scholarly journals Numerical Investigation of Multiple Solutions for Caputo Fractional-Order-Two Dimensional Magnetohydrodynamic Unsteady Flow of Generalized Viscous Fluid over a Shrinking Sheet Using the Adams-Type Predictor-Corrector Method

Coatings ◽  
2019 ◽  
Vol 9 (9) ◽  
pp. 548 ◽  
Author(s):  
Liaquat Ali Lund ◽  
Zurni Omar ◽  
Sayer O. Alharbi ◽  
Ilyas Khan ◽  
Kottakkaran Sooppy Nisar

In this paper, magnetohydrodynamic (MHD) flow over a shrinking sheet and heat transfer with viscous dissipation has been studied. The governing equations of the considered problem are transformed into ordinary differential equations using similarity transformation. The resultant equations are converted into a system of fractional differential boundary layer equations by employing a Caputo derivative which is then solved numerically using the Adams-type predictor-corrector method (APCM). The results show the existence of two ranges of solutions, namely, dual solutions and no solution. Moreover, the results indicate that dual solutions exist for a certain range of specific parameters which are in line with the results of some previously published work. It is also observed that the velocity boundary layer decreases as the suction and magnetic parameters increase.

Symmetry ◽  
2020 ◽  
Vol 12 (3) ◽  
pp. 487 ◽  
Author(s):  
Liaquat Ali Lund ◽  
Zurni Omar ◽  
Jawad Raza ◽  
Ilyas Khan ◽  
El-Sayed M. Sherif

In this article, the magnetohydrodynamic (MHD) flow of Casson nanofluid with thermal radiation over an unsteady shrinking surface is investigated. The equation of momentum is derived from the Navier–Stokes model for non-Newtonian fluid where components of the viscous terms are symmetric. The effect of Stefan blowing with partial slip conditions of velocity, concentration, and temperature on the velocity, concentration, and temperature distributions is also taken into account. The modeled equations of partial differential equations (PDEs) are transformed into the equivalent boundary value problems (BVPs) of ordinary differential equations (ODEs) by employing similarity transformations. These similarity transformations can be obtained by using symmetry analysis. The resultant BVPs are reduced into initial value problems (IVPs) by using the shooting method and then solved by using the fourth-order Runge–Kutta (RK) technique. The numerical results reveal that dual solutions exist in some ranges of different physical parameters such as unsteadiness and suction/injection parameters. The thickness of the velocity boundary layer is enhanced in the second solution by increasing the magnetic and velocity slip factor effect in the boundary layer. Increment in the Prandtl number and Brownian motion parameter is caused by a reduction of the thickness of the thermal boundary layer and temperature. Moreover, stability analysis performed by employing the three-stage Lobatto IIIA formula in the BVP4C solver with the help of MATLAB software reveals that only the first solution is stable and physically realizable.


Author(s):  
Ioan Pop ◽  
Kohilavani Naganthran ◽  
Roslinda Nazar ◽  
Anuar Ishak

Purpose The purpose of this paper is to study the effects of vertical throughflow on the boundary layer flow and heat transfer of a nanofluid driven by a permeable stretching/shrinking surface. Design/methodology/approach Similarity transformation is used to convert the system of boundary layer equations into a system of ordinary differential equations. The system of governing similarity equations is then reduced to a system of first-order differential equations and solved numerically using the bvp4c function in Matlab software. The generated numerical results are presented graphically and discussed based on some governing parameters. Findings It is found that dual solutions exist in both cases of stretching and shrinking sheet situations. Stability analysis is performed to determine which solution is stable and valid physically. Originality/value Dual solutions are found for positive and negative values of the moving parameter. A stability analysis has also been performed to show that the first (upper branch) solutions are stable and physically realizable, while the second (lower branch) solutions are not stable and, therefore, not physically possible.


2012 ◽  
Vol 09 ◽  
pp. 511-519 ◽  
Author(s):  
AZIZAH MOHD ROHNI ◽  
SYAKILA AHMAD ◽  
AHMAD IZANI MD. ISMAIL ◽  
IOAN POP

The unsteady flow over a continuously shrinking sheet with wall mass suction in a nanofluid is numerically studied. The governing boundary layer equations are transformed into a set of nonlinear ordinary differential equations by using similarity transformation. The resulting similarity equations are then solved by the shooting method for three types of nanofluid: copper-water, alumina-water and titania-water to investigate the effect of nanoparticle volume fraction parameter ɸ to the flow in nanofluid. The skin friction coefficient and velocity profiles are presented and results show that dual solutions exist for a certain range of unsteadiness parameter A. It is also found that the nanoparticle volume fraction parameter ɸ and types of nanofluid play an important role to significantly determine the flow behaviour.


