scholarly journals Evaluation of Micro Hydro Power Plants in Central Java toward Sustainability against Hydrology Condition of Watershed

2018 ◽  
Vol 73 ◽  
pp. 01017
Author(s):  
Ignatius Sriyana
Keyword(s):  
Power Plant ◽  
Land Degradation ◽  
Power Plants ◽  
Hydro Power ◽  
Central Java ◽  
Hydro Power Plants

Land degradation on the upstream of watershed will affect hydrology condition in a way that it will disrupt the sustainability of its existing micro hydro. The purpose of this study is to evaluate micro hydro power plant in central Java toward sustainability against hydrology condition of watershed. This study is using River Regime Coefficient (RRC) approach where hydrology of watershed with coefficient value less than 50 is classified as non-critical, between 50 and 120 is moderate and more than 120 is critical. Result of the study that was done on 33 micro hydro power plants scattered on 9 watersheds is showing that there are 2 power plants on 2 watersheds have hydrology condition in non-critical status (9.09%), 1 power plant on 1 watershed is in between critical and non-critical status (3.03%), 21 power plants on 3 watersheds are in between critical and moderate status (63.64%), 8 power plants on 6 watersheds are in critical status (21.21%) and 1 power plant on 1 watershed is in between moderate and critical status (3.03%).

scholarly journals Analisis Ketidakstabilan Tegangan dan Frekuensi Pada Pembangkit Listrik Tenaga Mikrohidro Soko Kembang

2019 ◽  
Vol 11 (2) ◽  
pp. 129-137
Author(s):  
Nurul Dyah Pratiwi ◽  
Isdiyato Isdiyato
Keyword(s):  
Power Plant ◽  
Electric Power ◽  
Rotational Speed ◽  
Power Plants ◽  
Synchronous Generator ◽  
Frequency Instability ◽  
Small Scale ◽  
Hydro Power ◽  
Central Java ◽  
Hydro Power Plants

Microhydro power plant (MPP) is a small-scale power plant that uses water energy. The process of energy change occurs in a device called a synchronous generator. when the synchronous generator is given an arbitrary load, then the voltage will change. These results cause voltage and frequency instability. This research was conducted to analyze the voltage and frequency instability in MPP. The research method used in this research is descriptive quantitative approach in the village of Soko Kembang, Petungkriyono District, Pekalongan Regency, Central Java. This study provides an overview and explanation of the problems regarding the voltage and frequency instability of Micro Hydro Power Plants. The results of this study are the highest and lowest voltage / frequency instability values, namely 235 volts / 51 Hz and 160 volts / 44 Hz, due to the influence of changes in load current, which can affect the rotational speed of the generator changes, resulting in unstable voltage and frequency generated by the generator, the rotational speed of the generator changes, resulting in unstable voltage and frequency generated by the generator. The solution is  add water power to rotate the shaft of the turbine and generator to be tighter, so that it can reduce the value of the decrease in electric power by losses to the turbine and generator. Large electric power can increase voltage and frequency without having to adjust the load, and the need for improvement of the ELC system in order to get a more effective value of voltage and frequency stability.  

scholarly journals Dimensioning Studies for Reversible Hydro Power Plants in Portuguese Islands

2018 ◽  
Vol 4 (1) ◽  
pp. 77-86
Author(s):  
Nuno Fonseca ◽  
André Madureira ◽  
João Peças Lopes ◽  
Manuel Matos
Keyword(s):  
Power Plant ◽  
Power Systems ◽  
Power Plants ◽  
Hydro Power ◽  
Power Resources ◽  
Hydro Power Plants ◽  
Pumped Storage ◽  
Energetic Level ◽  
Energy Surplus ◽  
The Ideal

This work is within the scope of set of consultancy studies made for Portuguese islands. It focuses on the integration of Pumped Storage Power in isolated islands. The paper starts to address several power systems circumstances about two Portuguese islands on the energetic level. For each of these islands, an independent examination of the conditions to install a reversible hydro power plant is accomplished. Therefore, the energy volume to be stored due to excess of renewable generation and the ideal power and number of the pumps and turbines to be installed were identified and evaluated for the sake of using the produced energy surplus as to be pumped and later generated. The paper enhances the importance of storing energy in the operation of isolated and small systems with considerable amount of intermittent power resources as well as the conditions for the viability of installing new exploitations of this kind.

