A Semi-Physical Modeling of the Combustion Chamber and Inlet Manifold of a 2 MW Natural Gas Generation Engine

2020 ◽  
Vol 13 (1) ◽  
pp. 26
Author(s):  
Guillermo Valencia ◽  
Jorge Duarte Forero ◽  
Carlos Acevedo
Keyword(s):  
Natural Gas ◽  
Combustion Chamber ◽  
Physical Modeling ◽  
Gas Generation ◽  
Inlet Manifold

Effect of Chemical Hythane Composition on Pressure in Combustion Chamber of Engine

2019 ◽  
pp. 36-42
Author(s):  
A. P. Shaikin ◽  
I. R. Galiev
Keyword(s):  
Natural Gas ◽  
Combustion Chamber ◽  
Power Plants ◽  
Engine Speed ◽  
Combustion Engine ◽  
Fuel Mixture ◽  
Maximum Pressure ◽  
Chamber Volume ◽  
Excess Air ◽  
Scientific Papers

The article analyzes the influence of chemical composition of hythane (a mixture of natural gas with hydrogen) on pressure in an engine combustion chamber. A review of the literature has showed the relevance of using hythane in transport energy industry, and also revealed a number of scientific papers devoted to studying the effect of hythane on environmental and traction-dynamic characteristics of the engine. We have studied a single-cylinder spark-ignited internal combustion engine. In the experiments, the varying factors are: engine speed (600 and 900 min-1), excess air ratio and hydrogen concentration in natural gas which are 29, 47 and 58% (volume).The article shows that at idling engine speed maximum pressure in combustion chamber depends on excess air ratio and proportion hydrogen in the air-fuel mixture – the poorer air-fuel mixture and greater addition of hydrogen is, the more intense pressure increases. The positive effect of hydrogen on pressure is explained by the fact that addition of hydrogen contributes to increase in heat of combustion fuel and rate propagation of the flame. As a result, during combustion, more heat is released, and the fuel itself burns in a smaller volume. Thus, the addition of hydrogen can ensure stable combustion of a lean air-fuel mixture without loss of engine power. Moreover, the article shows that, despite the change in engine speed, addition of hydrogen, excess air ratio, type of fuel (natural gas and gasoline), there is a power-law dependence of the maximum pressure in engine cylinder on combustion chamber volume. Processing and analysis of the results of the foreign and domestic researchers have showed that patterns we discovered are applicable to engines of different designs, operating at different speeds and using different hydrocarbon fuels. The results research presented allow us to reduce the time and material costs when creating new power plants using hythane and meeting modern requirements for power, economy and toxicity.

scholarly journals Emissions Effects of Energy Storage for Frequency Regulation: Comparing Battery and Flywheel Storage to Natural Gas

Energies ◽  
2021 ◽  
Vol 14 (3) ◽  
pp. 549
Author(s):  
Eric Pareis ◽  
Eric Hittinger
Keyword(s):  
Energy Storage ◽  
Natural Gas ◽  
Fossil Fuels ◽  
Storage Systems ◽  
Storage System ◽  
The United States ◽  
Frequency Regulation ◽  
So2 Emissions ◽  
Gas Generation ◽  
Electrical Generation

With an increase in renewable energy generation in the United States, there is a growing need for more frequency regulation to ensure the stability of the electric grid. Fast ramping natural gas plants are often used for frequency regulation, but this creates emissions associated with the burning of fossil fuels. Energy storage systems (ESSs), such as batteries and flywheels, provide an alternative frequency regulation service. However, the efficiency losses of charging and discharging a storage system cause additional electrical generation requirements and associated emissions. There is not a good understanding of these indirect emissions from charging and discharging ESSs in the literature, with most sources stating that ESSs for frequency regulation have lower emissions, without quantification of these emissions. We created a model to estimate three types of emissions (CO2, NOX, and SO2) from ESSs providing frequency regulation, and compare them to emissions from a natural gas plant providing the same service. When the natural gas plant is credited for the generated electricity, storage systems have 33% to 68% lower CO2 emissions than the gas turbine, depending on the US eGRID subregion, but higher NOX and SO2 emissions. However, different plausible assumptions about the framing of the analysis can make ESSs a worse choice so the true difference depends on the nature of the substitution between storage and natural gas generation.