2019 ◽  
Vol 24 (1) ◽  
pp. 53-66
Author(s):  
O.J. Fenuga ◽  
S.J. Aroloye ◽  
A.O. Popoola

Abstract This paper investigates a chemically reactive Magnetohydrodynamics fluid flow with heat and mass transfer over a permeable surface taking into consideration the buoyancy force, injection/suction, heat source/sink and thermal radiation. The governing momentum, energy and concentration balance equations are transformed into a set of ordinary differential equations by method of similarity transformation and solved numerically by Runge- Kutta method based on Shooting technique. The influence of various pertinent parameters on the velocity, temperature, concentration fields are discussed graphically. Comparison of this work with previously published works on special cases of the problem was carried out and the results are in excellent agreement. Results also show that the thermo physical parameters in the momentum boundary layer equations increase the skin friction coefficient but decrease the momentum boundary layer. Fluid suction/injection and Prandtl number increase the rate of heat transfer. The order of chemical reaction is quite significant and there is a faster rate of mass transfer when the reaction rate and Schmidt number are increased.


2018 ◽  
Vol 140 (9) ◽  
Author(s):  
Lin Liu ◽  
Liancun Zheng ◽  
Yanping Chen ◽  
Fawang Liu

The paper gives a comprehensive study on the space fractional boundary layer flow and heat transfer over a stretching sheet with variable thickness, and the variable magnetic field is applied. Novel governing equations with left and right Riemann–Liouville fractional derivatives subject to irregular region are formulated. By introducing new variables, the boundary conditions change as the traditional ones. Solutions of the governing equations are obtained numerically where the shifted Grünwald formulae are applied. Good agreement is obtained between the numerical solutions and exact solutions which are constructed by introducing new source items. Dynamic characteristics with the effects of involved parameters on the velocity and temperature distributions are shown and discussed by graphical illustrations. Results show that the velocity boundary layer is thicker for a larger fractional parameter or a smaller magnetic parameter, while the temperature boundary layer is thicker for a larger fractional parameter, a smaller exponent parameter, or a larger magnetic parameter. Moreover, it is thicker at a smaller y and thinner at a larger y for the velocity boundary layer with a larger exponent parameter while for the velocity and temperature boundary layers with a smaller weight coefficient.


Author(s):  
V. Ananthaswamy ◽  
K. Renganathan

In this paper we discuss with magneto hydrodynamic viscous flow due to a shrinking sheet in the presence of suction. We also discuss two dimensional and axisymmetric shrinking for various cases. Using similarity transformation the governing boundary layer equations are converted into its dimensionless form. The transformed simultaneous ordinary differential equations are solved analytically by using Homotopy analysis method. The approximate analytical expression of the dimensionless velocity, dimensionless temperature and dimensionless concentration are derived using the Homotopy analysis method through the guessing solutions. Our analytical results are compared with the previous work and a good agreement is observed.


1968 ◽  
Vol 33 (1) ◽  
pp. 113-126
Author(s):  
N. Rott ◽  
J. T. Ohrenberger

The boundary layer on an axisymmetric surface above which the flow is rotating about the axis of symmetry is considered. Transformations of the governing equations which permit the generalizations of a known solution for one meridian shape in incompressible flow to a family of meridian shapes are shown to exist. For compressible flow, a transformation of the Stewartson-Illingworth type was found which reduces a compressible flow problem to an incompressible case. Also, remarks are made concerning the invariance of the turbulent boundary-layer integral equations assuming particular semi-empirical shear laws.


2018 ◽  
Author(s):  
Mohamad Mustaqim Junoh ◽  
Fadzilah Md Ali ◽  
Norihan Md Arifin ◽  
Norfifah Bachok

2018 ◽  
Vol 22 (2) ◽  
pp. 857-870 ◽  
Author(s):  
Mohamed Abdel-Wahed ◽  
Tarek Emam

The present work provides an analysis of the hydromagnetic nanofluid boundary-layer flow over a rotating disk in a porous medium with a constant velocity in the presence of hall current and thermal radiation. The governing PDE system that describes the problem is converted to a system of ODE by the similarity transformation method, which solved analytically using optimal homotopy asymptotic method. The velocity profiles and temperature profiles of the boundary-layer are plotted and investigated in details. Moreover, the surface skin friction, rate of heat transfer are deduced and explained in details.


2016 ◽  
Vol 20 (2) ◽  
pp. 529-540
Author(s):  
Slobodan Savic ◽  
Branko Obrovic ◽  
Nebojsa Hristov

The ionized gas flow in the boundary layer on bodies of revolution with porous contour is studied in this paper. The gas electroconductivity is assumed to be a function of the longitudinal coordinate x. The problem is solved using Saljnikov's version of the general similarity method. This paper is an extension of Saljnikov?s generalized solutions and their application to a particular case of magnetohydrodynamic (MHD) flow. Generalized boundary layer equations have been numerically solved in a four-parametric localized approximation and characteristics of some physical quantities in the boundary layer has been studied.


Sign in / Sign up

Export Citation Format

Share Document