superparamagnetic properties
Recently Published Documents


TOTAL DOCUMENTS

110
(FIVE YEARS 30)

H-INDEX

17
(FIVE YEARS 3)

Nanomaterials ◽  
2022 ◽  
Vol 12 (2) ◽  
pp. 184
Author(s):  
Cody Landry ◽  
Alexander Morrison ◽  
Mehdi Esmaeili ◽  
Khashayar Ghandi

In this work, through a combination of photoluminescence spectroscopy, X-ray powder diffraction and magnetic measurements, it is determined that ZnO rods, made hydrothermally using a combination of magnetic field with respect to the force of gravity, exhibit superparamagnetic properties which emerge from Zn defects. These Zn defects result in a size-dependent superparamagnetic property of the rods. Red emissions, characteristic of Zn vacancies, and magnetic susceptibility both increased with decreasing rod size. The ZnO rods have significantly larger superparamagnetic cluster sizes (one order of magnitude) and lower fluctuation rates when compared to other superparamagnetic particles.


2022 ◽  
Author(s):  
Hussein. S.Mahmood ◽  
Tahseen. H. Mubarak ◽  
Sabah M. Ali Ridha ◽  
Jasim. Al-Zanganawee

Nanomaterials ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 3422
Author(s):  
Jin Soon Han ◽  
Gye Seok An

The rapid purification of biomaterials such as DNA, RNA, and antibodies has attracted extensive attention, and research interest has increased further with the COVID-19 pandemic. In particular, core–shell-structured superparamagnetic nanoparticles have been continuously studied for their application as biopurification materials. It has been reported that Fe3O4@SiO2 nanoparticles are one of the most promising candidates for separating nucleic acids via a simple and rapid process. This study proposed a fabrication method for dual-layered Fe3O4@SiO2 nanoparticles, in which the density of the SiO2 shell was controlled using an intermediate surfactant during the SiO2 coating. After the fabrication of dual-layered Fe3O4@SiO2 nanoparticles, structural, morphological, and magnetic analyses were conducted. The results showed that the Fe3O4 nanoparticles were surrounded by a dense layer 15.6~27.9 nm thick and a porous layer 24.2~44.4 nm thick, and had superparamagnetic properties with high saturated magnetization at room temperature (86.9 emu/g). Then, the optimal conditions for the biopurification material were suggested based on analysis of the selective separation of plasmid DNA.


Nanomaterials ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 3432
Author(s):  
Pedro Farinha ◽  
João M. P. Coelho ◽  
Catarina Pinto Reis ◽  
Maria Manuela Gaspar

Magnetic nanoparticles (MNPs) have been studied for diagnostic purposes for decades. Their high surface-to-volume ratio, dispersibility, ability to interact with various molecules and superparamagnetic properties are at the core of what makes MNPs so promising. They have been applied in a multitude of areas in medicine, particularly Magnetic Resonance Imaging (MRI). Iron oxide nanoparticles (IONPs) are the most well-accepted based on their excellent superparamagnetic properties and low toxicity. Nevertheless, IONPs are facing many challenges that make their entry into the market difficult. To overcome these challenges, research has focused on developing MNPs with better safety profiles and enhanced magnetic properties. One particularly important strategy includes doping MNPs (particularly IONPs) with other metallic elements, such as cobalt (Co) and manganese (Mn), to reduce the iron (Fe) content released into the body resulting in the creation of multimodal nanoparticles with unique properties. Another approach includes the development of MNPs using other metals besides Fe, that possess great magnetic or other imaging properties. The future of this field seems to be the production of MNPs which can be used as multipurpose platforms that can combine different uses of MRI or different imaging techniques to design more effective and complete diagnostic tests.


2021 ◽  
Vol 5 (1) ◽  
pp. 49
Author(s):  
Alice Mieting ◽  
Sitao Wang ◽  
Mia Schliephake ◽  
Daniela Franke ◽  
Margarita Guenther ◽  
...  

In this work, we present a template-based preparation of iron oxide-containing hydrogels (ferrogels) with ionic sensitive and superparamagnetic properties. The influence of the cross-linked template polyacrylamide and the concentration of the iron salts and sodium hydroxide on the precipitation of the iron oxide particles is investigated with respect to the stability of the ferrogels. Scanning electron microscope images show cubic particles, which can be semiquantitatively classified in three groups of particle size with respect to the dilution level. Magnetic hysteresis curves reveal a sigmoidal shape without remanence and coercivity for all samples. The higher cross-linked ferrogels, in comparison with the lower cross-linked ferrogels, possess a steady-state degree of swelling in ultrapure water and a stimuli-sensitive deswelling over a wide range of varying ionic strengths. Thus, they are suitable candidates for applications in sensing and microfluidics.


2021 ◽  
Vol 21 (11) ◽  
pp. 5493-5498
Author(s):  
Paulo Emilio Feuser ◽  
Camila Guindani ◽  
Jonathann Correa Possato ◽  
Jaqueline Pereira Guessi ◽  
Arthur Poester Cordeiro ◽  
...  

Nanomaterials, such as magnetic nanoparticles have attracted significant attention of medical area due to their capacity to improve the performance of immunoassays. Therefore the aim of this work was to study the bovine serum albumin (BSA) conjugation in superparamagnetic (MNPs)/poly(methyl methacrylate) (PMMA) nanoparticles with further characterization and application in enzyme-linked immunosorbent (ELISA) assay. The successful conjugation of BSA in MNPs- PMMA nanoparticles was confirmed by several techniques, including light scattering, zeta potential, transmission electron microscopy (TEM) and Lowry protein quantification assay. The superparamagnetic properties were confirmed by vibrating sample magnetometer. BSA conjugated MNPs-PMMA nanoparticles presented higher interactions with antibody than free BSA. The BSA + MNPs-PMMA nanoparticles (magnetic ELISA assay) reduced the time and increased the sensibility of traditional ELISA assay, reinforcing the idea that the use these nanomaterials are an excellent alternative for the immunoassays field.