Multiflame Patterns in Swirl-Driven Partially Premixed Natural Gas Combustion

2002 ◽  
Vol 125 (1) ◽  
pp. 40-45 ◽  
Author(s):  
K. P. Vanoverberghe ◽  
E. V. Van den Bulck ◽  
M. J. Tummers ◽  
W. A. Hu¨bner
Keyword(s):  
Natural Gas ◽  
Combustion Chamber ◽  
Gas Flow ◽  
State Transition ◽  
Gas Combustion ◽  
Bifurcation Phenomena ◽  
Major Species ◽  
Partially Premixed ◽  
Natural Gas Combustion ◽  
Low Nox Emission

Five different flame states are identified in a compact combustion chamber that is fired by a 30 kW swirl-stabilized partially premixed natural gas burner working at atmospheric pressure. These flame states include a nozzle-attached tulip shaped flame, a nonattached torroidal-ring shaped flame (SSF) suitable for very low NOx emission in a gas turbine combustor and a Coanda flame (CSF) that clings to the bottom wall of the combustion chamber. Flame state transition is generated by changing the swirl number and by premixing the combustion air with 70% of the natural gas flow. The flame state transition pathways reveal strong hysteresis and bifurcation phenomena. The paper also presents major species concentrations, temperature and velocity profiles of the lifted flame state and the Coanda flame and discusses the mechanisms of flame transition and stabilization.

Design Analysis of a Micro Gas Turbine Combustion Chamber Burning Natural Gas

2012 ◽  
Author(s):  
André Perpignan V. de Campos ◽  
Fernando L. Sacomano Filho ◽  
Guenther C. Krieger Filho
Keyword(s):  
Experimental Data ◽  
Natural Gas ◽  
Combustion Chamber ◽  
Gas Turbines ◽  
Low Cost ◽  
Mixture Fraction ◽  
Combustion Model ◽  
Inlet Temperature ◽  
Gas Combustion ◽  
Micro Turbine

Gas turbines are reliable energy conversion systems since they are able to operate with variable fuels and independently from seasonal natural changes. Within that reality, micro gas turbines have been increasing the importance of its usage on the onsite generation. Comparatively, less research has been done, leaving more room for improvements in this class of gas turbines. Focusing on the study of a flexible micro turbine set, this work is part of the development of a low cost electric generation micro turbine, which is capable of burning natural gas, LPG and ethanol. It is composed of an originally automotive turbocompressor, a combustion chamber specifically designed for this application, as well as a single stage axial power turbine. The combustion chamber is a reversed flow type and has a swirl stabilized combustor. This paper is dedicated to the diagnosis of the natural gas combustion in this chamber using computational fluid dynamics techniques compared to measured experimental data of temperature inside the combustion chamber. The study emphasizes the near inner wall temperature, turbine inlet temperature and dilution holes effectiveness. The calculation was conducted with the Reynolds Stress turbulence model coupled with the conventional β-PDF equilibrium along with mixture fraction transport combustion model. Thermal radiation was also considered. Reasonable agreement between experimental data and computational simulations was achieved, providing confidence on the phenomena observed on the simulations, which enabled the design improvement suggestions and analysis included in this work.

Using natural gas generation to improve power system efficiency in China

Energy Policy ◽  
2013 ◽  
Vol 60 ◽  
pp. 116-121 ◽  
Author(s):  
Junfeng Hu ◽  
Gabe Kwok ◽  
Wang Xuan ◽  
James H. Williams ◽  
Fredrich Kahrl
Keyword(s):  
Natural Gas ◽  
Power System ◽  
System Efficiency ◽  
Gas Generation

scholarly journals Design of new clean and efficient combustion mode and thermodynamics research using NSGA-II algorithm

2020 ◽  
Vol 24 (5 Part A) ◽  
pp. 2699-2706
Author(s):  
Guoqing Shen
Keyword(s):  
Natural Gas ◽  
Combustion Chamber ◽  
Fuel Consumption ◽  
Consumption Rate ◽  
Thermodynamic Characteristics ◽  
Dual Fuel ◽  
Combustion Mode ◽  
Nsga Ii ◽  
Fuel Consumption Rate ◽  
Efficient Combustion

In order to study a new clean and efficient combustion mode, which can relieve the pressure of traditional energy and ensure low emissions, in this study, a diesel/natural gas dual fuel engine is designed by non-dominant sorting genetic algorithm (NSGA-?), and its thermodynamic characteristics are studied. The WP10.290 Diesel engine is modified into a diesel/natural gas dual fuel engine. The emissions of harmful substances and thermal efficiency of the modified engine under different working conditions are compared. The combustion chamber structure and adaptability between combustion chamber and injection parameters are optimized by using NSGA-II algorithm and CFD software. The results show that the emission of NOx and CH4 and the fuel consumption rate can be reduced simultaneously by using the composite combustion model compared with the original engine. When the CH4 emission is close to zero, the fuel consumption rate decreases obviously, and NOx slightly increases. When the angle between the injection holes is 141.57? the amount of NOx in the cylinder is large. When the injection advance angle is 21.91?CA, the pressure in the cylinder is the highest, the CH4 production is the lowest, the NOx production is higher, and the oxygen content in the combustion mixture is less. The NOx production is the lowest. diesel/natural gas dual fuel engine can ensure efficient combustion while reducing emissions. In this study, the performance of the dual fuel engine at various speeds can be further studied, which can provide theoretical support for the design of diesel/natural gas dual fuel engine.

scholarly journals Mathematical modeling of a swirling jet in applications to low-emission combustion of low-grade fuels

