Modifying the resin type of hybrid anion exchange nanotechnology (HAIX-Nano) to improve its regeneration and phosphate recovery efficiency

In order to avoid eutrophication of freshwater systems, regulations all around the world have become increasingly stringent toward the maximum phosphate concentration allowed in wastewater discharges. Traditional phosphate removal methods such as chemical precipitation and enhanced biological phosphorus removal struggle to lower phosphate levels to the new requirements. Hybrid anion exchange nanotechnology (HAIX-Nano) is composed of a selective adsorption material able to remove phosphate down to levels close to zero. Moreover, HAIX-Nano is not affected by intermittent flow and does not produce sludge making it an interesting alternative. The regeneration process of HAIX-Nano typically requires a chemical solution with a high concentration of sodium hydroxide (NaOH) and sodium chloride (NaCl) (2–5% w/w of each). To lower the environmental impact and the operational cost of the technology, this study aims to enhance the HAIX-Nano regeneration efficiency. Therefore, the backbone of HAIX-Nano, which is normally a strong base anionic (SBA) resin, was changed for a weak base anionic (WBA) resin. The resulting material (WBA-2) exhibited a higher adsorption capacity than the traditional version of HAIX-Nano (SBA-1) under the tested conditions, while also showing a much higher regeneration efficiency. For a desorption solution of only 0.4% NaOH and no NaCl, WBA-2 showed an average regeneration efficiency of 78 ± 1% compared to SBA-1 with 24 ± 1%.

Non-linear multiphase flow in hydrophobic porous media

Multiphase flow in porous materials is conventionally described by an empirical extension to Darcy’s law which assumes that the pressure gradient is proportional to flow rate. Through a series of two-phase flow experiments, we demonstrate that even when capillary forces are dominant at the pore scale, there is a non-linear intermittent flow regime with a power-law dependence between pressure gradient and flow rate. Energy balance is used to predict accurately the start of the intermittent regime in hydrophobic porous media. The pore-scale explanation of the behaviour based on the periodic filling of critical flow pathways is confirmed through 3D micron-resolution X-ray imaging.

Aerodynamic Study of a NACA 64418 Rectangular Wing under Forced Pitching Motions

The aerodynamic behavior of a pitching NACA 64418 rectangular wing was experimentally studied in a subsonic wind tunnel. The wing had a chord c = 0.5 m, a span which covered the distance between the two parallel tunnel walls and an axis of rotation 0.35 c far from the leading edge. Based on pressure distribution and flow visualization, intermittent flow separation (double stall) was revealed near the leading edge suction side when the wing was stationary, at angles higher than 17° and Re = 0.5 × 106. Under pitching oscillations, aerodynamic loads were calculated by integrating the output data of fast responding surface pressure transducers for various mean angles of attack (αm (max) = 15°), reduced frequencies (kmax = 0.2) and angle amplitudes Δα in the interval [2°, 8°]. The impact of the above parameters up to Re = 0.75 × 106 on the cycle-averaged lift and pitching moment loops is discussed and the cycle aerodynamic damping coefficient is calculated. Moreover, the boundaries of the above parameters are defined for the case that energy is transferred from the flow to the wing (negative aerodynamic damping coefficient), indicating the conditions under which aeroelastic instabilities are probable to occur.

Field experiment on flow stabilization of working fluid in a top-heat-type thermosyphon

To address the problem of global warming, increasing efforts are being made to use renewable sources of energy, such as solar energy, wind energy, and geothermal energy. However, the effective use remains a major challenge for its sustainable development. In this study, we used a top-heat-type thermosyphon to heat water using solar energy and transport the low-density hot water from the source to the sink (high to low elevation) without an external power source. The transported hot water can be used for cooking, bathing, underfloor heating, and heating homes and buildings, and warming cold springs. However, a disadvantage of top-heat-type thermosyphon is the intermittent flow of the circulating working fluid under low solar radiation. To address this issue, the authors proposed and developed a control system to stabilize the intermittent flow and prevent equipment damage and failure due to the sudden boiling of water. Field experiments were conducted to assess the practicability of the developed controller. The results showed that the controller efficiently converted the intermittent flow of working fluid to continuous flow by reducing the pressure in the buffer chamber and thus lowering the boiling point of the working fluid in the header of the solar collector.

Guidelines for reporting methods to estimate metabolic rates by aquatic intermittent-flow respirometry

ABSTRACT Interest in the measurement of metabolic rates is growing rapidly, because of the importance of metabolism in advancing our understanding of organismal physiology, behaviour, evolution and responses to environmental change. The study of metabolism in aquatic animals is undergoing an especially pronounced expansion, with more researchers utilising intermittent-flow respirometry as a research tool than ever before. Aquatic respirometry measures the rate of oxygen uptake as a proxy for metabolic rate, and the intermittent-flow technique has numerous strengths for use with aquatic animals, allowing metabolic rate to be repeatedly estimated on individual animals over several hours or days and during exposure to various conditions or stimuli. There are, however, no published guidelines for the reporting of methodological details when using this method. Here, we provide the first guidelines for reporting intermittent-flow respirometry methods, in the form of a checklist of criteria that we consider to be the minimum required for the interpretation, evaluation and replication of experiments using intermittent-flow respirometry. Furthermore, using a survey of the existing literature, we show that there has been incomplete and inconsistent reporting of methods for intermittent-flow respirometry over the past few decades. Use of the provided checklist of required criteria by researchers when publishing their work should increase consistency of the reporting of methods for studies that use intermittent-flow respirometry. With the steep increase in studies using intermittent-flow respirometry, now is the ideal time to standardise reporting of methods, so that – in the future – data can be properly assessed by other scientists and conservationists.

Parameters for effective sand filtration of Schistosoma mansoni cercariae from water

Schistosomiasis is a water-based neglected tropical disease that is prevalent in over 78 countries. It affects communities that are reliant on freshwater bodies contaminated with schistosome cercariae for their daily water activities. Whilst treatment with the drug praziquantel is relatively effective, it does not prevent reinfection. One option for reducing schistosomiasis infection is providing at-risk communities with treated water, thereby reducing contact with cercaria-infested water for activities such as bathing or doing laundry. This study aims to establish design guidance for sand filtration to remove schistosome cercariae from water. Four sand filters were tested, varying from 300 to 2,000 μm in sand grain size. Each filter was tested with a sand depth of 20 cm, which was increased until no cercariae were detected in the effluent. The required filter depth to remove 100% of cercariae ranged between 40 and 70 cm depending on sand grain size. Cercaria removal was more effective in filters with smaller sand grain size and larger filter depth. These results are valid for intermittent flow, for up to six cycle flushes. While more rigorous testing is needed, these initial results suggest that sand filters can be an effective way to treat cercaria-contaminated water in low-income settings.