scholarly journals ANALISIS DAN PERBANDINGAN SEGITIGA KERJA: TURBIN SUDU SETENGAH LINGKARAN, SUDU SEGITIGA DAN SUDU SIRIP UNTUK MENGHASILKAN RPM YANG TERTINGGI

2019 ◽  
Vol 6 (2) ◽  
pp. 78
Author(s):  
Gregory Rama Darantiah Ruing ◽  
Antonius Ibi Weking ◽  
Lie Jasa

At present the power plant has a high dependence on energy sources such as diesel, natural gas and coal, while its energy source in nature is increasingly scarce, this situation encourages the development of renewable energy, one of which is in micro hydro power plants. This study aims to determine the effect of the width of the work triangle on the highest rpm produced. the fall of water on the pinwheel is set from the position angle of the nozzle 00, 150, 300, 450, 600, 750 and from the angle of the nozzle 00, 50, 100, 150, 200, 250, 300, 350 and 400 on the semicircular blade turbine, triangle blade turbine , and fin blade turbines. Semicircular turbine blade, working triangle area produces greater rpm at position of angle nozzle 00 and angle of nozzle 250 with area of work triangle 360,36 cm2, where the position produces 216 rpm at windmill rotation and 1626 rpm at generator rotation. When the nozzle position angle 150 and the nozzle angle 200 with the working triangle area 264.27 cm2, produce 221 rpm at the pinwheel rotation and 1711 rpm at the generator rotation. while at the nozzle position angle of 300 and the angle of the nozzle 100 the area of the triangle works 134.37 cm2 and produces 173 rpm at the spinning wheel and 1307 rpm at the generator rotation. on the triangle blade turbine and fin blade, the working triangle area does not affect the rpm produced.

Author(s):  
Zivojin Stamenkovic ◽  
Dragan Svrkota

Population growth and new forms of energy use have the effect that the energy demand grows year after year. The harmful influence of the use of fossil and nuclear fuels has influenced the intensive development of renewable energy sources (solar energy, small hydro power plants, wind energy, bio-renewable sources - biomass, geothermal energy). This paper gives an overview of the choice of design solution, technical parameters and the efficiency of small hydro power plants (SHPP) on small watercourses. Special attention in these considerations is dedicated to harmonization of selected solutions with natural resources and protection of ecosystems. In order to define the technical solution of one small HPP on a small watercourse, the following analyzes and studies need to be done: Hydrological study; Analysis of the available hydro potential; Pre-feasibility study of the chosen technical solution; Study on Environmental Impact Assessment; Analysis of the investment value of the elements of the system and the system as a whole; Analysis of annual fees and expenses. In analyzing the available hydro potential, it is necessary to examine in detail the influence of the minimum sustainable flow rate in the watercourse (biological minimum) both from the aspect of environmental protection and from the aspect of the techno-economic justification for SHPP construction. On the basis of the "cross-cutting" of the results of these analyzes, one can see the techno-economically justified solution for the construction of SHPP in line with the ecosystem. The goal of all previous analyzes is to select a technical solution that maximizes the use of hydro power potential and ensures optimum use of renewable energy sources, while paying special attention to ecology, environmental protection and sustainable development.


Author(s):  
Hassan Moghbelli ◽  
Robert Vartanian

One major problem in the world is global warming that is now in the concern of some countries. Most countries are working on the usage of renewable energy sources such as solar energy, clean fuels like hydrogen and also increasing the efficiency of fossil fuel plant to help the global warming effect. Countries having high potential of solar energy and also natural gas as a source of hydrogen can use the finding of this research by developing usage of the solar energy converters and natural gas fuel cells for electric power plants. This paper discusses hybridization of renewable solar energy source with high efficient and clean usage of natural gas fossil fuel. Other aspects of this hybrid power plant is using the renewable energy sources as a reliable power supply with stand alone and grid connected capability which can increase network power quality. This paper also discusses the hybridization of solar energy as a renewable energy source and natural gas fuel cells as a fossil fuel and also improvement of power plant efficiency by using power electronics technology and electric energy storages.


2018 ◽  
Vol 73 ◽  
pp. 01017
Author(s):  
Ignatius Sriyana

Land degradation on the upstream of watershed will affect hydrology condition in a way that it will disrupt the sustainability of its existing micro hydro. The purpose of this study is to evaluate micro hydro power plant in central Java toward sustainability against hydrology condition of watershed. This study is using River Regime Coefficient (RRC) approach where hydrology of watershed with coefficient value less than 50 is classified as non-critical, between 50 and 120 is moderate and more than 120 is critical. Result of the study that was done on 33 micro hydro power plants scattered on 9 watersheds is showing that there are 2 power plants on 2 watersheds have hydrology condition in non-critical status (9.09%), 1 power plant on 1 watershed is in between critical and non-critical status (3.03%), 21 power plants on 3 watersheds are in between critical and moderate status (63.64%), 8 power plants on 6 watersheds are in critical status (21.21%) and 1 power plant on 1 watershed is in between moderate and critical status (3.03%).