2021 ◽  
Vol 23 (3) ◽  
pp. 308-317
Author(s):  
Usama J. Mizher ◽  
Peter A. Velmisov
Keyword(s):  
Carbon Dioxide ◽  
Natural Gas ◽  
Combustion Chamber ◽  
Negative Impact ◽  
Numerical Study ◽  
Combustion Process ◽  
Theoretical Data ◽  
Modern Society ◽  
Low Grade ◽  
Similar Solutions

Abstract. The search for new solutions in the field of energy, preventing negative impact on the environment, is one of the priority tasks for modern society. Natural gas occupies a stable position in the demand of the UES of Russia for fossil fuel. Biogas is a possible alternative fuel from organic waste. Biogas has an increased content of carbon dioxide, which affects the speed of flame propagation, and a lower content of methane, which reduces its heat of combustion. However, the combined combustion of natural gas and biogas, provided that the mixture of fuel and oxidizer is well mixed, can, on the one hand, reduce the maximum adiabatic temperature in the combustion chamber of power boilers at TPPs, and, on the other, increase the stability of biogas combustion. For the combined combustion of natural gas and biogas in operating power boilers, it is necessary to reconstruct the existing burners. For a high-quality reconstruction of burners capable of providing stable and low-toxic combustion of fuel, it is important to have theoretical data on the combustion effect of combustion of combinations of organic fuels on the temperature distribution in the combustion zone and on its maximum value. In this paper, self-similar solutions of the energy equation for axisymmetric motion of a liquid (gas) in a model of a viscous incompressible medium are obtained. Basing on them, a stationary temperature field in swirling jets is constructed. A set of programs based on the ANSYS Fluent software solver has been developed for modeling and researching of thermal and gas-dynamic processes in the combustion chamber. On the basis of the k - ϵ (realizable) turbulence model, the combustion process of a swirling fuel-air mixture is simulated. The results of an analytical and numerical study of the temperature and carbon dioxide distribution in the jet are presented.

Lean-Burn Characteristics of a Heavy-Duty Diesel Engine Retrofitted to Natural Gas Spark Ignition

2018 ◽  
Author(s):  
Jinlong Liu ◽  
Cosmin E. Dumitrescu
Keyword(s):  
Natural Gas ◽  
Combustion Chamber ◽  
Spark Ignition ◽  
Operating Conditions ◽  
Combustion Stability ◽  
Fuel Injector ◽  
Heavy Duty ◽  
Lean Burn ◽  
Spark Timing ◽  
Heavy Duty Diesel

Increased utilization of natural-gas (NG) in the transportation sector can decrease the use of petroleum-based fuels and reduce greenhouse-gas emissions. Heavy-duty diesel engines retrofitted to NG spark ignition (SI) can achieve higher efficiencies and low NOx, CO, and HC emissions when operated under lean-burn conditions. To investigate the SI lean-burn combustion phenomena in a bowl-in-piston combustion chamber, a conventional heavy-duty direct-injection CI engine was converted to SI operation by replacing the fuel injector with a spark plug and by fumigating NG in the intake manifold. Steady-state engine experiments and numerical simulations were performed at several operating conditions that changed spark timing, engine speed, and mixture equivalence ratio. Results suggested a two-zone NG combustion inside the diesel-like combustion chamber. More frequent and significant late burn (including double-peak heat release rate) was observed for advanced spark timing. This was due to the chamber geometry affecting the local flame speed, which resulted in a faster and thicker flame in the bowl but a slower and thinner flame in the squish volume. Good combustion stability (COVIMEP < 3 %), moderate rate of pressure rise, and lack of knocking showed promise for heavy-duty CI engines converted to NG SI operation.

Research on the Natural Gas Enrichment Regularity of Es1 Layer in Yangxin Subsag of Jiyang Depression

2013 ◽  
Vol 734-737 ◽  
pp. 147-151
Author(s):  
Bo Zhang ◽  
Wen Tao Li ◽  
Zhi Hong Gan
Keyword(s):  
Natural Gas ◽  
Source Rock ◽  
Sedimentary Environment ◽  
Southern Slope ◽  
Gas Generation ◽  
Biological Origin ◽  
Gas Source ◽  
Gas Formation ◽  
Reservoir Development ◽  
Preservation Condition

Natural gas resource of Es1 layer in Yangxin subsag is very abundant. Natural gas formation, enrichment conditions and regularity are analyzed in this paper. Geochemistry analysis shows that natural gas resource of Es1 layer in Yangxin subsag belongs to biological origin gas. The sedimentary environment, ground temperature, gas source rock and preservation condition of the study area is advantageous, which provide a guarantee for natural gas generation and preservation. Research shows that natural gas enrichment in the lower part of Es1 layer because of limestone reservoir development, and on the horizontal direction natural gas is mainly enrichment in the eastern nose structure zone and southern slope zone. The both zones are the preferred zone for natural gas exploration in the study area.

Sign in / Sign up

Export Citation Format

Share Document