scholarly journals Pengaruh Pengaruh Sudut Kemiringan Head Turbin Ulir Terhadap Daya Putar Turbin Ulir Dan Daya Output Pada Pembangkit Listrik Tenaga Mikro Hidro

2018 ◽  
Vol 17 (3) ◽  
pp. 393
Author(s):  
I Putu Juliana ◽  
Antonius Ibi Weking ◽  
Lie Jasa
Keyword(s):  
Power Plant ◽  
Output Power ◽  
Power Plants ◽  
Water Discharge ◽  
Electrical Energy ◽  
Hydro Power ◽  
Small Water ◽  
Final Project ◽  
Working Principle ◽  
Hydro Power Plants

The dependence of power plants on energy sources such as diesel, natural gas and coal is almost 75%, encouraging the development of renewable energy in an effort to meet the electricity supply. One of them is the micro hydro power plant by utilizing the potential of existing water. The working principle of PLTMH is to change the potential energy of water into electrical energy. In this final project has been designed modeling of micro hydro power plant by using screw turbine (Archimedes Screw). The turbine used resembles a drill bit, with a diameter of a turbine of 26 cm, a screw width of 10 cm, and an amount of 10 pieces of blade. Measurements made on the modeling of micro hydro power plants include: water discharge, turbine rotation, generator rotation, voltage, current, torque and generator output power and efficiency. The parameters are measured by changing the water fall on the turbine from the position of the turbine head angle 00, 100, 150, 200, 250, 300, 350, 400, 450, 500, 550, 600, 700, 800  and 900 . The result of measurement that has been done on the parameters of micro hydro power plant modeling, obtained the highest measurement result at the corner of turbine head 400. The output power generated is 10.92 watts, torque is 0.60 Nm and efficiency of 14%. The results obtained are still low because the turbine rotation is less able to rotate the generator, where the generator torque is greater than the torque in the turbine. This is influenced by the small water discharges in the modeling of this micro hydro power plant.

ESTIMATION OF REDUCTION OF NITROGEN OXIDES IN COMBINED STEAM AND GAS POWER PLANTS

2018 ◽  
pp. 226-236
Author(s):  
M. P. Kulyk
Keyword(s):  
Power Plant ◽  
Power System ◽  
Power Plants ◽  
Membrane Separation ◽  
Thermal Power ◽  
Gas Generation ◽  
Hydro Power ◽  
Atmospheric Air ◽  
Power Change ◽  
Hydro Power Plants

The characteristic of the united power system of Ukraine, based on thermal, nuclear and hydro power plants, as well as on alternative and renewable sources, is carried out. The structure of power system potential indicates a lack of maneuver capacity, some plants are of low mobility. Thermal power is in critical condition due to expired service time of the main technological equipment, additionally, it is a huge source of emissions of harmful substances into the environment. An attempt to use them to cover peak loads only worsens their critical state.It is suggested to restore thermal power on the basis of combined steam and gas power plants. Moreover, for operation of gas section it is necessary to use working substance, which is formed in an additional furnace by heating the compressed air with heat from combustion of some part of coal flow, which subsequently enters the main furnace. The steam and gas generation branches are parallel connected, which extends the range of power change (increasing its maneuverability.) Gas generation increases mobility (rate of power change). For combustion of organic fuel, oxygen enriched atmospheric air is fed, and a nitrogen-based fraction can form a working substance for gas generation. With such an organization of combustion the coefficient of excess air can be ignored, which enables to reduce the volume of flue gases. The membrane separation of atmospheric air into fractions - one en-riched with oxygen, and another with nitrogen, improves the environmentalperformance of a power plant, while increasing its power and economic indices. On the example of the boiler unit TP-92 the basic parameters of a power plant are checked by a calculation method. It is confirmed that the proposed technical solutions point to the correctness and validity of the assumptions. Analysis of the existing technical level of scientific research increases confidence in perspective of the selected direction.