2021 ◽  
Vol 118 (42) ◽  
pp. e2102340118
Author(s):  
He Wei ◽  
Agata Wiśniowska ◽  
Jingxuan Fan ◽  
Peter Harvey ◽  
Yuanyuan Li ◽  
...  

Magnetic nanoparticles are robust contrast agents for MRI and often produce particularly strong signal changes per particle. Leveraging these effects to probe cellular- and molecular-level phenomena in tissue can, however, be hindered by the large sizes of typical nanoparticle contrast agents. To address this limitation, we introduce single-nanometer iron oxide (SNIO) particles that exhibit superparamagnetic properties in conjunction with hydrodynamic diameters comparable to small, highly diffusible imaging agents. These particles efficiently brighten the signal in T1-weighted MRI, producing per-molecule longitudinal relaxation enhancements over 10 times greater than conventional gadolinium-based contrast agents. We show that SNIOs permeate biological tissue effectively following injection into brain parenchyma or cerebrospinal fluid. We also demonstrate that SNIOs readily enter the brain following ultrasound-induced blood–brain barrier disruption, emulating the performance of a gadolinium agent and providing a basis for future biomedical applications. These results thus demonstrate a platform for MRI probe development that combines advantages of small-molecule imaging agents with the potency of nanoscale materials.


Polymers ◽  
2021 ◽  
Vol 13 (19) ◽  
pp. 3240
Author(s):  
Tar-Hwa Hsieh ◽  
Lin-Chia Ho ◽  
Yen-Zen Wang ◽  
Ko-Shan Ho ◽  
Cheng-Hsien Tsai ◽  
...  

The hydrophilic initiator potassium persulfate (KPS) was converted into a hydrophobic molecule by complexing with cetyltrimethylammonium bromide (CTAB) at both ends of the molecule (CTAPSu). Inverse emulsion polymerization thus proceeded inside micelles dispersed in the affluent toluene with CTAPSu as the initiator. Polyaniline (PANI) formed inside the micelles and entangled with Fe3O4 nanoparticles already esterified with oleic acid (OA). Iron composites consisted of OA-esterified Fe3O4 nanoparticles covered with PANI after de-emulsification. After calcination at 950 °C in an argon atmosphere, the resultant iron compound was a mixture of α-Fe (ferrite) and Fe3C (cementite), as determined by X-ray diffraction. Eventually, the calcined iron compounds (mixtures) demonstrated superparamagnetic properties with a high saturation magnetization (Ms) of 197 emu/g, which decayed to 160 emu/g after exposure to the atmosphere for four months.


2021 ◽  
Vol 15 ◽  
pp. 165-171
Author(s):  
N. M. Bugaev ◽  
Ekaterina L. Kuznetsova ◽  
Kyaw Ye Ko

In this work, it is shown that the advantage of using matrix-stabilized magnetic nanoparticles to obtain polymer nanocomposites based on them is that such nanoparticles retain their dispersion and stability of size and shape in the technological modes of obtaining polymer nanocomposite materials, and thus ensured stable ferro- and superparamagnetic properties of the obtained target products. For the production of films by the method of hot pressing from blanks obtained in an injection molding machine or a mechanochemical mixture, a manual electrically heated hydraulic press was used. The magnetic properties of nanocomposite samples (about 50 mg on average) were studied using a vibration magnetometer. The character of the dependence of the magnetization on the magnitude of the magnetic field confirms the ferromagnetic character of the behavior of the obtained nanocomposites. The resulting film nanocomposites exhibit ferromagnetic properties at room temperature.


Materials ◽  
2021 ◽  
Vol 14 (18) ◽  
pp. 5154
Author(s):  
Marius Murariu ◽  
Armando Galluzzi ◽  
Yoann Paint ◽  
Oltea Murariu ◽  
Jean-Marie Raquez ◽  
...  

In the category of biopolymers, polylactide or polylactic acid (PLA) is one of the most promising candidates considered for future developments, as it is not only biodegradable under industrial composting conditions, but it is produced from renewable natural resources. The modification of PLA through the addition of nanofillers is considered as a modern approach to improve its main characteristic features (mechanical, thermal, barrier, etc.) and to obtain specific end-use properties. Iron oxide nanoparticles (NPs) of low dimension (10–20 nm) such as magnetite (Fe3O4), exhibit strong magnetization in magnetic field, are biocompatible and show low toxicity, and can be considered in the production of polymer nanocomposites requiring superparamagnetic properties. Accordingly, PLA was mixed by melt-compounding with 4–16 wt.% magnetite NPs. Surface treatment of NPs with a reactive polymethylhydrogensiloxane (MHX) was investigated to render the nanofiller water repellent, less sensitive to moisture and to reduce the catalytic effects at high temperature of iron (from magnetite) on PLA macromolecular chains. The characterization of nanocomposites was focused on the differences of the rheology and morphology, modification, and improvements in the thermal properties using surface treated NPs, while the superparamagnetic behavior was confirmed by VSM (vibrating sample magnetometer) measurements. The PLA−magnetite nanocomposites had strong magnetization properties at low magnetic field (values close to 70% of Mmax at H = 0.2 T), while the maximum magnetic signal (Mmax) was mainly determined by the loading of the nanofiller, without any significant differences linked to the surface treatment of MNPs. These bionanocomposites showing superparamagnetic properties, close to zero magnetic remanence, and coercivity, can be further produced at a larger scale by melt-compounding and can be designed for special end-use applications, going from biomedical to technical areas.


Sign in / Sign up

Export Citation Format

Share Document