Author(s):  
Alexey Dragunov ◽  
Eugene Saltanov ◽  
Igor Pioro ◽  
Pavel Kirillov ◽  
Romney Duffey

It is well known that the electrical-power generation is the key factor for advances in any other industries, agriculture and level of living. In general, electrical energy can be generated by: 1) non-renewable-energy sources such as coal, natural gas, oil, and nuclear; and 2) renewable-energy sources such as hydro, wind, solar, biomass, geothermal and marine. However, the main sources for electrical-energy generation are: 1) thermal - primary coal and secondary natural gas; 2) “large” hydro and 3) nuclear. The rest of the energy sources might have visible impact just in some countries. Modern advanced thermal power plants have reached very high thermal efficiencies (55–62%). In spite of that they are still the largest emitters of carbon dioxide into atmosphere. Due to that, reliable non-fossil-fuel energy generation, such as nuclear power, becomes more and more attractive. However, current Nuclear Power Plants (NPPs) are way behind by thermal efficiency (30–42%) compared to that of advanced thermal power plants. Therefore, it is important to consider various ways to enhance thermal efficiency of NPPs. The paper presents comparison of thermodynamic cycles and layouts of modern NPPs and discusses ways to improve their thermal efficiencies.


2018 ◽  
Vol 4 (1) ◽  
pp. 77-86
Author(s):  
Nuno Fonseca ◽  
André Madureira ◽  
João Peças Lopes ◽  
Manuel Matos

This work is within the scope of set of consultancy studies made for Portuguese islands. It focuses on the integration of Pumped Storage Power in isolated islands. The paper starts to address several power systems circumstances about two Portuguese islands on the energetic level. For each of these islands, an independent examination of the conditions to install a reversible hydro power plant is accomplished. Therefore, the energy volume to be stored due to excess of renewable generation and the ideal power and number of the pumps and turbines to be installed were identified and evaluated for the sake of using the produced energy surplus as to be pumped and later generated. The paper enhances the importance of storing energy in the operation of isolated and small systems with considerable amount of intermittent power resources as well as the conditions for the viability of installing new exploitations of this kind.


2021 ◽  
Vol 3-4 (185-186) ◽  
pp. 109-125
Author(s):  
Myroslav Podolskyy ◽  
Dmytro Bryk ◽  
Lesia Kulchytska-Zhyhailo ◽  
Oleh Gvozdevych

An analysis of Ukraine’s sustainable development targets, in particular in the field of energy, resource management and environmental protection, are presented. It is shown that regional energetic is a determining factor for achieving the aims of sustainable development. Changes in the natural environment in Ukraine due to external (global) and internal (local) factors that are intertwined and overlapped can cause threats to socio-economic development. It is proved that in the areas of mining and industrial activity a multiple increase in emissions of pollutants into the environment are observed. The comparison confirmed the overall compliance of the structure of consumption of primary energy resources (solid fossil fuels, natural gas, nuclear fuel, oil and petroleum products, renewable energy sources) in Ukraine and in the European Union, shows a steaby trend to reduce the share of solid fuels and natural gas and increasing the shares of energy from renewable sources. For example, in Ukraine the shares in the production and cost of electricity in 2018 was: the nuclear power plants – 54.33 % and in the cost – 26.60 %, the thermal power – 35.95 and 59.52 %, the renewable energy sources – 9.6 and 13.88 %. The energy component must be given priority, as it is crucial for achieving of all other goals of sustainable development and harmonization of socio-economic progress. The paper systematizes the indicators of regional energy efficiency and proposes a dynamic model for the transition to sustainable energy development of the region.


2015 ◽  
Vol 21 (5) ◽  
pp. 756-772 ◽  
Author(s):  
Anant V KHANDEKAR ◽  
Jurgita ANTUCHEVIČIENĖ ◽  
Shankar CHAKRABORTY

There has been a rapid growth in construction activities during the last few decades owing to overall development in all facets of humanity. Due to technological advancements and ever increasing civilization, there is a persistent need of energy. Along with the conventional energy sources, the renewable energy sources have also significantly contributed to the rising energy needs. As a renewable source of energy, numerous small hydro-power plants (SHPPs) have been built up across the world in the recent past. Usually these SHPPs are being built and operated by the private developers complying with the government regulations. In order to assist a developer in selecting the most profitable and feasible SHPP for construction and subsequent operation, a method based on fuzzy axiomatic design principles is employed in this paper. The techno-commercial and socioeconomic criteria as considered for analyzing the feasibility of the candidate SHPPs are expressed qualitatively using trapezoidal fuzzy numbers. The performance of each SHPP is evaluated in terms of its total information content and the one with the least information content is selected to be the best venture for the required construction activity. The adopted methodology is found to have immense potential to the developers while selecting the most feasible project for construction.


2019 ◽  
Vol 11 (2) ◽  
pp. 129-137
Author(s):  
Nurul Dyah Pratiwi ◽  
Isdiyato Isdiyato

Microhydro power plant (MPP) is a small-scale power plant that uses water energy. The process of energy change occurs in a device called a synchronous generator. when the synchronous generator is given an arbitrary load, then the voltage will change. These results cause voltage and frequency instability. This research was conducted to analyze the voltage and frequency instability in MPP. The research method used in this research is descriptive quantitative approach in the village of Soko Kembang, Petungkriyono District, Pekalongan Regency, Central Java. This study provides an overview and explanation of the problems regarding the voltage and frequency instability of Micro Hydro Power Plants. The results of this study are the highest and lowest voltage / frequency instability values, namely 235 volts / 51 Hz and 160 volts / 44 Hz, due to the influence of changes in load current, which can affect the rotational speed of the generator changes, resulting in unstable voltage and frequency generated by the generator, the rotational speed of the generator changes, resulting in unstable voltage and frequency generated by the generator. The solution is  add water power to rotate the shaft of the turbine and generator to be tighter, so that it can reduce the value of the decrease in electric power by losses to the turbine and generator. Large electric power can increase voltage and frequency without having to adjust the load, and the need for improvement of the ELC system in order to get a more effective value of voltage and frequency stability.  


Sign in / Sign up

Export Citation Format

Share Document