Aerodynamics and Turbulent Flow Heat Exchange in the Rotary Disk Air Cleaner

2005 ◽  
Vol 36 (1-2) ◽  
pp. 104-113 ◽  
Author(s):  
I. V. Shevchuk ◽  
N. I. Delas
2015 ◽  
Vol 11 (1) ◽  
pp. 1-17 ◽  
Author(s):  
Rashmi Walvekar ◽  
Mohammad Khalid Siddiqui ◽  
SeikSan Ong ◽  
Ahmad Faris Ismail

Cryogenics ◽  
2013 ◽  
Vol 53 ◽  
pp. 51-60 ◽  
Author(s):  
Enrico Rizzo ◽  
Reinhard Heller ◽  
Laura Savoldi Richard ◽  
Roberto Zanino

The flow due to a disk rotating in its own plane has been investigated theoretically by von Kármán, Goldstein, and others, but little has been published on the heat transfer. For laminar conditions theoretical solutions have been given by Millsaps & Pohlhausen and by Wagner, but for conditions when the flow is turbulent over the outer part of the disk there is no previous information. The present paper describes an experimental investigation of the heat transfer for a range of conditions from entirely laminar flow to conditions when the outer 80% of the disk area is under turbulence. For laminar flow the heat transfer agrees with Wagner’s results, but Millsap’s theory is found to give too low values and an explanation is given. For the turbulent case, which occurs in most practical applications, values are given for the heat transfer which is found to approach the expression N = 0∙015 R 0∙8 for all-turbulent flow. An attempt is made to deduce the turbulent flow heat transfer theoretically by assuming a 1/7 power law of temperature distribution, but this gives too low a value. Some measurements of the velocity and temperature profiles both for laminar and for turbulent conditions are given. For laminar flow these show fair agreement with the theoretical values. For turbulent flow the temperature ratios are higher than those of velocity, which explains the low heat transfer values calculated assuming a 1/7 power temperature distribution. The relation between heat transfer and friction torque is also discussed.


2018 ◽  
Vol 57 (5) ◽  
pp. 1905-1918 ◽  
Author(s):  
Sumer B. Dilgen ◽  
Cetin B. Dilgen ◽  
David R. Fuhrman ◽  
Ole Sigmund ◽  
Boyan S. Lazarov

2007 ◽  
Vol 539-543 ◽  
pp. 242-247 ◽  
Author(s):  
Haydn N.G. Wadley ◽  
Douglas T. Queheillalt

Numerous methods have recently emerged for fabricating cellular lattice structures with unit cells that can be repeated to create 3D space filling systems with very high interconnected pore fractions. These lattice structures possess exceptional mechanical strength resulting in highly efficient load supporting systems when configured as the cores of sandwich panels. These same structures also provide interesting possibilities for cross flow heat exchange. In this scenario, heat is transported from a locally heated facesheet through the lattice structure by conduction and is dissipated by a cross flow that propagates through the low flow resistant pore passages. The combination of efficient thermal conduction along the lattice trusses and low flow resistance through the pore channels results in highly efficient cross flow heat exchange. Recent research is investigating the use of hollow truss structures that enable their simultaneous use as heat pipes which significantly increases the efficiency of heat transport through the lattice and their mechanical strength. The relationships between heat transfer, frictional flow losses and topology of the lattice structure are discussed and opportunities for future developments identified.


Sign in / Sign up

Export Citation Format

Share Document