Residual Stresses in Roller Bearing Components
Rolling contact fatigue is a very complex process. The mechanism can only be described by speculative considerations. Because the loading conditions during the elastic- hydro- dynamical contact are not clearly described. The loading cycle runs within extremely short rates and structural alterations occur under high hydrostatic pressure. Widely unknown is therefore, how the materials conditions are influenced by these processes. But by means of simplified considerations an approach to the rolling contact fatigue process can be obtained. Following these conceptions simplifying quasi-static conditions are drawn. A lubricant film inhibits the metallic contact of the revolved bearing components. A HERTZian load stress will be accumulated over an elliptical contact area and within and beneath this contact area three dimensional stresses are acting. The materials strengthening can be described by the hypothesis of alteration of shape. During the fatigue period, the microstructure will be changed by micro- and macro- plastically deformation. By this residual stresses occur. These are superimposed to the operational -loading –stresses which change the distressing conditions of the material. The progressive plastically deformations accompanying the growing fatigue procedure cause perpetually alterations in the distress- conditions of the material. Structural alterations of the rolling contact fatigue process are shown by means of metallography as followed: by dark etching areas (DEA), and by white etching areas (WEA) showing bands, which are positioned beneath the contact area at an angle of 30° (30°WEB) and for instance at 80° (80°WEB), and furthermore by so called butterfly structures (butterflies with “white etched” flanks). All these white etching areas, regarding their morphological structure and the etching conditions, are commonly originated by two axial distressing. The three dimensional materials distressing within the roller-bearing component on the one hand and the two dimensionally originating of the WEA on the other seem to be an antagonism. But when the changes of residual stresses during the contact rolling fatigue process are to be analyzed, it is clear that this antagonism rises only virtually because there exists a real tri-axial stress condition, which tolerates a two axial distressing of the material. By the concept, that the growing plastically deformations cause residual stresses superposing the operational load stresses, the temporary cycle of the structural alterations and the local and angular positions of the 30° WEB can be explained.