scholarly journals Designing Marine Current Micro-Hydro Power Plants

2018 ◽  
Author(s):  
Andrea Stevens Karnyoto
Keyword(s):  
Power Plant ◽  
Power Plants ◽  
Diesel Oil ◽  
Power Source ◽  
Small Island ◽  
Hydro Power ◽  
South Sulawesi ◽  
Oil Transportation ◽  
Marine Current ◽  
Hydro Power Plants

Indonesia is an archipelago country. Today, Indonesian government continues to increase support to entrepreneurs engaged in renewable-energy. Based on the observation of the researchers, Barrang Lompo is one of the islands in the province of South Sulawesi that inhabited by about 4000 people still using diesel power plants. Costly diesel oil and oil transportation constraints cause the diesel power plant to be used only at 6 pm to 12 pm. Develop a Marine Current Micro-Hydro Power Plants can be a solution for people in the small island because it is too difficult to connecting electricity from power source in the main island. We hoped with these design people can be easy to build their marine current power plant.

scholarly journals ANALISIS DAN PERBANDINGAN SEGITIGA KERJA: TURBIN SUDU SETENGAH LINGKARAN, SUDU SEGITIGA DAN SUDU SIRIP UNTUK MENGHASILKAN RPM YANG TERTINGGI

2019 ◽  
Vol 6 (2) ◽  
pp. 78
Author(s):  
Gregory Rama Darantiah Ruing ◽  
Antonius Ibi Weking ◽  
Lie Jasa
Keyword(s):  
Energy Source ◽  
Renewable Energy ◽  
Power Plant ◽  
Natural Gas ◽  
Power Plants ◽  
Position Angle ◽  
Energy Sources ◽  
Hydro Power ◽  
Nozzle Position ◽  
Hydro Power Plants

At present the power plant has a high dependence on energy sources such as diesel, natural gas and coal, while its energy source in nature is increasingly scarce, this situation encourages the development of renewable energy, one of which is in micro hydro power plants. This study aims to determine the effect of the width of the work triangle on the highest rpm produced. the fall of water on the pinwheel is set from the position angle of the nozzle 00, 150, 300, 450, 600, 750 and from the angle of the nozzle 00, 50, 100, 150, 200, 250, 300, 350 and 400 on the semicircular blade turbine, triangle blade turbine , and fin blade turbines. Semicircular turbine blade, working triangle area produces greater rpm at position of angle nozzle 00 and angle of nozzle 250 with area of work triangle 360,36 cm2, where the position produces 216 rpm at windmill rotation and 1626 rpm at generator rotation. When the nozzle position angle 150 and the nozzle angle 200 with the working triangle area 264.27 cm2, produce 221 rpm at the pinwheel rotation and 1711 rpm at the generator rotation. while at the nozzle position angle of 300 and the angle of the nozzle 100 the area of the triangle works 134.37 cm2 and produces 173 rpm at the spinning wheel and 1307 rpm at the generator rotation. on the triangle blade turbine and fin blade, the working triangle area does not affect the rpm produced.

scholarly journals Micro hydro Power Plant Shanping (Site Reconstruction)

2018 ◽  
Author(s):  
Štefan Tkáč
Keyword(s):  
Power Generation ◽  
Power Plant ◽  
Power Plants ◽  
The Other ◽  
Historical Documents ◽  
Hydro Power ◽  
Comparative Methodology ◽  
Hydro Power Plants ◽  
Supporting Structures

This research paper is part of the wider project concerning the very first detailed mapping of the overall Taiwanese hydro-power plants that took place from 2013 up to 2015 and it is currently in evaluation and finalization stage. The case of Shanping hydro-power plant has been carefully studied, photographed, documented and mapped in situ. It was one of the isolated hydro-power plant projects originally built to supply the remote area with the specific designation. Shanping hydro-power plant, as well as the other units from the early hydro-power generation era in Taiwan, are considered to be the technological heritage of civil and mechanical engineering that reflects later in all the further projects up to nowadays modern Taiwanese hydro-power plants. Unfortunately, most of the hydro-power houses from the older periods were severely damaged or destroyed by natural causes which were also the case of Shanping unit. The research is trying to reconstruct the original location of the powerhouse and its supporting structures based on available historical documents, previous studies, comparative methodology, and the current on-site observation.

Sign in / Sign up

Export Citation Format

Share Document