kind for titanium disulphide and provides a new and exciting material for a variety of applications.  A final chapter on conclusions and recommendations for future work is then presented.</p>


2021 ◽  
Vol 1047 ◽  
pp. 90-96
Author(s):  
Chusak Choawarot ◽  
Vilailuck Siriwongrungson ◽  
Janjira Hongrapipat ◽  
Shu Sheng Pang ◽  
Michael Messner

Complex metal hydrides are one of the most effective hydrogen storage materials due to their unique property to absorb and desorb hydrogen with the hydrogen storage capacity of about 5-7 wt%. In this study, lithium aluminium hydride (LiAlH4) was coated on glass substrate using dip coating method. The coating conditions investigated were LiAlH4 concentrations of 6 g/l, 10 g/l and 20 g/l and post-annealing time from 0 to 60 min. Phase and grain size of the deposited LiAlH4 were analyzed using X-ray powder diffraction (XRD). Scanning electron microscope (SEM) was used for surface morphology analysis. The hydrogen storage capacity of the deposited thin films was analyzed using thermogravimetric analysis (TGA). The experimental results revealed that the phase of the deposited LiAlH4 thin films on glass substrate were mixed with lithium aluminium hydroxide hydrate (LiAl2(OH)7·2H2O) and lithium hexahydroaluminate (Li3AlH6). The intensity of the LiAl2(OH)7·2H2O and LiAlH4 peaks tends to decrease with increasing LiAlH4 concentration and post-annealing time while the intensity of the Li3AlH6 peaks increased with increasing LiAlH4 concentration and post-annealing time. The grain size was decreased with increasing LiAlH4 concentration and post-annealing time. The smaller grain size the better the hydrogen storage capacity. The hydrogen storage capacity of the deposited LiAlH4 thin film was increased from 0.124 wt % using LiAlH4 concentration of 6 g/l without post-annealing to 1.675 wt % using LiAlH4 concentration of 20 g/l with 60 min post-annealing time.


Materials ◽  
2021 ◽  
Vol 14 (15) ◽  
pp. 4334
Author(s):  
Agata Stempkowska

In this paper, the system of natural mineral alkali fluxes used in typical mineral industry technologies was analyzed. The main objective was to reduce the melting temperature of the flux systems. Particular attention was paid to the properties of lithium aluminium silicates in terms of simplifying and accelerating the heat treatment process. In this area, an alkaline flux system involving lithium was analyzed. A basic flux system based on sodium potassium lithium aluminosilicates was analyzed; using naturally occurring raw materials such as spodumene, albite and orthoclase, an attempt was made to obtain the eutectic with the lowest melting point. Studies have shown that there are two eutectics in these systems, with about 30% spodumene content. The active influence of sodium feldspar was found.


2021 ◽  
Vol 233 ◽  
pp. 117932
Author(s):  
P.O. Ike ◽  
D.E. Folley ◽  
K.K. Agwu ◽  
M.L. Chithambo ◽  
S. Chikwembani ◽  
...  

2021 ◽  
Author(s):  
Fangyu Xiong ◽  
Zhouyang Jiang ◽  
Shuangshaung Tan ◽  
Qinyou An

A room-temperature rechargeable dual-plating lithium-aluminium battery with high theoretical energy density is presented. Based on the aluminium plating/stripping and lithium stripping/plating occur in the cathode and anode sides, respectively, this...


Sign in / Sign up

Export Citation Format

Share Document